$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x Injectors Siemens 60lb 630cc (set 4)
4 x Ignition Coil 9-3SS 2.0t and 2.0T
6 x ARP Exhaust Manifold Stud kit Stainless
8 x 9000 Intercooler ETS
4 x 3 Point Hardware
1 x Oil Cooler Adaptor B2X5
2 x Shifter Mount Kit Cobalt/ HHR
2 x Oil Cap 9-3SS "Ghost"
2 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
3 x 9-5 Shift Knobs Leather
2 x Floormats BSR 9-5
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
3 x Aero Clutch Kit 9-5
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Shifter Top Ghost Logo
2 x Replacement Filter for Open air 9-3 T7
2 x Griffin logo Shifter Top
2 x T7 Head Plug NGK
1 x Oil Filter Re-locator
4 x Fuel Pressure Regulator 4.0 bar
2 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x BSR Optiflow Intake V6 2.8t
1 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x T7 3.5 Bar Fuel Pressure Regulator
2 x Rear Rotors PAIR 292mm Plain (Code: BB)
3 x 9-3 SS Akebono Rear Pads
4 x Drop in Sport Filter 9-5
1 x PPC 3 Volvo Diagnostic System
1 x Header Flange Stainless Blended Transition B2x4,B2x5
4 x Injectors Green Giant 42lb (set 4)
3 x Injectors Siemens 80lb 875cc (set 4)
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x PPC - Upgrade from stage 1 to stage 3
4 x 9000 High Performance Brake Line Kit '95-'98
1 x Basic Subframe Brace
2 x Moog Ball Joint
2 x Map/MAT sensor weld bung
2 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
2 x BBS Center Cap for 9-2x RK small caps
1 x Con Rods V6 2.8L 155.8mm
1 x Troll Head Plug
2 x Oil Cap GM "HHR"
1 x B207 Coolant Cap
1 x Limit Strap Coilover Add On Kit
2 x BSR 9-5 2010-2011 V6 300Hp
2 x Oil Pressure Switch
3 x Throttle Body T7
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
2 x Shifter Alignment Pins (Set 2)
2 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
2 x Rear Rotors PAIR 278mm Plain (Code: BA)
3 x Viggen Clutch Kit 99-02
1 x Rear Brake Pads 9-3 SS
3 x Valve Cover Gasket Set 4cyl
3 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x Genuine Saab 4cyl Oil Filters
2 x Remote Button NG900
1 x Rear Rotors PAIR 292mm XWD (Code: BC)
2 x Front Brake Pads 9-5 9-3 900 LOW DUST
2 x Viggen Front Brake Disk Pair 308mm
3 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x Flex Pipe 900 94-98 9-3 99-02
2 x Headbolts (New Style)
1 x Downpipe Hardware Kit
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
2 x 9-5 Blend Flap Limit Lever 99-04
1 x Turbo to Downpipe Flange B207
1 x Midpipe 2.8T FWD (2wd)
1 x Midpipe 2.8T XWD (4wd)
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x BSR 9-5 3.0T V6 200Hp
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Brembo Kit 315mm Hawk HPS Pads
1 x Fog light 9-3 Right 99-00
2 x Rivetnuts Pair (2pcs)
1 x 9-3 ng900 Hood Protection Strip
1 x Fog light 9-3 left 99-00
2 x Crank Vent Kit #6 T7 4cyl
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
2 x Front Rotors PAIR 285mm Plain (Code: AA)
2 x Fog light Replacement Panels 99-01
3 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
5 x Open Air Intake 9000 93-98
1 x Brembo Brake Kit 315mm 9-5 02-->
1 x Coolant Bypass Valve 9-5
1 x Hood Emblem 9-5 All
1 x Turbo Bypass Valve
1 x Head Stud Kit all 4cyl
1 x Filter 9-5 Cabin Air
1 x Cat back for Viggen 2.5in
2 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x Fog light Replacement Panels
1 x Slave Cyl
1 x Cabin Vent Fan
1 x Metal Steering Wheel Buttons
1 x Rear Pedestal Spoiler 9-3 SS
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
$42,657.99
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail