$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x PPC 3 Volvo Diagnostic System
6 x Forge Bypass Valve Cobalt/HHR TC
5 x Shifter Mount Kit Cobalt/ HHR
3 x Viggen Titanium KeyChain
4 x Moog Ball Joint
4 x Map/MAT sensor weld bung
4 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
3 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
2 x Fuel Pressure Regulator 4.0 bar
2 x K&N Filter Service Kit
5 x MTF0063 Manual Gear oil
3 x PPC - Upgrade from stage 1 to stage 3
6 x Injectors Siemens 80lb 875cc (set 4)
3 x Rear spring perches Adjustable NG900/9-3
2 x Basic Subframe Brace
6 x Rear Camber Shims Kit 6pcs
2 x Steering Rod Bushings NG900/93
4 x 9-3 / 900 Uprated Front ARB Bushings
4 x Steering Coupler 9-3 99-02
4 x 9-3 / 900 Uprated Suspension Bushings Inner
3 x SCNA Christmas Calendar
3 x Replacement V6 Coolant Cap
4 x Front Camber Adjustment Bolts
4 x Midpipe 2.0T 07-11 FWD (2wd)
3 x V6 Tank Float - SparePart
3 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
6 x ARP Exhaust Manifold Stud kit Stainless
1 x Clear Little Fender Blinkers Factory Saab
3 x 9-5 Wheel 5-Spoke Twin 17in
4 x Griffin logo Shifter Top
3 x Drop in Sport Filter 9-5
2 x 9-3 Rear Ashtray
3 x T7 Injector Spacer Kit
3 x Adaptor Harness Handsfree 01-
3 x T7 3.5 Bar Fuel Pressure Regulator
4 x Coreganizer
4 x Floormats BSR 9-3 99-02 900 94-98
2 x 9-3/NG900 Shift Knobs Leather
4 x Universal / Special Request
4 x Head Bolt Washers
2 x 9000 High Performance Brake Line Kit '95-'98
2 x Rivetnuts Pair (2pcs)
2 x 9000 Shifter Bushing Repair Kit
7 x Shift Rod Bushings
2 x Injectors Green Giant 42lb (set 4)
3 x Intake Flange B2x4 T5
4 x Weld Bungs -Taper- Race Only
3 x IAT Weld Bung T5/Bosch
3 x Crush Sleeve F35 F25
4 x Header Flange 1/2in Blended Transition B2x4,B2x5
3 x Shifter Alignment Pins (Set 2)
1 x 9000 Intercooler ETS
2 x T5 3.0 Bar Map Sensor Adaptor
1 x Oil Cap 9-3SS "Ghost"
4 x 9-5 Aero Sill Protection
2 x B207 Upper Radiator Coolant T
2 x c900 Performance Brake lines
1 x 9-5 Shift Knobs Leather
1 x 9-5 Textile Mats 98-07
1 x Aluminum Flywheel For NG900/9-3
2 x Alu Hybrid Flywheel For NG900/9-3
2 x Optical Cable Connector (Onstar Delete)
2 x Replacement Flywheel Insert NG900/9-3
2 x BSR 9-5 2010-2011 V6 300Hp
1 x 3 Point Hardware
1 x Quaife Differential 9-5 and Viggen (F35)
3 x Slave Cyl
2 x Head Stud Kit all 4cyl
1 x Hood Emblem 9-3 SS/sc 03- All
3 x Brake Vac pump seals
3 x Transmission Nut F35 F25
1 x ARP Ring Gear Bolts F25/F35
1 x Sparkplugs 9-3SS
4 x Shifter Top Ghost Logo
2 x Headlight Connector Repair Kit 9-3SS 9-5
2 x Ignition Coil 9-3SS 2.8t and 2.8T
4 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Flywheel Twin Disk 7.25in B2xx
2 x Rear Engine Mount 4cyl
1 x Spec Light Flywheel For 9-5 4cyl 99-09
3 x Crank Vent Kit #6 T7 4cyl
1 x T7 Head Plug NGK
3 x Direct Ignition T7 Black
2 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Replacement Filter for Open air 9-3 T7
1 x Remote Button NG900
3 x Sport Transmission Mount 9-5 (Manual) 1998-1999
2 x Downpipe Hardware Kit
1 x Fuel Line Clip
2 x 4340 Connecting Rods B204 B235
1 x Replacement Hardware Pack 6-Point
1 x Genuine Saab 4cyl Oil Filters
1 x Mass Airflow Meter T7
2 x Balance Shaft Tensioner Delete
1 x JE Piston Rings 90.0mm 235/205
1 x Aero Clutch Kit 9-5
3 x Saab black Keychain
2 x BSR Optiflow Intake 4cyl
1 x BBS Center Cap for 9-2x RK small caps
1 x BSR 9-5 260Hp 2006-
2 x Oil Cap 9-3SS V6 "Ghost"
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x Downpipe 2.8T XWD (4wd)
2 x Short Shifter HHR Cobalt F35 F40
1 x Oil Cooler Adaptor B2X5
1 x Oil Cap 9-3SS V6 "Griffin"
2 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
2 x Brembo Brake Kit 315mm 9-3 SS
1 x Oil Cap GM "HHR"
5 x ShortShift Kit 93ss
1 x Turbo to Downpipe Flange B207
1 x Troll Head Plug
2 x Downpipe 2.8T FWD (2wd)
1 x Brembo Brake Kit 315mm 9-5 02-->
1 x Throttle Bend for T5 94-99
1 x Front Camber Adjustment Bolts
3 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x Shifter Mount Kit 93ss
2 x Midpipe 2.8T FWD (2wd)
1 x Limit Strap Coilover Add On Kit
1 x Rod Bearings only Pauter Rods
2 x Torque Mount Insert V6 Manual (XWD and FWD)
2 x Midpipe 2.8T XWD (4wd)
2 x Cat back for Viggen 2.5in
1 x Machined Control Arm Kit
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x 9-5 Blend Flap Limit Lever 99-04
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x Rear Rotors PAIR 292mm XWD (Code: BC)
1 x Goodridge Brake Lines 9-3 SS / SC 03-
2 x 9-3 ng900 radio wires
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
1 x Mat Set Black Rubber 9-5 10-
1 x AEM Wideband Gauge Kit
1 x Mat Set Textile Jet Black 9-5 10-
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
2 x Exhaust manifold Stud Kit
2 x 9-3SS Wheel 5-Spoke Low Split 17 in.
2 x 20th Viggen logo Shifter Top
1 x Valve Cover Gasket Set 4cyl
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x 9-5 High Performance Brake Line Kit
1 x 9-5 Rear Brake rotor See Description
1 x Flex Pipe 900 94-98 9-3 99-02
1 x Rear Brake Pads 9-3 SS
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x Ceramic Low Dust Brake Pads 9-3 SS
$47,727.54
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail