$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Rod Bearings only Pauter Rods
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x AEM Wideband Gauge Kit
3 x Oil Filter Re-locator
3 x Aero Clutch Kit 9-5
2 x Injectors Siemens 60lb 630cc (set 4)
3 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x PPC 3 Volvo Diagnostic System
4 x 9-5 Shift Knobs Leather
3 x IAT Weld Bung T5/Bosch
3 x Balance Shaft Tensioner Delete
5 x Clear Little Fender Blinkers Factory Saab
1 x Upgrade Valve Springs T5 Cars
2 x K&N Filter Service Kit
1 x Viggen Fog Air Intake
3 x Injectors Siemens 80lb 875cc (set 4)
3 x Header Flange 1/2in Blended Transition B2x4,B2x5
4 x Map/MAT sensor weld bung
2 x Sport Transmission Mount 9-5 (Manual) 1998-1999
2 x 9-3 ng900 radio wires
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
3 x Cigarette Lighter
1 x Turbo Conversion Pipe 900 9-3 T5
3 x Saab black Keychain
2 x ATF Saab 3309 (Automatic 02->)
2 x 9-5 Blend Flap Limit Lever 99-04
2 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Head Stud Kit all 4cyl
1 x v6 header flange
2 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x Rivetnuts Pair (2pcs)
3 x BSR Optiflow Intake 4cyl
1 x 4340 Connecting Rods B204 B235
1 x Fog light 9-3 left 99-00
2 x Floormats BSR 9-5
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
3 x PPC - Upgrade from stage 1 to stage 3
3 x Head Bolt Washers
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Universal / Special Request
2 x Moog Ball Joint
2 x Injectors Green Giant 42lb (set 4)
1 x T5 3.0 Bar Map Sensor Adaptor
1 x 9-5 286mm REAR Brembo Disk (1) See Descr.
3 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Weld Bungs -Taper- Race Only
3 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Headlight Bulb H7 Longer Life
2 x MTF0063 Manual Gear oil
1 x Downpipe Hardware Kit
1 x Midpipe 2.8T FWD (2wd)
3 x 9-5 Exhaust Flex Pipe Stainless
1 x Direct Ignition T7 Black
1 x Mass Airflow Meter T7
1 x Midpipe 2.0T 07-11 FWD (2wd)
2 x Brake Vac pump seals
1 x Fuel Line Clip
1 x Filter 9-5 Cabin Air
2 x Crush Sleeve F35 F25
2 x Limit Strap Coilover Add On Kit
2 x Air Filter 06 version (All 9-5)
3 x Crank Vent Kit #6 T7 4cyl
1 x Oil Pressure Switch
3 x Machined Control Arm Kit
1 x 9-5 Open Air Prefilter
1 x Cabin Vent Fan
2 x Griffin logo Shifter Top
2 x Genuine Saab 4cyl Oil Filters
2 x c900 Performance Brake lines
2 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x 9-5 High Performance Brake Line Kit
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
3 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x Brembo Kit 315mm Hawk HPS Pads
2 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
2 x Brembo Brake Kit 315mm 9-5 02-->
1 x Viggen Front Brake Disk Pair 308mm
1 x Rear Camber Shims Kit 6pcs
1 x BSR 9-5 3.0T V6 200Hp
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x BSR 9-5 260Hp 2006-
1 x Rear Pedestal Spoiler 9-3 SS
1 x 9-3 / 900 Uprated Front ARB Bushings
2 x Shifter Alignment Pins (Set 2)
1 x Oil Cooler Adaptor B2X5
2 x "Griffin" Valve stem caps
1 x Downpipe 2.8T XWD (4wd)
1 x ARP Exhaust Manifold Stud kit Stainless
2 x 9000 Shifter Bushing Repair Kit
1 x Open Air Intake 9000 93-98
1 x B207 Upper Radiator Coolant T
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
4 x Shift Rod Bushings
1 x Slave Cyl
1 x Viggen Titanium KeyChain
1 x Bulb Switch Light
1 x Alu Hybrid Flywheel For NG900/9-3
2 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-5 Aero Sill Protection
1 x 9-5 Wheel 10-Spoke 16in.
1 x 9-3/NG900 Shift Knobs Leather
1 x Brembo Brake Kit 315mm 9-3 SS
1 x Antenna Plug NG900/9-3 hatchback
2 x 9-5 Textile Mats 98-07
1 x 9-5 Rear Brake rotor See Description
1 x Basic Subframe Brace
1 x Downpipe 2.8T FWD (2wd)
1 x 9000 Intercooler ETS
1 x 9-3 ng900 Hood Protection Strip
1 x Flywheel Twin Disk 7.25in B2xx
2 x 9-5 Wheel 5-Spoke Twin 17in
1 x Exhaust manifold Stud Kit
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x 9000 High Performance Brake Line Kit '95-'98
1 x B207 Coolant Cap
1 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x T7 Head Plug NGK
1 x T7 Injector Spacer Kit
1 x Throttle Bend for T5 94-99
1 x Shifter Top Ghost Logo
1 x Replacement Hardware Pack 6-Point
1 x Shifter Mount Kit Cobalt/ HHR
1 x Rear spring perches Adjustable NG900/9-3
1 x Steering Coupler 9-3 99-02
1 x Short Shifter HHR Cobalt F35 F40
1 x ShortShift Kit 93ss
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x BBS Center Cap for 9-2x RK small caps
1 x Steering Rod Bushings NG900/93
1 x Shifter Mount Kit 93ss
$35,306.62
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail