$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x MTF0063 Manual Gear oil
1 x ATF Saab 3309 (Automatic 02->)
1 x K&N Filter Service Kit
1 x SCNA Christmas Calendar
1 x Shifter Alignment Pins (Set 2)
1 x Viggen Titanium KeyChain
1 x Saab black Keychain
1 x Rivetnuts Pair (2pcs)
1 x AEM Wideband Gauge Kit
1 x Intake Flange B2x4 T5
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Universal / Special Request
1 x Moog Ball Joint
1 x PPC 3 Volvo Diagnostic System
1 x Injectors Green Giant 42lb (set 4)
1 x Injectors Siemens 60lb 630cc (set 4)
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Fuel Pressure Regulator 4.0 bar
1 x Head Bolt Washers
1 x IAT Weld Bung T5/Bosch
1 x PPC - Upgrade from stage 1 to stage 3
1 x Injectors Siemens 80lb 875cc (set 4)
1 x Map/MAT sensor weld bung
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Fuel Line Clip
1 x Remote Button NG900
1 x Downpipe Hardware Kit
1 x Genuine Saab 4cyl Oil Filters
1 x Replacement Hardware Pack 6-Point
2 x Exhaust Clamp Kit
2 x Flex Pipe 900 94-98 9-3 99-02
1 x Rear Engine Mount 4cyl
1 x Crank Vent Kit #6 T7 4cyl
1 x Mass Airflow Meter T7
1 x Replacement Filter for Open air 9-3 T7
1 x Direct Ignition T7 Black
1 x Crush Sleeve F35 F25
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Direct Ignition T5 RED
1 x Exhaust manifold Stud Kit
1 x ARP Exhaust Manifold Stud kit Stainless
1 x Cat back for Viggen 2.5in
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x 20th Viggen logo Shifter Top
1 x Adaptor Harness Handsfree 01-
1 x Griffin logo Shifter Top
1 x 9-3 ng900 radio wires
1 x 9-3 Rear Ashtray
1 x Floormats BSR 9-3 99-02 900 94-98
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x 9-3/NG900 Shift Knobs Leather
1 x Coreganizer
1 x Headbolts (New Style)
1 x Oil Filter Re-locator
1 x 4340 Connecting Rods B204 B235
1 x Rod Bearings only Pauter Rods
1 x T7 Head Plug NGK
1 x Fog light 9-3 Right 99-00
1 x Antenna Plug NG900/9-3 hatchback
1 x 9-3 ng900 Hood Protection Strip
1 x Fog light Replacement Panels
1 x Fog light 9-3 left 99-00
1 x 9-3 /NG900 Grille
1 x Clear Little Fender Blinkers Factory Saab
1 x Aluminum Flywheel For NG900/9-3
1 x 9-3 / 900 Uprated Front ARB Bushings
$9,394.42
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail