$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Head Bolt Washers
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Moog Ball Joint
1 x PPC 3 Volvo Diagnostic System
4 x BSR Optiflow Intake 4cyl
1 x Short Shifter HHR Cobalt F35 F40
1 x Forge Bypass Valve Cobalt/HHR TC
2 x Midpipe 2.0T 07-11 FWD (2wd)
2 x 9-5 Aero Sill Protection
1 x 9-3 /NG900 Grille
1 x Antenna Plug NG900/9-3 hatchback
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
2 x 9-5 Wheel 5-Spoke Twin 17in
1 x 9-5 Rear Brake rotor See Description
1 x 9-3/NG900 Shift Knobs Leather
4 x 9-5 Wheel 10-Spoke 16in.
1 x Aero Clutch Kit 9-5
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x 9-3 ng900 Hood Protection Strip
2 x ATF Saab 3309 (Automatic 02->)
1 x 9-5 Shift Knobs Leather
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x 9-5 Textile Mats 98-07
1 x Drop in Sport Filter 9-5
1 x ARP Exhaust Manifold Stud kit Stainless
1 x Exhaust manifold Stud Kit
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x 3 Point Hardware
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
2 x Oil Cap 9-3SS V6 "Griffin"
3 x Mat Set Black Rubber 9-5 10-
3 x Mat Set Textile Parchment 9-5 10-
2 x BSR 9-5 260Hp 2006-
2 x Shift Rod Bushings
1 x BSR Optiflow Intake 4cyl w SAI
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Custom Brake Lines RR 300mm Kit
2 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Clear Little Fender Blinkers Factory Saab
1 x Front Rotors PAIR 285mm Plain (Code: AA)
2 x Rear Camber Shims Kit 6pcs
1 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x 9000 High Performance Brake Line Kit '95-'98
1 x c900 Performance Brake lines
1 x 9-5 286mm REAR Brembo Disk (1) See Descr.
1 x Fog light 9-3 left 99-00
1 x Fog light 9-3 Right 99-00
1 x Basic Subframe Brace
1 x B207 Coolant Cap
1 x Mat Set Textile Jet Black 9-5 10-
1 x MTF0063 Manual Gear oil
1 x Rear Pedestal Spoiler 9-3 SS
1 x Optical Cable Connector (Onstar Delete)
1 x Saab black Keychain
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
2 x Cat Back Exh for 9-5 Aero 04-, All 06-
2 x Oil Cap 9-3SS V6 "Ghost"
1 x Oil Cap 9-3SS "Ghost"
1 x Brake Vac pump seals
1 x ShortShift Kit 93ss
1 x v6 header flange
1 x BSR 9-5 3.0T V6 200Hp
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Mat Set Textile Shark Grey 9-5 10-
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Floormats BSR 9-3 99-02 900 94-98
1 x BBS Center Cap for 9-2x RK small caps
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x T7 Injector Spacer Kit
1 x Front Camber Adjustment Bolts
1 x Rivetnuts Pair (2pcs)
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Injectors 175hp Stg3 (Set4)
1 x Midpipe 2.8T FWD (2wd)
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x Turbo to Downpipe Flange B207
1 x B207 Upper Radiator Coolant T
1 x Genuine Saab 4cyl Oil Filters
$18,958.90
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail