$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x SCNA Christmas Calendar
1 x Injectors Siemens 80lb 875cc (set 4)
2 x 9-3 / 900 Uprated Front ARB Bushings
4 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
3 x Rivetnuts Pair (2pcs)
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Moog Ball Joint
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Shifter Mount Kit Cobalt/ HHR
1 x Short Shifter HHR Cobalt F35 F40
1 x Forge Bypass Valve Cobalt/HHR TC
2 x Oil Cap GM "HHR"
1 x Flywheel Twin Disk 7.25in B2xx
1 x Balance Shaft Tensioner Delete
2 x T7 Head Plug NGK
1 x JE Piston Rings 90.0mm 235/205
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Rod Bearings only Pauter Rods
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Slave Cyl
1 x Replacement Flywheel Insert NG900/9-3
1 x Head Stud Kit all 4cyl
2 x Transmission Nut F35 F25
3 x Shift Rod Bushings
1 x 4340 Connecting Rods B204 B235
1 x Aluminum Flywheel For NG900/9-3
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Rear Engine Mount 4cyl
1 x Shifter Top Ghost Logo
1 x Headbolts (New Style)
1 x ARP Ring Gear Bolts F25/F35
2 x Oil Filter Re-locator
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
2 x Troll Head Plug
1 x Replacement Filter for Open air 9-3 T7
1 x Fog light 9-3 left 99-00
1 x Floormats BSR 9-3 99-02 900 94-98
1 x 9-3/NG900 Shift Knobs Leather
1 x Adaptor Harness Handsfree 01-
2 x Throttle Bend for T5 94-99
2 x Viggen Fog Air Intake
1 x T7 Injector Spacer Kit
1 x Griffin logo Shifter Top
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x Coreganizer
2 x Oil Cooler Adaptor B2X5
1 x T7 3.5 Bar Fuel Pressure Regulator
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x 9-3 ng900 radio wires
2 x Turbo Conversion Pipe 900 9-3 T5
3 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x 9-3 Rear Ashtray
1 x c900 Performance Brake lines
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Mat Set Black Rubber 9-5 10-
1 x Mat Set Textile Shark Grey 9-5 10-
2 x Saab black Keychain
1 x Mat Set Textile Parchment 9-5 10-
1 x 9-5 Aero Sill Protection
2 x Oil Cap 9-3SS V6 "Ghost"
1 x Mat Set Textile Jet Black 9-5 10-
2 x Oil Cap 9-3SS V6 "Griffin"
2 x Weld Bungs -Taper- Race Only
1 x ATF Saab 3309 (Automatic 02->)
1 x Replacement Hardware Pack 6-Point
2 x Shifter Alignment Pins (Set 2)
1 x v6 header flange
1 x v6oilcoolplate
1 x Intake Flange B2x4 T5
1 x Rear spring perches Adjustable NG900/9-3
1 x K&N Filter Service Kit
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x Rear Camber Shims Kit 6pcs
2 x Map/MAT sensor weld bung
1 x v6 2.8t SAI Delete Kit
1 x Turbo to Downpipe Flange B207
1 x Universal / Special Request
1 x Direct Ignition T7 Black
1 x Limit Strap Coilover Add On Kit
1 x Shifter Mount Kit 93ss
2 x Oil Cap 9-3SS "Ghost"
1 x PPC - Upgrade from stage 1 to stage 3
2 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Midpipe 2.0T 07-11 FWD (2wd)
4 x IAT Weld Bung T5/Bosch
1 x Open Air Intake 9000 93-98
1 x Midpipe 2.8T XWD (4wd)
1 x ShortShift Kit 93ss
1 x 20th Viggen logo Shifter Top
1 x Brake Vac pump seals
1 x Fuel Pressure Regulator 4.0 bar
1 x Steering Rod Bushings NG900/93
2 x Head Bolt Washers
1 x 9-5 Exhaust Flex Pipe Stainless
1 x Front Camber Adjustment Bolts
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Exhaust manifold Stud Kit
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Steering Coupler 9-3 99-02
$14,532.35
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail