$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x 20th Viggen logo Shifter Top
3 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x AEM Wideband Gauge Kit
2 x Rivetnuts Pair (2pcs)
5 x IAT Weld Bung T5/Bosch
3 x Injectors Green Giant 42lb (set 4)
3 x Intake Flange B2x4 T5
1 x Universal / Special Request
4 x Header Flange Stainless Blended Transition B2x4,B2x5
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
3 x Head Bolt Washers
4 x Injectors Siemens 80lb 875cc (set 4)
1 x Injectors Siemens 60lb 630cc (set 4)
5 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
2 x T5 3.0 Bar Map Sensor Adaptor
3 x PPC - Upgrade from stage 1 to stage 3
4 x Map/MAT sensor weld bung
2 x Moog Ball Joint
1 x Viggen Titanium KeyChain
2 x Shifter Mount Kit Cobalt/ HHR
2 x Con Rods V6 2.8L 155.8mm
2 x Troll Head Plug
2 x B207 Coolant Cap
1 x T7 Head Plug NGK
1 x 9000 Shifter Bushing Repair Kit
2 x Limit Strap Coilover Add On Kit
2 x SCNA Christmas Calendar
1 x c900 Performance Brake lines
1 x v6oilcoolplate
1 x v6 2.8t SAI Delete Kit
2 x Shifter Top Ghost Logo
2 x T7 Injector Spacer Kit
1 x Downpipe 2.8T XWD (4wd)
1 x BBS Center Cap for 9-2x RK small caps
1 x Throttle Bend for T5 94-99
1 x Balance Shaft Tensioner Delete
2 x Brembo Brake Kit 315mm 9-5 02-->
1 x Replacement Hardware Pack 6-Point
2 x Sport Transmission Mount 9-3/900 (Automatic)
2 x Shift Rod Bushings
2 x Steering Rod Bushings NG900/93
1 x ShortShift Kit 93ss
1 x Rear Camber Shims Kit 6pcs
1 x Rear spring perches Adjustable NG900/9-3
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Short Shifter HHR Cobalt F35 F40
1 x Oil Cap 9-3SS "Ghost"
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x Oil Cooler Adaptor B2X5
1 x Midpipe 2.8T XWD (4wd)
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x Machined Control Arm Kit
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Exhaust manifold Stud Kit
1 x Griffin logo Shifter Top
1 x Oil Cap GM "HHR"
3 x 9-5 Wheel 10-Spoke 16in.
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Midpipe 2.8T FWD (2wd)
1 x Open Air Intake 9000 93-98
2 x Midpipe 2.0T 07-11 FWD (2wd)
2 x Oil Filter Re-locator
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Direct Ignition T7 Black
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
2 x 9-3 ng900 radio wires
1 x 9-5 Open Air Prefilter
1 x B207 Upper Radiator Coolant T
1 x Front Camber Adjustment Bolts
2 x Floormats BSR 9-5
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
3 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x V6 Tank Float - SparePart
2 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Replacement Filter for Open air 9-3 T7
1 x Shifter Alignment Pins (Set 2)
1 x Custom Brake Lines RR 300mm Kit
1 x ATF Saab 3309 (Automatic 02->)
1 x MTF0063 Manual Gear oil
2 x K&N Filter Service Kit
1 x Bulb Switch Light
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
2 x 9-3 Rear Ashtray
1 x 9-5 Aero Sill Protection
1 x Replacement V6 Coolant Cap
1 x Cigarette Lighter
1 x 9-5 Shift Knobs Leather
1 x Drop in Sport Filter 9-5
2 x Fuel Pressure Regulator 4.0 bar
1 x Filter 9-5 Cabin Air
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x 9-3/NG900 Shift Knobs Leather
1 x 9-5 Blend Flap Limit Lever 99-04
$19,918.30
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail