$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
4 x Replacement V6 Coolant Cap
2 x B207 Coolant Cap
1 x Viggen Titanium KeyChain
3 x MTF0063 Manual Gear oil
2 x K&N Filter Service Kit
2 x 9-3 / 900 Uprated Front ARB Bushings
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x 9-5 Blend Flap Limit Lever 99-04
3 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x 20th Viggen logo Shifter Top
3 x PPC - Upgrade from stage 1 to stage 3
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Intake Flange B2x4 T5
1 x AEM Wideband Gauge Kit
1 x Universal / Special Request
1 x Troll Head Plug
1 x Limit Strap Coilover Add On Kit
1 x T7 Head Plug NGK
1 x Rod Bearings only Pauter Rods
1 x JE Piston Rings 90.0mm 235/205
1 x Antenna Plug NG900/9-3 hatchback
1 x 9-3 /NG900 Grille
2 x 9-3 Rear Ashtray
3 x 9-3 ng900 radio wires
1 x 9-5 Aero Sill Protection
2 x Floormats BSR 9-3 99-02 900 94-98
2 x Adaptor Harness Handsfree 01-
2 x T7 3.5 Bar Fuel Pressure Regulator
3 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Genuine Saab 4cyl Oil Filters
1 x Throttle Bend for T5 94-99
2 x T7 Injector Spacer Kit
2 x Crush Sleeve F35 F25
1 x Downpipe Hardware Kit
1 x Replacement Hardware Pack 6-Point
2 x Turbo Conversion Pipe 900 9-3 T5
1 x Replacement Flywheel Insert NG900/9-3
3 x Exhaust Clamp Kit
1 x Flywheel Twin Disk 7.25in B2xx
1 x Mass Airflow Meter T7
1 x Direct Ignition T7 Black
3 x Transmission Nut F35 F25
1 x Viggen Fog Air Intake
3 x ARP Ring Gear Bolts F25/F35
2 x Flex Pipe 900 94-98 9-3 99-02
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x Direct Ignition T5 RED
3 x Rear Engine Mount 4cyl
2 x Aluminum Flywheel For NG900/9-3
5 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Oil Cooler Adaptor B2X5
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Replacement Filter for Open air 9-3 T7
3 x Alu Hybrid Flywheel For NG900/9-3
1 x Remote Button NG900
1 x Quaife Differential 9-5 and Viggen (F35)
4 x Shift Rod Bushings
2 x Shifter Top Ghost Logo
1 x Crank Vent Kit #6 T7 4cyl
1 x Fuel Line Clip
1 x Injectors 175hp Stg3 (Set4)
2 x Midpipe 2.8T FWD (2wd)
2 x Downpipe 2.8T XWD (4wd)
1 x BSR Optiflow Replacement Filter V6 2.8
2 x Brake Vac pump seals
1 x Floormats BSR 9-3SS/SC
2 x Rear Pedestal Spoiler 9-3 SS
1 x Ignition Coil 9-3SS 2.0t and 2.0T
2 x Front Camber Adjustment Bolts
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x B207 Upper Radiator Coolant T
1 x Sparkplugs 9-3SS
1 x Con Rods V6 2.8L 155.8mm
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x BSR Optiflow Intake V6 2.8t
2 x Coreganizer
1 x V6 Tank Float - SparePart
1 x Optical Cable Connector (Onstar Delete)
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Clear Little Fender Blinkers Factory Saab
3 x Shifter Alignment Pins (Set 2)
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x Rivetnuts Pair (2pcs)
1 x Rear Camber Shims Kit 6pcs
1 x BSR 9-5 260Hp 2006-
1 x Fog light 9-3 Right 99-00
1 x 9-3 ng900 Hood Protection Strip
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
2 x Basic Subframe Brace
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x 9-5 Wheel 10-Spoke 16in.
1 x IAT Weld Bung T5/Bosch
2 x Slave Cyl
1 x Throttle Body T7
1 x Steering Rod Bushings NG900/93
2 x 9000 Shifter Bushing Repair Kit
2 x Sport Transmission Mount 9-5 (Manual) 1998-1999
2 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x 4 Cyl 2.0 Coolant Tank
1 x ShortShift Kit 93ss
2 x BSR Optiflow Intake 4cyl
2 x Shifter Mount Kit 93ss
1 x SCNA Christmas Calendar
1 x ARP Exhaust Manifold Stud kit Stainless
1 x Cat back for Viggen 2.5in
1 x 4340 Connecting Rods B204 B235
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Aero Clutch Kit 9-5
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Midpipe 2.8T XWD (4wd)
1 x ATF Saab 3309 (Automatic 02->)
1 x Injectors Green Giant 42lb (set 4)
1 x 9000 Intercooler ETS
1 x Cat Back Exh for 9000 CS, CSE AERO
$27,708.16
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail