$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
4 x ATF Saab 3309 (Automatic 02->)
4 x Universal / Special Request
5 x T5 3.0 Bar Map Sensor Adaptor
2 x Injectors Siemens 60lb 630cc (set 4)
2 x AEM Wideband Gauge Kit
4 x Clear Little Fender Blinkers Factory Saab
1 x c900 Performance Brake lines
1 x Saab black Keychain
3 x 9-5 Aero Sill Protection
3 x K&N Filter Service Kit
2 x MTF0063 Manual Gear oil
1 x Fog light Replacement Panels
1 x Fog light 9-3 Right 99-00
1 x Antenna Plug NG900/9-3 hatchback
2 x 20th Viggen logo Shifter Top
1 x ARP Ring Gear Bolts F25/F35
1 x Floormats BSR 9-3 99-02 900 94-98
1 x 9-3 ng900 radio wires
1 x 9-3 /NG900 Grille
1 x Fog light 9-3 left 99-00
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Viggen Fog Air Intake
1 x Rear Engine Mount 4cyl
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x T7 Injector Spacer Kit
2 x Shift Rod Bushings
2 x Oil Cooler Adaptor B2X5
1 x Throttle Bend for T5 94-99
1 x 9-3/NG900 Shift Knobs Leather
2 x Griffin logo Shifter Top
1 x Transmission Nut F35 F25
3 x Coreganizer
1 x Shifter Top Ghost Logo
1 x Alu Hybrid Flywheel For NG900/9-3
2 x Adaptor Harness Handsfree 01-
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x 9-3 Rear Ashtray
2 x 9-3 ng900 Hood Protection Strip
1 x Sport Transmission Mount 9-3/900 (Automatic)
2 x PPC 3 Volvo Diagnostic System
1 x Aluminum Flywheel For NG900/9-3
1 x Flywheel Twin Disk 7.25in B2xx
2 x Machined Control Arm Kit
1 x Exhaust manifold Stud Kit
2 x Steering Coupler 9-3 99-02
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
3 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x Rear Camber Shims Kit 6pcs
2 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
2 x BSR 9-5 260Hp 2006-
2 x ARP Exhaust Manifold Stud kit Stainless
2 x Basic Subframe Brace
2 x Flex Pipe 900 94-98 9-3 99-02
1 x 9-5 Exhaust Flex Pipe Stainless
1 x Forge Bypass Valve Cobalt/HHR TC
1 x Hood Emblem 9-5 All
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x Coolant Bypass Valve 9-5
2 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
2 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x 9-5 Blend Flap Limit Lever 99-04
2 x Drop in Sport Filter 9-5
1 x Crush Sleeve F35 F25
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x Injectors 175hp Stg3 (Set4)
2 x B207 Upper Radiator Coolant T
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
1 x BSR Optiflow Intake V6 2.8t
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x Hood Emblem 9-3 SS/sc 03- All
1 x Midpipe 2.8T FWD (2wd)
1 x Shifter Mount Kit 93ss
2 x V6 Tank Float - SparePart
1 x Downpipe 2.8T XWD (4wd)
2 x Rear Pedestal Spoiler 9-3 SS
1 x 3 Point Hardware
1 x Replacement V6 Coolant Cap
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x Optical Cable Connector (Onstar Delete)
1 x IAT Weld Bung T5/Bosch
1 x B207 Coolant Cap
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Rivetnuts Pair (2pcs)
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
2 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Ignition Coil 9-3SS 2.0t and 2.0T
2 x Injectors Siemens 80lb 875cc (set 4)
2 x BSR Optiflow Intake 4cyl
3 x Injectors Green Giant 42lb (set 4)
2 x Head Bolt Washers
2 x PPC - Upgrade from stage 1 to stage 3
2 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Intake Flange B2x4 T5
1 x Floormats BSR 9-3SS/SC
2 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Front Camber Adjustment Bolts
2 x 4 Cyl 2.0 Coolant Tank
1 x Metal Steering Wheel Buttons
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Downpipe 2.8T FWD (2wd)
2 x Fuel Pressure Regulator 4.0 bar
1 x Con Rods V6 2.8L 155.8mm
3 x ShortShift Kit 93ss
1 x Brake Vac pump seals
3 x Weld Bungs -Taper- Race Only
3 x Sparkplugs 9-3SS
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x 9-5 Wheel 10-Spoke 16in.
1 x 9-5 Rear Brake rotor See Description
1 x Aero Clutch Kit 9-5
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Headbolts (New Style)
1 x Steering Rod Bushings NG900/93
1 x Slave Cyl
1 x Cat back for Viggen 2.5in
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x Front Camber Adjustment Bolts
1 x Brembo Brake Kit 315mm 9-3 SS
2 x Oil Cap 9-3SS "Ghost"
2 x Limit Strap Coilover Add On Kit
1 x Troll Head Plug
1 x Turbo to Downpipe Flange B207
1 x Map/MAT sensor weld bung
1 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x Upgrade Valve Springs T5 Cars
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x Open Air Intake 9000 93-98
1 x BSR 9-5 3.0T V6 200Hp
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Head Stud Kit all 4cyl
$34,562.51
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail