$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x 9-3 ng900 Hood Protection Strip
3 x 9-3 /NG900 Grille
2 x Antenna Plug NG900/9-3 hatchback
1 x Cat back for Viggen 2.5in
1 x Exhaust manifold Stud Kit
1 x ARP Exhaust Manifold Stud kit Stainless
1 x Exhaust Clamp Kit
2 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Flex Pipe 900 94-98 9-3 99-02
2 x Sport Transmission Mount 9-3/900 (Automatic)
3 x Shifter Top Ghost Logo
2 x Rear Engine Mount 4cyl
2 x Shift Rod Bushings
1 x Slave Cyl
1 x Flywheel Twin Disk 7.25in B2xx
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Transmission Nut F35 F25
1 x Aluminum Flywheel For NG900/9-3
1 x Replacement Flywheel Insert NG900/9-3
1 x Quaife Differential 9-5 and Viggen (F35)
1 x 4340 Connecting Rods B204 B235
1 x T7 Head Plug NGK
1 x Headbolts (New Style)
2 x PPC - Upgrade from stage 1 to stage 3
1 x Oil Filter Re-locator
1 x JE Piston Rings 90.0mm 235/205
1 x 9-5 Blend Flap Limit Lever 99-04
1 x 9-3 / 900 Uprated Front ARB Bushings
2 x Turbo Conversion Pipe 900 9-3 T5
1 x Saab black Keychain
2 x Shifter Alignment Pins (Set 2)
1 x K&N Filter Service Kit
2 x 9-5 Aero Sill Protection
1 x Mat Set Textile Jet Black 9-5 10-
1 x Storage Tray / Ashtray Kit 9-5 10-
2 x Mat Set Textile Parchment 9-5 10-
1 x Mat Set Black Rubber 9-5 10-
1 x Oil Cap 9-3SS V6 "Ghost"
2 x Mat Set Textile Shark Grey 9-5 10-
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Basic Subframe Brace
1 x Fog light 9-3 Right 99-00
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x Clear Little Fender Blinkers Factory Saab
1 x Fog light 9-3 left 99-00
1 x Fog light Replacement Panels
2 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Optical Cable Connector (Onstar Delete)
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x 4 Cyl 2.0 Coolant Tank
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x Steering Rod Bushings NG900/93
1 x Midpipe 2.8T XWD (4wd)
1 x Viggen Fog Air Intake
1 x Throttle Bend for T5 94-99
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x T7 3.5 Bar Fuel Pressure Regulator
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x T7 Injector Spacer Kit
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Fog light Replacement Panels 99-01
1 x ATF Saab 3309 (Automatic 02->)
1 x Shifter Mount Kit Cobalt/ HHR
1 x Open Air Intake 9000 93-98
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Crush Sleeve F35 F25
1 x Replacement V6 Coolant Cap
1 x 9-3 SS Akebono Rear Pads
1 x Moog Ball Joint
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Upgrade Valve Springs T5 Cars
1 x V6 Tank Float - SparePart
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Fuel Pressure Regulator 4.0 bar
1 x Front Camber Adjustment Bolts
$17,016.47
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail