$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
4 x SCNA Christmas Calendar
4 x Forge Bypass Valve Cobalt/HHR TC
1 x AEM Wideband Gauge Kit
2 x Troll Head Plug
1 x Head Bolt Washers
4 x PPC - Upgrade from stage 1 to stage 3
1 x Universal / Special Request
2 x Map/MAT sensor weld bung
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x T7 Head Plug NGK
1 x Intake Flange B2x4 T5
1 x Turbo Conversion Pipe 900 9-3 T5
1 x Crank Vent Kit #6 T7 4cyl
4 x Short Shifter HHR Cobalt F35 F40
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
3 x Rear Engine Mount 4cyl
2 x ARP Ring Gear Bolts F25/F35
1 x Fuel Line Clip
2 x Alu Hybrid Flywheel For NG900/9-3
1 x Exhaust Clamp Kit
1 x Direct Ignition T7 Black
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Flywheel Twin Disk 7.25in B2xx
1 x Sport Transmission Mount 9-3/900 (Automatic)
3 x T7 3.5 Bar Fuel Pressure Regulator
1 x Mass Airflow Meter T7
1 x Replacement Flywheel Insert NG900/9-3
1 x Remote Button NG900
1 x Genuine Saab 4cyl Oil Filters
1 x Oil Cooler Adaptor B2X5
3 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Slave Cyl
1 x Shifter Top Ghost Logo
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x Throttle Bend for T5 94-99
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x T7 Injector Spacer Kit
2 x Aluminum Flywheel For NG900/9-3
1 x Replacement Filter for Open air 9-3 T7
1 x Viggen Fog Air Intake
2 x Hood Emblem 9-5 All
1 x 9-3 ng900 radio wires
1 x Steering Coupler 9-3 99-02
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Coreganizer
1 x Oil Cap GM "HHR"
1 x Drop in Sport Filter 9-5
2 x Adaptor Harness Handsfree 01-
2 x 9-3 / 900 Uprated Front ARB Bushings
1 x Rod Bearings only Pauter Rods
3 x Saab black Keychain
2 x Fog light Replacement Panels 99-01
2 x Rear Camber Shims Kit 6pcs
2 x Balance Shaft Tensioner Delete
1 x Headbolts (New Style)
1 x BSR 9-5 3.0T V6 200Hp
1 x Flex Pipe 900 94-98 9-3 99-02
1 x JE Piston Rings 90.0mm 235/205
2 x Fog light 9-5 Aero 04-05, 06-08 All Right
2 x Machined Control Arm Kit
1 x 4340 Connecting Rods B204 B235
1 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x Bulb Switch Light
1 x Coolant Bypass Valve 9-5
1 x Headlight Bulb H7 Longer Life
1 x 9-5 Textile Mats 98-07
2 x Floormats BSR 9-5
1 x Air Filter 06 version (All 9-5)
1 x 9-5 Open Air Prefilter
1 x 9-5 Wheel 10-Spoke 16in.
1 x v6 header flange
3 x Clear Little Fender Blinkers Factory Saab
4 x Shift Rod Bushings
3 x 9000 Intercooler ETS
2 x 9000 Shifter Bushing Repair Kit
2 x 9000 High Performance Brake Line Kit '95-'98
2 x Mat Set Textile Shark Grey 9-5 10-
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Mat Set Textile Jet Black 9-5 10-
2 x Oil Cap 9-3SS V6 "Ghost"
1 x Mat Set Textile Parchment 9-5 10-
1 x 9-5 High Performance Brake Line Kit
3 x MTF0063 Manual Gear oil
1 x BSR Optiflow Intake 4cyl
1 x BSR Optiflow Intake V6 2.8t
1 x Downpipe 2.8T XWD (4wd)
1 x 9-5 Exhaust Flex Pipe Stainless
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x Basic Subframe Brace
1 x 9-5 Blend Flap Limit Lever 99-04
2 x Brake Vac pump seals
1 x Shifter Mount Kit Cobalt/ HHR
1 x Fog light Replacement Panels
1 x Viggen Front Brake Disk Pair 308mm
1 x 9-5 Aero Sill Protection
2 x Cat Back Exh for 9000 CS, CSE AERO
1 x Injectors Green Giant 42lb (set 4)
1 x Steering Rod Bushings NG900/93
1 x Floormats BSR 9-3 99-02 900 94-98
1 x Griffin logo Shifter Top
1 x Downpipe 2.8T FWD (2wd)
1 x B207 Upper Radiator Coolant T
1 x B207 Coolant Cap
1 x ARP Exhaust Manifold Stud kit Stainless
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
2 x Open Air Intake 9000 93-98
1 x Head Stud Kit all 4cyl
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x Torque Mount Insert V6 Manual (XWD and FWD)
$23,547.64
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail