$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Metal Steering Wheel Buttons
3 x Adaptor Harness Handsfree 01-
1 x Sparkplugs 9-3SS
3 x Replacement V6 Coolant Cap
3 x K&N Filter Service Kit
6 x MTF0063 Manual Gear oil
3 x Shifter Alignment Pins (Set 2)
2 x Saab black Keychain
3 x SCNA Christmas Calendar
1 x Viggen Titanium KeyChain
3 x Limit Strap Coilover Add On Kit
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x Forge Bypass Valve Cobalt/HHR TC
1 x B207 Coolant Cap
1 x T7 Head Plug NGK
1 x 9000 Shifter Bushing Repair Kit
1 x Troll Head Plug
3 x Midpipe 2.8T FWD (2wd)
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Fuel Pressure Regulator 4.0 bar
2 x Intake Flange B2x4 T5
1 x Injectors Green Giant 42lb (set 4)
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x c900 Performance Brake lines
3 x Clear Little Fender Blinkers Factory Saab
1 x T5 3.0 Bar Map Sensor Adaptor
2 x Rivetnuts Pair (2pcs)
1 x PPC - Upgrade from stage 1 to stage 3
2 x Shift Rod Bushings
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
2 x Exhaust manifold Stud Kit
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
2 x 20th Viggen logo Shifter Top
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x Crank Vent Kit #6 T7 4cyl
1 x Replacement Filter for Open air 9-3 T7
1 x Aluminum Flywheel For NG900/9-3
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x Antenna Plug NG900/9-3 hatchback
3 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
1 x Rear Rotors PAIR 292mm Plain (Code: BB)
2 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x Rear Rotors PAIR 292mm XWD (Code: BC)
1 x 9-3 SS Akebono Rear Pads
3 x Rear Brake Pads 9-3 SS
1 x 9-5 Textile Mats 98-07
1 x Cabin Vent Fan
1 x JE Piston Rings 90.0mm 235/205
1 x Air Filter 06 version (All 9-5)
1 x Headbolts (New Style)
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x 9-5 Exhaust Flex Pipe Stainless
1 x 9-5 Shift Knobs Leather
1 x Head Bolt Washers
1 x Injectors Siemens 80lb 875cc (set 4)
1 x Universal / Special Request
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Midpipe 2.0T 07-11 FWD (2wd)
2 x Brembo Kit 315mm Hawk HPS Pads
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
2 x Ceramic Low Dust Brake Pads 9-3 SS
2 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x Brembo Brake Kit 315mm 9-3 SS
2 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x Oil Cap 9-3SS V6 "Griffin"
3 x Oil Cap 9-3SS V6 "Ghost"
2 x Mat Set Textile Jet Black 9-5 10-
1 x Mat Set Textile Parchment 9-5 10-
2 x Mat Set Black Rubber 9-5 10-
2 x Storage Tray / Ashtray Kit 9-5 10-
1 x Mat Set Textile Shark Grey 9-5 10-
1 x 9-5 Blend Flap Limit Lever 99-04
1 x Steering Rod Bushings NG900/93
2 x Exhaust Clamp Kit
2 x Rear Engine Mount 4cyl
2 x Flex Pipe 900 94-98 9-3 99-02
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Replacement Hardware Pack 6-Point
2 x 9-5 Wheel 10-Spoke 16in.
1 x 9-5 High Performance Brake Line Kit
1 x Rear Camber Shims Kit 6pcs
1 x Hood Emblem 9-3 SS/sc 03- All
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x 9000 High Performance Brake Line Kit '95-'98
1 x Custom Brake Lines RR 300mm Kit
2 x Moog Ball Joint
1 x Steering Coupler 9-3 99-02
1 x ATF Saab 3309 (Automatic 02->)
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x Shifter Mount Kit 93ss
3 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x Floormats BSR 9-3 99-02 900 94-98
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Front Camber Adjustment Bolts
2 x ShortShift Kit 93ss
1 x Viggen Fog Air Intake
1 x BSR Optiflow Intake 4cyl w SAI
1 x Brembo Brake Kit 315mm 9-5 02-->
2 x BSR 9-5 2010-2011 V6 300Hp
1 x Turbo Bypass Valve
1 x Crush Sleeve F35 F25
1 x BBS Center Cap for 9-2x RK small caps
1 x Griffin logo Shifter Top
1 x 9-3 ng900 radio wires
1 x 9-3/NG900 Shift Knobs Leather
1 x Throttle Bend for T5 94-99
1 x Turbo Conversion Pipe 900 9-3 T5
1 x T7 Injector Spacer Kit
2 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x Remote Button NG900
1 x 9-5 Aero Sill Protection
1 x Basic Subframe Brace
1 x Rear spring perches Adjustable NG900/9-3
1 x Front Camber Adjustment Bolts
$23,809.60
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail