$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x Rear Engine Mount 4cyl
1 x Coreganizer
4 x SCNA Christmas Calendar
3 x Downpipe Hardware Kit
3 x Adaptor Harness Handsfree 01-
1 x 9-3 Rear Ashtray
2 x Crank Vent Kit #6 T7 4cyl
5 x 9-3/NG900 Shift Knobs Leather
4 x Exhaust Clamp Kit
4 x Genuine Saab 4cyl Oil Filters
1 x Limit Strap Coilover Add On Kit
1 x 4340 Connecting Rods B204 B235
1 x Balance Shaft Tensioner Delete
1 x Headbolts (New Style)
2 x Head Stud Kit all 4cyl
2 x T5 3.0 Bar Map Sensor Adaptor
1 x Rivetnuts Pair (2pcs)
1 x Intake Flange B2x4 T5
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Injectors Siemens 60lb 630cc (set 4)
1 x Head Bolt Washers
1 x Universal / Special Request
1 x AEM Wideband Gauge Kit
3 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x PPC - Upgrade from stage 1 to stage 3
2 x Injectors Green Giant 42lb (set 4)
2 x Injectors Siemens 80lb 875cc (set 4)
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Exhaust manifold Stud Kit
2 x 9-3 ng900 Hood Protection Strip
1 x Fog light Replacement Panels
2 x Oil Cap GM "HHR"
1 x Clear Little Fender Blinkers Factory Saab
1 x Fog light 9-3 left 99-00
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Alu Hybrid Flywheel For NG900/9-3
2 x Throttle Body T7
4 x Replacement Filter for Open air 9-3 T7
2 x MTF0063 Manual Gear oil
3 x Shift Rod Bushings
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Direct Ignition T7 Black
3 x Turbo Bypass Valve
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Oil Cooler Adaptor B2X5
1 x Oil Cap 9-3SS "Ghost"
1 x Steering Coupler 9-3 99-02
1 x B207 Upper Radiator Coolant T
2 x Direct Ignition T5 RED
1 x Midpipe 2.0T 07-11 FWD (2wd)
3 x Remote Button NG900
2 x 9-3 99-02,03 CV Antenna Adaptor
1 x V6 Tank Float - SparePart
1 x Flywheel Twin Disk 7.25in B2xx
3 x 20th Viggen logo Shifter Top
1 x Moog Ball Joint
1 x Machined Control Arm Kit
1 x K&N Filter Service Kit
2 x Saab black Keychain
1 x Forge Bypass Valve Cobalt/HHR TC
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x 9-5 Rear Brake rotor See Description
2 x Bulb Switch Light
1 x 9-5 Wheel 10-Spoke 16in.
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-5 Aero Sill Protection
1 x 9-5 Textile Mats 98-07
2 x Upgrade Valve Springs T5 Cars
2 x Oil Filter Re-locator
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Flex Pipe 900 94-98 9-3 99-02
1 x Griffin logo Shifter Top
1 x Crush Sleeve F35 F25
1 x Cat back for Viggen 2.5in
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x Coolant Bypass Valve 9-5
1 x Hood Emblem 9-3 SS/sc 03- All
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x Sparkplugs 9-3SS
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x Mat Set Textile Jet Black 9-5 10-
1 x Mat Set Textile Shark Grey 9-5 10-
1 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Fuel Line Clip
1 x Cigarette Lighter
1 x Headlight Bulb H7 Longer Life
1 x ATF Saab 3309 (Automatic 02->)
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x 9-3 ng900 radio wires
1 x Midpipe 2.8T XWD (4wd)
1 x Midpipe 2.8T FWD (2wd)
1 x 9-5 Blend Flap Limit Lever 99-04
1 x Replacement Hardware Pack 6-Point
1 x v6 2.8t SAI Delete Kit
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Ignition Coil 9-3SS 2.8t and 2.8T
$17,996.62
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail