$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Basic Subframe Brace
1 x Steering Coupler 9-3 99-02
1 x Machined Control Arm Kit
1 x Rear spring perches Adjustable NG900/9-3
1 x Limit Strap Coilover Add On Kit
2 x 9-3 / 900 Uprated Front ARB Bushings
1 x Steering Rod Bushings NG900/93
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Injectors Green Giant 42lb (set 4)
1 x Injectors Siemens 60lb 630cc (set 4)
1 x AEM Wideband Gauge Kit
1 x Head Bolt Washers
1 x Injectors Siemens 80lb 875cc (set 4)
1 x IAT Weld Bung T5/Bosch
1 x PPC - Upgrade from stage 1 to stage 3
1 x Intake Flange B2x4 T5
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Rivetnuts Pair (2pcs)
1 x Map/MAT sensor weld bung
1 x Universal / Special Request
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Fuel Pressure Regulator 4.0 bar
1 x Moog Ball Joint
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x PPC 3 Volvo Diagnostic System
1 x Exhaust Clamp Kit
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x SCNA Christmas Calendar
1 x Viggen Titanium KeyChain
1 x Oil Filter Re-locator
1 x T7 Head Plug NGK
1 x Shift Rod Bushings
1 x 20th Viggen logo Shifter Top
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Flywheel Twin Disk 7.25in B2xx
1 x Shifter Top Ghost Logo
1 x 9-3 ng900 radio wires
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Slave Cyl
1 x Aluminum Flywheel For NG900/9-3
1 x Transmission Nut F35 F25
1 x Replacement Flywheel Insert NG900/9-3
1 x Coreganizer
1 x Rear Engine Mount 4cyl
1 x 9-3 Rear Ashtray
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Floormats BSR 9-3 99-02 900 94-98
1 x Adaptor Harness Handsfree 01-
1 x Griffin logo Shifter Top
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x ARP Ring Gear Bolts F25/F35
1 x 9-3/NG900 Shift Knobs Leather
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Turbo Conversion Pipe 900 9-3 T5
1 x Throttle Bend for T5 94-99
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Oil Cooler Adaptor B2X5
1 x Viggen Fog Air Intake
1 x Mass Airflow Meter T7
1 x 9-5 Aero Sill Protection
1 x BSR 9-5 2010-2011 V6 300Hp
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Mat Set Textile Parchment 9-5 10-
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Mat Set Black Rubber 9-5 10-
1 x Mat Set Textile Jet Black 9-5 10-
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Downpipe Hardware Kit
1 x Upgrade Valve Springs T5 Cars
$10,129.56
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail