$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x ATF Saab 3309 (Automatic 02->)
3 x Limit Strap Coilover Add On Kit
1 x B207 Coolant Cap
1 x Troll Head Plug
1 x Rear spring perches Adjustable NG900/9-3
1 x Fog light 9-3 Right 99-00
1 x 20th Viggen logo Shifter Top
1 x Slave Cyl
1 x Fuel Line Clip
2 x Replacement Flywheel Insert NG900/9-3
3 x 9-3 / 900 Uprated Front ARB Bushings
1 x Headbolts (New Style)
1 x Mass Airflow Meter T7
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x 9-3 ng900 Hood Protection Strip
1 x Genuine Saab 4cyl Oil Filters
2 x 9-3 ng900 radio wires
1 x Alu Hybrid Flywheel For NG900/9-3
2 x Fog light Replacement Panels
2 x Crush Sleeve F35 F25
2 x 9-3 Rear Ashtray
1 x Fog light 9-3 left 99-00
1 x Rod Bearings only Pauter Rods
1 x Machined Control Arm Kit
3 x Griffin logo Shifter Top
1 x Direct Ignition T7 Black
2 x Flex Pipe 900 94-98 9-3 99-02
2 x Steering Coupler 9-3 99-02
3 x Flywheel Twin Disk 7.25in B2xx
1 x PPC - Upgrade from stage 1 to stage 3
1 x Adaptor Harness Handsfree 01-
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Head Stud Kit all 4cyl
1 x Clear Little Fender Blinkers Factory Saab
1 x Exhaust Clamp Kit
1 x Transmission Nut F35 F25
1 x Steering Rod Bushings NG900/93
1 x T7 Head Plug NGK
1 x Sport Transmission Mount 9-3/900 (Automatic)
2 x 9-3 99-02,03 CV Antenna Adaptor
1 x 4340 Connecting Rods B204 B235
1 x Oil Filter Re-locator
1 x Rear Engine Mount 4cyl
2 x Antenna Plug NG900/9-3 hatchback
1 x ARP Ring Gear Bolts F25/F35
1 x Remote Button NG900
2 x Shifter Top Ghost Logo
2 x Coreganizer
3 x Shift Rod Bushings
2 x Replacement Hardware Pack 6-Point
3 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x BSR 9-5 2010-2011 V6 300Hp
1 x Mat Set Textile Jet Black 9-5 10-
1 x 9-5 Blend Flap Limit Lever 99-04
2 x MTF0063 Manual Gear oil
1 x 4 Cyl 2.0 Coolant Tank
2 x Brake Vac pump seals
1 x Intake Flange B2x4 T5
1 x Floormats BSR 9-3SS/SC
2 x Turbo Bypass Valve
1 x JE Piston Rings 90.0mm 235/205
1 x Floormats BSR 9-3 99-02 900 94-98
1 x Viggen Clutch Kit 99-02
1 x Cat back for Viggen 2.5in
1 x Rear Camber Shims Kit 6pcs
1 x Exhaust manifold Stud Kit
1 x Fog light Replacement Panels 99-01
1 x 3 Point Hardware
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Mat Set Black Rubber 9-5 10-
$13,351.74
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail