$164.69

Performance Brake Line Kit NG900 94-98 9-3 99-02
[40005]

Performance Brake Line Kit NG900 94-98 9-3 99-02

Add to Cart

Date Added: Friday 25 July, 2008

by M. Luke Wisniewski

Here's the rear line instruction. This is more of a pain than the front mainly because space is tight. I did this on a M95 900.

Tools Needed:
Jack and Jack Stands
Drain pan
17mm Open-End Wrench
10,13mm Flare (Brake Line) Wrench
13,17mm Socket
Channel Locks
Torque Wrench

Jack up rear of vehicle and secure with jack stands.

Remove center cap and wheel/tire assembly (flat blade screwdriver and 17mm socket

Place drain pan under control arm, the brake fluid will leak on to the control arm and run down to its lowest point.

Disconnect the solid brake line from the caliper to the flexible line at the bracket on the control arm (10mm flare wrench).

Remove bracket that holds flexible brake line to control arm (13mm socket).

Remove clip securing flexible brake line to bracket (channel locks).

Remove solid brake line from brake limit valve (a cylinder just upstream from the flexible brake line)(13mm flare wrench).

Remove brake limit valve (17mm wrench).

Remove clip holding flexible brake line to mounting point (channel locks).

Install SS line into mounting bracket, secure with clip.

Reinstall brake limit valve (17mm wrench).

Reinstall solid brake line to brake limit valve (13mm flare wrench).

Install other end of SS line into bracket (19,24mm wrench).

Install bracket onto control arm (13mm socket).

Install solid brake line from caliper to SS line (10mm flare wrench).

Bleed brakes

Reinstall wheel/tire assembly (17mm socket, torque wrench).

Remove jack stands and lower vehicle.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x Shifter Alignment Pins (Set 2)
1 x Cobalt SS/TC 315mm Sport Rotors Pair
3 x MTF0063 Manual Gear oil
2 x K&N Filter Service Kit
1 x Exhaust Clamp Kit
1 x ATF Saab 3309 (Automatic 02->)
2 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Rivetnuts Pair (2pcs)
1 x Injectors Green Giant 42lb (set 4)
1 x T7 Injector Spacer Kit
2 x Exhaust manifold Stud Kit
2 x Intake Flange B2x4 T5
1 x Injectors Siemens 80lb 875cc (set 4)
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x 9-5 Aero Sill Protection
1 x 9-5 Intercooler ETS
1 x Injectors Siemens 60lb 630cc (set 4)
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Drop in Sport Filter 9-5
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x ARP Exhaust Manifold Stud kit Stainless
1 x Clear Little Fender Blinkers Factory Saab
1 x IAT Weld Bung T5/Bosch
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x AEM Wideband Gauge Kit
1 x Fuel Regulator 3-5 Bar Adjustable T7 (SPECIAL APP)
1 x Fuel Pressure Regulator 4.0 bar
1 x Fog light Replacement Panels 99-01
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Moog Ball Joint
1 x Map/MAT sensor weld bung
1 x Hood Emblem 9-5 All
1 x Head Bolt Washers
1 x PPC - Upgrade from stage 1 to stage 3
2 x Crank Vent Kit #6 T7 4cyl
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Griffin logo Shifter Top
1 x Short Shifter HHR Cobalt F35 F40
1 x Shifter Top Ghost Logo
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Viggen Clutch Kit 99-02
1 x Aluminum Flywheel For NG900/9-3
1 x Rod Bearings only Pauter Rods
1 x Rear Engine Mount 4cyl
1 x Remote Button NG900
1 x Shifter Mount Kit Cobalt/ HHR
1 x Balance Shaft Tensioner Delete
1 x Brake Vac pump seals
1 x Flywheel Twin Disk 7.25in B2xx
1 x Mass Airflow Meter T7
$7,839.82
Manufacturer Info
Goodridge
Other products
Share Product
Share via E-Mail