$20.00

Steering Rod Bushings NG900/93
[4242669U]

Steering Rod Bushings NG900/93

Add to Cart

Date Added: Monday 11 April, 2011

by Seth Johnson

Great part for worn out replacement or to use in conjunction with the steering rack brace. When used with the steering brace, cowl shake is severely reduced and the steering is much more responsive. For $20 why wouldn't you install these?

Installation tips:
at 150,000 miles don't think the original bushing are just going to "fall out". I wasn't about to try and remove the entire arm assembly and put it on a bench so I used some "help". That help came in the form of a propane torch being careful not to turn the old rubber (or fire wall) into a molten fiery mess. Once the rubber was crispy the metal insert fell out with ease and the rubber as well (this was done after the arms were removed from the rack). While I removed the bolts with the car on the ground, I wouldn't recommend installing them without the tires in the air. Using just one of the bolts I aligned the steering mechanism back in the rack so it was a snap to get the first arm lined up and the bolt started (don't forget the plate). Then remove the first alignment bolt you installed, load up the last arm with the bushing and install the last arm. Trying to install both bolts at the same time when they are tied together with that brace is near impossible. The locking tab went on smooth with an over sized socket (17mm) and a long breaker bar using leverage from the intake to seat it fully. If you have high miles on your SAAB, installing these can be a challenge but nothing an experienced car-crafter can't get done.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Saab black Keychain
1 x Viggen Titanium KeyChain
2 x SCNA Christmas Calendar
3 x MTF0063 Manual Gear oil
3 x Shift Rod Bushings
2 x 9-5 Wheel 10-Spoke 16in.
3 x 9-5 Aero Sill Protection
2 x BBS Center Cap for 9-2x RK small caps
2 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x BSR Optiflow Intake 4cyl w SAI
1 x BSR Optiflow Intake V6 2.8t
1 x Downpipe 2.8T FWD (2wd)
1 x 4 Cyl 2.0 Coolant Tank
2 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
3 x Weld Bungs -Taper- Race Only
2 x 9000 High Performance Brake Line Kit '95-'98
2 x Exhaust manifold Stud Kit
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x Cat Back Exh for 9000 CS, CSE AERO
2 x 9000 Shifter Bushing Repair Kit
2 x BSR 9-5 3.0T V6 200Hp
3 x PPC - Upgrade from stage 1 to stage 3
2 x BSR 9-5 260Hp 2006-
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x Drop in Sport Filter 9-5
1 x Open Air Intake 9000 93-98
2 x Injectors Green Giant 42lb (set 4)
2 x IAT Weld Bung T5/Bosch
1 x Clear Little Fender Blinkers Factory Saab
1 x K&N Filter Service Kit
1 x Fuel Pressure Regulator 4.0 bar
2 x Header Flange Stainless Blended Transition B2x4,B2x5
2 x Intake Flange B2x4 T5
2 x Head Bolt Washers
2 x 9000 Intercooler ETS
1 x T5 3.0 Bar Map Sensor Adaptor
2 x Crush Sleeve F35 F25
1 x Moog Ball Joint
4 x Universal / Special Request
2 x ARP Exhaust Manifold Stud kit Stainless
3 x AEM Wideband Gauge Kit
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
1 x B207 Coolant Cap
1 x Injectors 175hp Stg3 (Set4)
1 x Downpipe 2.8T XWD (4wd)
1 x Basic Subframe Brace
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x 9-3/NG900 Shift Knobs Leather
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x Front Camber Adjustment Bolts
1 x Map/MAT sensor weld bung
1 x V6 Tank Float - SparePart
1 x Rear Pedestal Spoiler 9-3 SS
1 x Sparkplugs 9-3SS
1 x Hood Emblem 9-3 SS/sc 03- All
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Replacement V6 Coolant Cap
1 x Injectors Siemens 80lb 875cc (set 4)
1 x Head Stud Kit all 4cyl
1 x Downpipe Hardware Kit
2 x Midpipe 2.0T 07-11 FWD (2wd)
$16,937.35
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail