$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x AEM Wideband Gauge Kit
5 x Intake Flange B2x4 T5
3 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
3 x Map/MAT sensor weld bung
2 x Rivetnuts Pair (2pcs)
1 x Griffin logo Shifter Top
3 x Con Rods V6 2.8L 155.8mm
3 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x Weld Bungs -Taper- Race Only
2 x IAT Weld Bung T5/Bosch
2 x Injectors Siemens 60lb 630cc (set 4)
1 x Fuel Pressure Regulator 4.0 bar
4 x PPC - Upgrade from stage 1 to stage 3
1 x Injectors Green Giant 42lb (set 4)
2 x Header Flange Stainless Blended Transition B2x4,B2x5
3 x Head Bolt Washers
1 x T5 3.0 Bar Map Sensor Adaptor
2 x Moog Ball Joint
1 x 9-5 Wheel 10-Spoke 16in.
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
2 x B207 Coolant Cap
1 x Mat Set Black Rubber 9-5 10-
3 x BSR 9-5 2010-2011 V6 300Hp
1 x Storage Tray / Ashtray Kit 9-5 10-
4 x Oil Cap 9-3SS V6 "Griffin"
2 x Oil Cap 9-3SS V6 "Ghost"
1 x BBS Center Cap for 9-2x RK small caps
3 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x InjectorDynamics 725cc For 2.8V6 (Set6)
2 x 9-5 Blend Flap Limit Lever 99-04
1 x 20th Viggen logo Shifter Top
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Headlight Bulb H7 Longer Life
1 x 9-5 Exhaust Flex Pipe Stainless
1 x 9-5 Open Air Prefilter
1 x Bulb Switch Light
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x 9-5 Textile Mats 98-07
1 x Crank Vent Kit #6 T7 4cyl
1 x Front Camber Adjustment Bolts
3 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Fog light Replacement Panels 99-01
1 x Rear Camber Shims Kit 6pcs
1 x Hood Emblem 9-5 All
1 x Midpipe 2.8T FWD (2wd)
2 x Downpipe 2.8T FWD (2wd)
2 x Injectors Siemens 80lb 875cc (set 4)
1 x Injectors 175hp Stg3 (Set4)
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
2 x B207 Upper Radiator Coolant T
1 x 3 Point Hardware
1 x Metal Steering Wheel Buttons
2 x Headlight Connector Repair Kit 9-3SS 9-5
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
2 x ShortShift Kit 93ss
2 x BSR Optiflow Intake V6 2.8t
3 x Midpipe 2.0T 07-11 FWD (2wd)
2 x Shifter Mount Kit 93ss
1 x Floormats BSR 9-3SS/SC
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
2 x Rear Pedestal Spoiler 9-3 SS
2 x Front Camber Adjustment Bolts
1 x Coreganizer
2 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
3 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
2 x BSR Optiflow Intake 4cyl w SAI
2 x ARP Exhaust Manifold Stud kit Stainless
2 x Brake Vac pump seals
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
2 x Downpipe 2.8T XWD (4wd)
2 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
2 x Hood Emblem 9-3 SS/sc 03- All
1 x Adaptor Harness Handsfree 01-
2 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
2 x Replacement V6 Coolant Cap
1 x Optical Cable Connector (Onstar Delete)
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Midpipe 2.8T XWD (4wd)
2 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Ignition Coil 9-3SS 2.8t and 2.8T
3 x SCNA Christmas Calendar
6 x BSR Optiflow Intake 4cyl
2 x V6 Tank Float - SparePart
1 x Sparkplugs 9-3SS
3 x Shifter Mount Kit Cobalt/ HHR
2 x MTF0063 Manual Gear oil
2 x Forge Bypass Valve Cobalt/HHR TC
3 x Saab black Keychain
1 x Mat Set Textile Jet Black 9-5 10-
2 x Limit Strap Coilover Add On Kit
1 x Fog light 9-3 left 99-00
1 x Brembo Brake Kit 315mm 9-5 02-->
2 x Shifter Alignment Pins (Set 2)
4 x v6 2.8t SAI Delete Kit
1 x Turbo Conversion Pipe 900 9-3 T5
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x Viggen Fog Air Intake
1 x Rear Brake Pads 9-5 Later Style
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x 9-5 High Performance Brake Line Kit
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Fog light Replacement Panels
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
2 x K&N Filter Service Kit
1 x Custom Brake Lines RR 300mm Kit
1 x Head Stud Kit all 4cyl
1 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
1 x Ceramic Low Dust Brake Pads 9-3 SS
1 x Short Shifter HHR Cobalt F35 F40
1 x 9-5 Rear Brake rotor See Description
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x BSR 9-5 3.0T V6 200Hp
1 x 9-5 Aero Sill Protection
1 x Throttle Body T7
1 x Slave Cyl
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x Rear Rotors PAIR 292mm Plain (Code: BB)
1 x T7 Head Plug NGK
1 x Rear Rotors PAIR 292mm XWD (Code: BC)
1 x Clear Little Fender Blinkers Factory Saab
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x PPC 3 Volvo Diagnostic System
1 x Valve Cover Gasket Set 4cyl
1 x v6oilcoolplate
1 x Troll Head Plug
1 x v6 header flange
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x Oil Cap GM "HHR"
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Oil Cooler Adaptor B2X5
1 x Rear spring perches Adjustable NG900/9-3
$38,203.03
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail