$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x Saab black Keychain
4 x 3 Point Hardware
4 x 9000 Shifter Bushing Repair Kit
2 x Limit Strap Coilover Add On Kit
2 x Forge Bypass Valve Cobalt/HHR TC
2 x Short Shifter HHR Cobalt F35 F40
4 x Oil Cap GM "HHR"
3 x Shifter Mount Kit Cobalt/ HHR
1 x Viggen Titanium KeyChain
1 x c900 Performance Brake lines
3 x 9-5 Aero Sill Protection
3 x Shift Rod Bushings
1 x v6oilcoolplate
1 x 20th Viggen logo Shifter Top
1 x Open Air Intake 9000 93-98
2 x Rear Camber Shims Kit 6pcs
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x B207 Upper Radiator Coolant T
1 x Front Camber Adjustment Bolts
2 x Exhaust manifold Stud Kit
2 x Oil Cooler Adaptor B2X5
1 x 9000 Intercooler ETS
1 x Oil Filter Re-locator
2 x Oil Cap 9-3SS "Ghost"
1 x Brake Vac pump seals
3 x Crush Sleeve F35 F25
2 x IAT Weld Bung T5/Bosch
1 x 9-5 Exhaust Flex Pipe Stainless
1 x v6 header flange
2 x Steering Coupler 9-3 99-02
1 x 9000 High Performance Brake Line Kit '95-'98
3 x Clear Little Fender Blinkers Factory Saab
1 x Injectors Green Giant 42lb (set 4)
1 x Transmission Nut F35 F25
2 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Flywheel Twin Disk 7.25in B2xx
2 x Intake Flange B2x4 T5
2 x Machined Control Arm Kit
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Griffin logo Shifter Top
3 x Head Bolt Washers
2 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
2 x 9-5 Wheel 5-Spoke Twin 17in
1 x Antenna Plug NG900/9-3 hatchback
2 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x 9-3/NG900 Shift Knobs Leather
2 x 9-5 Shift Knobs Leather
1 x 9-3 ng900 Hood Protection Strip
3 x 9-5 Wheel 10-Spoke 16in.
1 x 9-3 /NG900 Grille
1 x 9-5 Rear Brake rotor See Description
1 x ATF Saab 3309 (Automatic 02->)
1 x 4 Cyl 2.0 Coolant Tank
1 x BSR 9-5 3.0T V6 200Hp
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
3 x SCNA Christmas Calendar
2 x BSR Optiflow Replacement Filter V6 2.8
1 x Mat Set Black Rubber 9-5 10-
3 x PPC - Upgrade from stage 1 to stage 3
3 x AEM Wideband Gauge Kit
3 x Rivetnuts Pair (2pcs)
3 x Moog Ball Joint
1 x Injectors Siemens 60lb 630cc (set 4)
1 x Universal / Special Request
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x 9-3 SS Akebono Rear Pads
1 x 9-5 Open Air Prefilter
1 x Replacement V6 Coolant Cap
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x 9-5 286mm REAR Brembo Disk (1) See Descr.
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
1 x MTF0063 Manual Gear oil
1 x Sparkplugs 9-3SS
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x Shifter Mount Kit 93ss
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x Exhaust Clamp Kit
1 x Direct Ignition T7 Black
1 x Turbo Bypass Valve
2 x Rear Rotors PAIR 278mm Plain (Code: BA)
2 x Oil Cap 9-3SS V6 "Ghost"
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x Basic Subframe Brace
1 x Weld Bungs -Taper- Race Only
1 x Injectors Siemens 80lb 875cc (set 4)
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x Rear Rotors PAIR 292mm XWD (Code: BC)
2 x Oil Cap 9-3SS V6 "Griffin"
1 x BBS Center Cap for 9-2x RK small caps
1 x Viggen Front Brake Disk Pair 308mm
1 x Sport Transmission Mount 9-3/900 (Automatic)
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Shifter Top Ghost Logo
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x Con Rods V6 2.8L 155.8mm
1 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x Map/MAT sensor weld bung
1 x Replacement Filter for Open air 9-3 T7
1 x Drop in Sport Filter 9-5
1 x ShortShift Kit 93ss
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Cat back for Viggen 2.5in
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x Brembo Kit 315mm Hawk HPS Pads
1 x Ceramic Low Dust Brake Pads 9-3 SS
$21,783.27
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail