$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x Intake Flange B2x4 T5
5 x Mass Airflow Meter T7
4 x Air Filter 06 version (All 9-5)
5 x BSR 9-5 260Hp 2006-
3 x Oil Filter Re-locator
5 x Downpipe Hardware Kit
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
3 x Crank Vent Kit #6 T7 4cyl
5 x Head Stud Kit all 4cyl
3 x Injectors Siemens 80lb 875cc (set 4)
2 x Cabin Vent Fan
2 x Rivetnuts Pair (2pcs)
3 x Oil Pressure Switch
2 x AEM Wideband Gauge Kit
3 x 9-5 Open Air Prefilter
1 x Universal / Special Request
3 x Crush Sleeve F35 F25
2 x Throttle Body T7
5 x Clear Little Fender Blinkers Factory Saab
3 x V6 Tank Float - SparePart
2 x 9-3 Rear Ashtray
2 x Floormats BSR 9-3 99-02 900 94-98
7 x PPC - Upgrade from stage 1 to stage 3
3 x T7 Injector Spacer Kit
2 x Exhaust Clamp Kit
2 x Cat back for Viggen 2.5in
2 x ARP Exhaust Manifold Stud kit Stainless
4 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x T7 3.5 Bar Fuel Pressure Regulator
3 x Adaptor Harness Handsfree 01-
2 x Turbo Conversion Pipe 900 9-3 T5
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x Coreganizer
2 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Mat Set Textile Parchment 9-5 10-
2 x Oil Cap 9-3SS V6 "Ghost"
3 x Storage Tray / Ashtray Kit 9-5 10-
2 x Mat Set Textile Jet Black 9-5 10-
1 x Oil Cap GM "HHR"
7 x BSR Optiflow Intake 4cyl
2 x Basic Subframe Brace
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
2 x Rear Pedestal Spoiler 9-3 SS
1 x ARP Ring Gear Bolts F25/F35
2 x JE Piston Rings 90.0mm 235/205
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Rear Engine Mount 4cyl
1 x Balance Shaft Tensioner Delete
2 x Aluminum Flywheel For NG900/9-3
1 x Shift Rod Bushings
2 x Shifter Top Ghost Logo
2 x T7 Head Plug NGK
1 x Rod Bearings only Pauter Rods
1 x Transmission Nut F35 F25
1 x Slave Cyl
2 x 4340 Connecting Rods B204 B235
1 x Replacement Flywheel Insert NG900/9-3
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Flywheel Twin Disk 7.25in B2xx
3 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Alu Hybrid Flywheel For NG900/9-3
1 x PPC 3 Volvo Diagnostic System
5 x Headbolts (New Style)
1 x Quaife Differential 9-5 and Viggen (F35)
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
2 x 9-5 Wheel 10-Spoke 16in.
1 x Antenna Plug NG900/9-3 hatchback
3 x Downpipe 2.8T FWD (2wd)
2 x BSR Optiflow Intake V6 2.8t
2 x BSR 9-5 3.0T V6 200Hp
3 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
2 x B207 Coolant Cap
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
2 x Con Rods V6 2.8L 155.8mm
2 x BSR Optiflow Replacement Filter V6 2.8
2 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x BSR Optiflow Intake 4cyl w SAI
1 x Midpipe 2.8T XWD (4wd)
2 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Coolant Bypass Valve 9-5
3 x v6oilcoolplate
1 x BSR 9-5 2010-2011 V6 300Hp
2 x Filter 9-5 Cabin Air
1 x BBS Center Cap for 9-2x RK small caps
3 x MTF0063 Manual Gear oil
1 x Shifter Mount Kit 93ss
1 x Rear Camber Shims Kit 6pcs
1 x 3 Point Hardware
2 x Viggen Titanium KeyChain
1 x T5 3.0 Bar Map Sensor Adaptor
1 x IAT Weld Bung T5/Bosch
1 x Head Bolt Washers
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x Injectors Green Giant 42lb (set 4)
3 x SCNA Christmas Calendar
1 x 9-5 Textile Mats 98-07
1 x Fog light Replacement Panels 99-01
1 x Front Camber Adjustment Bolts
2 x Drop in Sport Filter 9-5
1 x 9-5 Aero Sill Protection
1 x Genuine Saab 4cyl Oil Filters
4 x 9-5 Blend Flap Limit Lever 99-04
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Direct Ignition T7 Black
1 x 9-3 / 900 Uprated Suspension Bushings Inner
4 x c900 Performance Brake lines
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x Limit Strap Coilover Add On Kit
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x Replacement V6 Coolant Cap
1 x 9-3 / 900 Uprated Front ARB Bushings
2 x 9-3 ng900 radio wires
1 x 9000 Shifter Bushing Repair Kit
2 x Custom Brake Lines Brembo 315mm 9-3SS/SC
2 x Shifter Alignment Pins (Set 2)
1 x Replacement Hardware Pack 6-Point
1 x v6 2.8t SAI Delete Kit
1 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Midpipe 2.8T FWD (2wd)
2 x Turbo to Downpipe Flange B207
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x 9-3/NG900 Shift Knobs Leather
1 x Rear spring perches Adjustable NG900/9-3
1 x 9-5 High Performance Brake Line Kit
1 x Forge Bypass Valve Cobalt/HHR TC
1 x 9-5 Rear Brake rotor See Description
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Viggen Front Brake Disk Pair 308mm
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x Exhaust manifold Stud Kit
2 x Oil Cap 9-3SS V6 "Griffin"
2 x Throttle Bend for T5 94-99
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Turbo Bypass Valve
1 x Custom Brake Lines RR 300mm Kit
1 x Short Shifter HHR Cobalt F35 F40
1 x Mat Set Textile Shark Grey 9-5 10-
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x v6 header flange
1 x Fuel Line Clip
1 x Sparkplugs 9-3SS
1 x Steering Coupler 9-3 99-02
1 x Troll Head Plug
1 x Valve Cover Gasket Set 4cyl
$49,742.69
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail