$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x Crank Vent Kit #6 T7 4cyl
3 x Adaptor Harness Handsfree 01-
3 x Coolant Bypass Valve 9-5
5 x 5d Rear Window repair kit 94-02 900/9-3/9-5
3 x Bulb Switch Light
3 x Genuine Saab 4cyl Oil Filters
4 x 9-5 Blend Flap Limit Lever 99-04
2 x Headlight Bulb H7 Longer Life
3 x ARP Exhaust Manifold Stud kit Stainless
4 x Shift Rod Bushings
1 x Moog Ball Joint
2 x Shifter Alignment Pins (Set 2)
1 x Con Rods V6 2.8L 155.8mm
2 x Limit Strap Coilover Add On Kit
1 x B207 Coolant Cap
3 x ATF Saab 3309 (Automatic 02->)
2 x 9-5 Aero Sill Protection
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
2 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Replacement V6 Coolant Cap
2 x K&N Filter Service Kit
2 x Short Shifter HHR Cobalt F35 F40
1 x Shifter Mount Kit Cobalt/ HHR
2 x Oil Cap GM "HHR"
2 x Forge Bypass Valve Cobalt/HHR TC
1 x Viggen Titanium KeyChain
2 x Saab black Keychain
1 x Head Stud Kit all 4cyl
2 x Midpipe 2.0T 07-11 FWD (2wd)
4 x Exhaust manifold Stud Kit
2 x Drop in Sport Filter 9-5
3 x 9-5 Open Air Prefilter
2 x Floormats BSR 9-5
2 x Headbolts (New Style)
2 x Oil Pressure Switch
2 x Downpipe Hardware Kit
1 x Mat Set Textile Jet Black 9-5 10-
2 x Valve Cover Gasket Set 4cyl
3 x Oil Cap 9-3SS V6 "Ghost"
1 x Mat Set Black Rubber 9-5 10-
1 x Mat Set Textile Parchment 9-5 10-
2 x Throttle Body T7
1 x Mat Set Textile Shark Grey 9-5 10-
1 x T7 3.5 Bar Fuel Pressure Regulator
2 x Fuel Line Clip
2 x BSR 9-5 2010-2011 V6 300Hp
2 x Cabin Vent Fan
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Filter 9-5 Cabin Air
3 x Oil Cap 9-3SS V6 "Griffin"
1 x Crush Sleeve F35 F25
1 x Mass Airflow Meter T7
3 x Brake Vac pump seals
2 x Slave Cyl
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Machined Control Arm Kit
2 x Intake Flange B2x4 T5
2 x Hood Emblem 9-5 All
1 x Oil Filter Re-locator
2 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x T5 3.0 Bar Map Sensor Adaptor
2 x MTF0063 Manual Gear oil
1 x V6 Tank Float - SparePart
3 x 20th Viggen logo Shifter Top
1 x Steering Coupler 9-3 99-02
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x 9-3 / 900 Uprated Front ARB Bushings
2 x Fog light 9-3 left 99-00
1 x Air Filter 06 version (All 9-5)
1 x Basic Subframe Brace
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
2 x Clear Little Fender Blinkers Factory Saab
1 x Exhaust Clamp Kit
1 x SCNA Christmas Calendar
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x 9-3 ng900 radio wires
1 x ARP Ring Gear Bolts F25/F35
1 x 9000 High Performance Brake Line Kit '95-'98
2 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
2 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
2 x Brembo Kit 315mm Hawk HPS Pads
2 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Throttle Bend for T5 94-99
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x 9-5 Shift Knobs Leather
1 x 9-5 Exhaust Flex Pipe Stainless
2 x Cat Back Exh for 9-5 Aero 04-, All 06-
2 x T7 Injector Spacer Kit
1 x 9-5 Textile Mats 98-07
1 x Cigarette Lighter
1 x Direct Ignition T7 Black
3 x BSR Optiflow Intake 4cyl
2 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Oil Cap 9-3SS "Ghost"
1 x Open Air Intake 9000 93-98
1 x Oil Cooler Adaptor B2X5
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Map/MAT sensor weld bung
1 x Midpipe 2.8T XWD (4wd)
1 x IAT Weld Bung T5/Bosch
1 x Shifter Mount Kit 93ss
1 x Antenna Plug NG900/9-3 hatchback
1 x Viggen Front Brake Disk Pair 308mm
1 x Downpipe 2.8T XWD (4wd)
1 x Downpipe 2.8T FWD (2wd)
1 x Balance Shaft Tensioner Delete
1 x Turbo to Downpipe Flange B207
1 x T7 Head Plug NGK
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x 3 Point Hardware
3 x Head Bolt Washers
2 x Midpipe 2.8T FWD (2wd)
1 x Griffin logo Shifter Top
1 x v6 2.8t SAI Delete Kit
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x ShortShift Kit 93ss
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x AEM Wideband Gauge Kit
1 x Fog light Replacement Panels 99-01
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Troll Head Plug
1 x B207 Upper Radiator Coolant T
1 x v6 header flange
1 x Viggen Fog Air Intake
1 x 9000 Shifter Bushing Repair Kit
1 x 9-5 Intercooler ETS
$25,611.32
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail