$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
4 x Coreganizer
5 x Adaptor Harness Handsfree 01-
5 x Griffin logo Shifter Top
5 x Steering Coupler 9-3 99-02
3 x Machined Control Arm Kit
3 x 9-3 Rear Ashtray
2 x Fog light Replacement Panels
5 x 20th Viggen logo Shifter Top
1 x Aluminum Flywheel For NG900/9-3
4 x Shifter Top Ghost Logo
3 x ARP Ring Gear Bolts F25/F35
1 x Rear Engine Mount 4cyl
3 x Con Rods V6 2.8L 155.8mm
3 x 9-3 ng900 radio wires
2 x 9000 Shifter Bushing Repair Kit
2 x T7 Head Plug NGK
2 x Troll Head Plug
2 x Exhaust manifold Stud Kit
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
4 x B207 Coolant Cap
2 x Saab black Keychain
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
3 x Flex Pipe 900 94-98 9-3 99-02
2 x ARP Exhaust Manifold Stud kit Stainless
2 x Cat back for Viggen 2.5in
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x 9-5 Wheel 10-Spoke 16in.
2 x Direct Ignition T5 RED
1 x Genuine Saab 4cyl Oil Filters
2 x Oil Cap GM "HHR"
2 x Short Shifter HHR Cobalt F35 F40
3 x 9-3 / 900 Uprated Suspension Bushings Inner
3 x Rear spring perches Adjustable NG900/9-3
2 x T7 Injector Spacer Kit
2 x PPC 3 Volvo Diagnostic System
1 x Throttle Bend for T5 94-99
2 x T7 3.5 Bar Fuel Pressure Regulator
2 x Oil Cooler Adaptor B2X5
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x Turbo Conversion Pipe 900 9-3 T5
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
2 x PPC - Upgrade from stage 1 to stage 3
1 x Injectors Siemens 80lb 875cc (set 4)
1 x T5 3.0 Bar Map Sensor Adaptor
3 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x Universal / Special Request
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
2 x Injectors Green Giant 42lb (set 4)
1 x Rivetnuts Pair (2pcs)
1 x Floormats BSR 9-3 99-02 900 94-98
3 x BSR Optiflow Intake V6 2.8t
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Metal Steering Wheel Buttons
4 x Front Camber Adjustment Bolts
1 x 9-5 Aero Sill Protection
2 x ShortShift Kit 93ss
1 x 9-5 Shift Knobs Leather
1 x Torque Mount Insert V6 Manual (XWD and FWD)
3 x 9-3/NG900 Shift Knobs Leather
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Air Filter 06 version (All 9-5)
1 x 9-5 Rear Brake rotor See Description
2 x Shifter Mount Kit 93ss
1 x 9-5 Wheel 5-Spoke Twin 17in
4 x Headlight Connector Repair Kit 9-3SS 9-5
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
2 x Rear Pedestal Spoiler 9-3 SS
1 x Optical Cable Connector (Onstar Delete)
2 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x Sparkplugs 9-3SS
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
2 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
2 x B207 Upper Radiator Coolant T
1 x Hood Emblem 9-3 SS/sc 03- All
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x V6 Tank Float - SparePart
1 x 3 Point Hardware
2 x Ignition Coil 9-3SS 2.0t and 2.0T
2 x Replacement V6 Coolant Cap
2 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Downpipe 2.8T XWD (4wd)
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x Injectors 175hp Stg3 (Set4)
1 x BSR Optiflow Replacement Filter V6 2.8
2 x Midpipe 2.8T XWD (4wd)
3 x Basic Subframe Brace
1 x Downpipe 2.8T FWD (2wd)
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
2 x 9-3 99-02,03 CV Antenna Adaptor
1 x Alu Hybrid Flywheel For NG900/9-3
3 x Replacement Flywheel Insert NG900/9-3
2 x Intake Flange B2x4 T5
1 x Antenna Plug NG900/9-3 hatchback
2 x Fog light 9-3 Right 99-00
1 x Replacement Hardware Pack 6-Point
2 x Fog light 9-3 left 99-00
2 x Shift Rod Bushings
3 x Viggen Clutch Kit 99-02
1 x Brembo Brake Kit 315mm 9-5 02-->
1 x Transmission Nut F35 F25
1 x Crush Sleeve F35 F25
2 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
2 x BBS Center Cap for 9-2x RK small caps
1 x IAT Weld Bung T5/Bosch
1 x 9-5 Textile Mats 98-07
3 x Limit Strap Coilover Add On Kit
1 x Brake Vac pump seals
2 x 9-3 / 900 Uprated Front ARB Bushings
2 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Oil Filter Re-locator
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x v6 header flange
1 x Open Air Intake 9000 93-98
1 x Hood Emblem 9-5 All
2 x Floormats BSR 9-5
1 x Mass Airflow Meter T7
1 x Coolant Bypass Valve 9-5
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x 9-5 High Performance Brake Line Kit
2 x Oil Pressure Switch
2 x Cigarette Lighter
1 x Fuel Line Clip
1 x Fog light Replacement Panels 99-01
1 x Clear Little Fender Blinkers Factory Saab
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x c900 Performance Brake lines
2 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x 9-5 Exhaust Flex Pipe Stainless
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x Brembo Brake Kit 315mm 9-3 SS
1 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
2 x Oil Cap 9-3SS V6 "Ghost"
2 x BSR Optiflow Intake 4cyl
1 x Direct Ignition T7 Black
1 x Rear Camber Shims Kit 6pcs
1 x Shifter Mount Kit Cobalt/ HHR
2 x 4 Cyl 2.0 Coolant Tank
1 x 9-3 ng900 Hood Protection Strip
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x SCNA Christmas Calendar
1 x Slave Cyl
1 x Flywheel Twin Disk 7.25in B2xx
1 x Filter 9-5 Cabin Air
$41,959.37
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail