$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
5 x Intake Flange B2x4 T5
6 x Rear Camber Shims Kit 6pcs
3 x Hood Emblem 9-3 SS/sc 03- All
8 x Clear Little Fender Blinkers Factory Saab
3 x ATF Saab 3309 (Automatic 02->)
2 x Griffin logo Shifter Top
2 x Front Camber Adjustment Bolts
4 x V6 Tank Float - SparePart
3 x Saab black Keychain
7 x PPC - Upgrade from stage 1 to stage 3
4 x Downpipe Hardware Kit
7 x MTF0063 Manual Gear oil
1 x v6 header flange
3 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
2 x Injectors 175hp Stg3 (Set4)
3 x BSR Optiflow Intake 4cyl
3 x Ignition Coil 9-3SS 2.0t and 2.0T
3 x Short Shifter HHR Cobalt F35 F40
3 x Aluminum Flywheel For NG900/9-3
5 x Shift Rod Bushings
2 x Transmission Nut F35 F25
1 x Rear Engine Mount 4cyl
1 x Slave Cyl
2 x Alu Hybrid Flywheel For NG900/9-3
3 x Flywheel Twin Disk 7.25in B2xx
1 x Replacement Flywheel Insert NG900/9-3
3 x Fog light Replacement Panels 99-01
3 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x 4340 Connecting Rods B204 B235
2 x AEM Wideband Gauge Kit
2 x 9-3 ng900 Hood Protection Strip
2 x v6 2.8t SAI Delete Kit
2 x 9-5 Wheel 10-Spoke 16in.
5 x SCNA Christmas Calendar
2 x Viggen Titanium KeyChain
1 x Shifter Top Ghost Logo
2 x Map/MAT sensor weld bung
1 x Rod Bearings only Pauter Rods
1 x Midpipe 2.0T 07-11 FWD (2wd)
3 x Forge Bypass Valve Cobalt/HHR TC
4 x Rear spring perches Adjustable NG900/9-3
4 x Oil Cap GM "HHR"
2 x Shifter Mount Kit Cobalt/ HHR
1 x c900 Performance Brake lines
2 x T5 3.0 Bar Map Sensor Adaptor
2 x 20th Viggen logo Shifter Top
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
2 x T7 Injector Spacer Kit
2 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
5 x Limit Strap Coilover Add On Kit
3 x Steering Coupler 9-3 99-02
2 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
4 x 9-3 / 900 Uprated Front ARB Bushings
1 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
2 x ARP Exhaust Manifold Stud kit Stainless
1 x Crush Sleeve F35 F25
4 x Drop in Sport Filter 9-5
3 x T7 3.5 Bar Fuel Pressure Regulator
1 x PPC 3 Volvo Diagnostic System
3 x Machined Control Arm Kit
4 x Steering Rod Bushings NG900/93
2 x 3 Point Hardware
2 x 9-5 Blend Flap Limit Lever 99-04
2 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x Exhaust manifold Stud Kit
2 x Basic Subframe Brace
3 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Cabin Vent Fan
1 x Genuine Saab 4cyl Oil Filters
1 x Headlight Bulb H7 Longer Life
2 x Direct Ignition T7 Black
1 x Rear Pedestal Spoiler 9-3 SS
2 x T7 Head Plug NGK
1 x Bulb Switch Light
1 x Cigarette Lighter
2 x Throttle Bend for T5 94-99
4 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Universal / Special Request
1 x Oil Cooler Adaptor B2X5
2 x BSR Optiflow Replacement Filter V6 2.8
2 x Con Rods V6 2.8L 155.8mm
1 x Head Bolt Washers
2 x 9-5 Textile Mats 98-07
2 x B207 Coolant Cap
2 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Floormats BSR 9-3SS/SC
4 x Replacement V6 Coolant Cap
2 x IAT Weld Bung T5/Bosch
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x Viggen Fog Air Intake
1 x Fuel Pressure Regulator 4.0 bar
1 x Injectors Siemens 60lb 630cc (set 4)
2 x Troll Head Plug
1 x Injectors Green Giant 42lb (set 4)
4 x Adaptor Harness Handsfree 01-
2 x 9-5 Open Air Prefilter
1 x Weld Bungs -Taper- Race Only
2 x 9-5 Shift Knobs Leather
1 x Injectors Siemens 80lb 875cc (set 4)
2 x Coreganizer
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
4 x K&N Filter Service Kit
2 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
3 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Mat Set Textile Jet Black 9-5 10-
3 x Brake Vac pump seals
1 x 9-3 99-02,03 CV Antenna Adaptor
3 x B207 Upper Radiator Coolant T
1 x 9-3/NG900 Shift Knobs Leather
3 x Floormats BSR 9-3 99-02 900 94-98
3 x Optical Cable Connector (Onstar Delete)
1 x Oil Cap 9-3SS V6 "Ghost"
1 x 9-5 Exhaust Flex Pipe Stainless
1 x Flex Pipe 900 94-98 9-3 99-02
1 x Crank Vent Kit #6 T7 4cyl
3 x Oil Cap 9-3SS "Ghost"
1 x Replacement Hardware Pack 6-Point
3 x Shifter Alignment Pins (Set 2)
1 x "Griffin" Valve stem caps
1 x Mat Set Textile Shark Grey 9-5 10-
1 x Mat Set Textile Parchment 9-5 10-
1 x Replacement Filter for Open air 9-3 T7
1 x Mat Set Black Rubber 9-5 10-
1 x Oil Cap 9-3SS V6 "Griffin"
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
2 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
2 x Viggen Clutch Kit 99-02
2 x Performance Brake Line Kit NG900 94-98 9-3 99-02
2 x Downpipe 2.8T FWD (2wd)
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
2 x Custom Brake Lines Brembo 315mm 9-3SS/SC
2 x Custom Brake Lines RR 300mm Kit
1 x 9000 High Performance Brake Line Kit '95-'98
3 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x 9-5 High Performance Brake Line Kit
1 x Ceramic Low Dust Brake Pads 9-3 SS
2 x BSR Optiflow Intake 4cyl w SAI
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x 9-3 SS Akebono Rear Pads
1 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
1 x Rear Rotors PAIR 292mm XWD (Code: BC)
1 x Rear Brake Pads 9-3 SS
1 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x Turbo to Downpipe Flange B207
1 x Rear Rotors PAIR 292mm Plain (Code: BB)
1 x Brembo Kit 315mm Hawk HPS Pads
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x Fog light 9-3 left 99-00
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Rivetnuts Pair (2pcs)
1 x Brembo Brake Kit 315mm 9-5 02-->
1 x Valve Cover Gasket Set 4cyl
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x BBS Center Cap for 9-2x RK small caps
1 x Headlight Connector Repair Kit 9-3SS 9-5
$46,961.47
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail