$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Direct Ignition T5 RED
1 x Mass Airflow Meter T7
2 x Downpipe Hardware Kit
3 x Replacement Filter for Open air 9-3 T7
2 x Aluminum Flywheel For NG900/9-3
1 x Alu Hybrid Flywheel For NG900/9-3
2 x Shifter Top Ghost Logo
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Sport Transmission Mount 9-3/900 (Automatic)
1 x ATF Saab 3309 (Automatic 02->)
1 x K&N Filter Service Kit
1 x Cat back for Viggen 2.5in
3 x ARP Exhaust Manifold Stud kit Stainless
2 x Shifter Alignment Pins (Set 2)
2 x Exhaust manifold Stud Kit
1 x MTF0063 Manual Gear oil
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x SCNA Christmas Calendar
1 x Saab black Keychain
1 x Viggen Titanium KeyChain
1 x 9-3 ng900 Hood Protection Strip
1 x 9-3 /NG900 Grille
1 x Antenna Plug NG900/9-3 hatchback
2 x Clear Little Fender Blinkers Factory Saab
1 x Fog light Replacement Panels
1 x Fog light 9-3 Right 99-00
1 x c900 Performance Brake lines
1 x Fog light 9-3 left 99-00
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Short Shifter HHR Cobalt F35 F40
1 x T7 Injector Spacer Kit
1 x Limit Strap Coilover Add On Kit
1 x Steering Rod Bushings NG900/93
1 x Coreganizer
1 x Griffin logo Shifter Top
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x 9-3 ng900 radio wires
1 x Rear spring perches Adjustable NG900/9-3
1 x Rear Camber Shims Kit 6pcs
1 x 20th Viggen logo Shifter Top
1 x 9-3/NG900 Shift Knobs Leather
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x Steering Coupler 9-3 99-02
2 x Throttle Body T7
1 x Turbo Bypass Valve
1 x Rear Engine Mount 4cyl
1 x Replacement Flywheel Insert NG900/9-3
1 x Flywheel Twin Disk 7.25in B2xx
2 x Viggen Clutch Kit 99-02
1 x Exhaust Clamp Kit
1 x BSR 9-5 2010-2011 V6 300Hp
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x BSR 9-5 3.0T V6 200Hp
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x PPC - Upgrade from stage 1 to stage 3
$12,279.75
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail