$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x Shifter Mount Kit Cobalt/ HHR
1 x Viggen Titanium KeyChain
3 x SCNA Christmas Calendar
1 x Injectors Siemens 60lb 630cc (set 4)
1 x K&N Filter Service Kit
2 x Con Rods V6 2.8L 155.8mm
1 x T7 Head Plug NGK
1 x Troll Head Plug
1 x B207 Coolant Cap
2 x 9-3SS Wheel 5-Spoke Low Split 17 in.
2 x Oil Filter Re-locator
3 x Adaptor Harness Handsfree 01-
3 x Direct Ignition T7 Black
5 x 20th Viggen logo Shifter Top
2 x Clear Little Fender Blinkers Factory Saab
1 x Fog light Replacement Panels
2 x Transmission Nut F35 F25
2 x Antenna Plug NG900/9-3 hatchback
3 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
3 x Crank Vent Kit #6 T7 4cyl
2 x Slave Cyl
3 x Coreganizer
2 x 9-3 /NG900 Grille
2 x Flex Pipe 900 94-98 9-3 99-02
4 x T7 3.5 Bar Fuel Pressure Regulator
1 x Quaife Differential 9-5 and Viggen (F35)
2 x Direct Ignition T5 RED
1 x Fog light 9-3 Right 99-00
2 x 9-5 Blend Flap Limit Lever 99-04
2 x 9-3 99-02,03 CV Antenna Adaptor
2 x Griffin logo Shifter Top
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Replacement Filter for Open air 9-3 T7
1 x Rear Engine Mount 4cyl
1 x Remote Button NG900
2 x Fuel Line Clip
5 x Shift Rod Bushings
3 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x 9-3 Rear Ashtray
2 x 9-3/NG900 Shift Knobs Leather
1 x Aluminum Flywheel For NG900/9-3
2 x Replacement Flywheel Insert NG900/9-3
3 x Replacement Hardware Pack 6-Point
1 x Alu Hybrid Flywheel For NG900/9-3
3 x Genuine Saab 4cyl Oil Filters
2 x Exhaust Clamp Kit
1 x Cat back for Viggen 2.5in
2 x ARP Exhaust Manifold Stud kit Stainless
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
3 x PPC - Upgrade from stage 1 to stage 3
2 x Exhaust manifold Stud Kit
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x Steering Rod Bushings NG900/93
1 x Limit Strap Coilover Add On Kit
1 x Machined Control Arm Kit
1 x Basic Subframe Brace
2 x Air Filter 06 version (All 9-5)
1 x Hood Emblem 9-5 All
1 x Rear Camber Shims Kit 6pcs
2 x MTF0063 Manual Gear oil
1 x 9-5 Exhaust Flex Pipe Stainless
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x Floormats BSR 9-5
2 x Aero Clutch Kit 9-5
1 x Midpipe 2.8T XWD (4wd)
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
2 x T7 Injector Spacer Kit
1 x Downpipe 2.8T FWD (2wd)
2 x Midpipe 2.0T 07-11 FWD (2wd)
1 x BSR Optiflow Intake 4cyl w SAI
1 x ATF Saab 3309 (Automatic 02->)
2 x 9-5 Textile Mats 98-07
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x Drop in Sport Filter 9-5
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
1 x Cabin Vent Fan
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x Oil Pressure Switch
1 x Front Camber Adjustment Bolts
1 x BSR Optiflow Intake V6 2.8t
1 x 9-5 Rear Brake rotor See Description
2 x 9-5 Aero Sill Protection
2 x 9-5 Shift Knobs Leather
1 x Cat Back Exh for 9000 CS, CSE AERO
2 x Crush Sleeve F35 F25
1 x Flywheel Twin Disk 7.25in B2xx
1 x Oil Cap 9-3SS V6 "Griffin"
2 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Injectors 175hp Stg3 (Set4)
2 x Downpipe Hardware Kit
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Filter 9-5 Cabin Air
1 x 9-5 Intercooler ETS
1 x BSR Optiflow Intake 4cyl
1 x Bulb Switch Light
1 x 9-5 Wheel 10-Spoke 16in.
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x 9-5 Open Air Prefilter
1 x Cigarette Lighter
1 x Coolant Bypass Valve 9-5
1 x Head Stud Kit all 4cyl
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Mass Airflow Meter T7
1 x Downpipe 2.8T XWD (4wd)
1 x Headlight Bulb H7 Longer Life
1 x Rear Pedestal Spoiler 9-3 SS
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x Fog light Replacement Panels 99-01
1 x Midpipe 2.8T FWD (2wd)
1 x Headbolts (New Style)
1 x 9-3 ng900 Hood Protection Strip
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Shifter Mount Kit 93ss
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x ShortShift Kit 93ss
1 x Forge Bypass Valve Cobalt/HHR TC
1 x BSR 9-5 260Hp 2006-
1 x Metal Steering Wheel Buttons
1 x Floormats BSR 9-3SS/SC
1 x BSR 9-5 3.0T V6 200Hp
3 x Oil Cap GM "HHR"
1 x B207 Upper Radiator Coolant T
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Brake Vac pump seals
1 x Hood Emblem 9-3 SS/sc 03- All
1 x Saab black Keychain
1 x Viggen Front Brake Disk Pair 308mm
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Moog Ball Joint
1 x Rear spring perches Adjustable NG900/9-3
1 x Replacement V6 Coolant Cap
1 x Rivetnuts Pair (2pcs)
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Upgrade Valve Springs T5 Cars
1 x Oil Cooler Adaptor B2X5
1 x ARP Ring Gear Bolts F25/F35
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Viggen Clutch Kit 99-02
$37,648.01
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail