$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x Injectors Siemens 60lb 630cc (set 4)
3 x Intake Flange B2x4 T5
2 x Injectors Green Giant 42lb (set 4)
1 x IAT Weld Bung T5/Bosch
1 x T5 3.0 Bar Map Sensor Adaptor
2 x Head Bolt Washers
3 x PPC 3 Volvo Diagnostic System
3 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Oil Cap GM "HHR"
3 x Clear Little Fender Blinkers Factory Saab
1 x SCNA Christmas Calendar
2 x Saab black Keychain
2 x c900 Performance Brake lines
1 x Viggen Titanium KeyChain
1 x Troll Head Plug
2 x B207 Coolant Cap
5 x Midpipe 2.0T 07-11 FWD (2wd)
4 x MTF0063 Manual Gear oil
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Brake Vac pump seals
1 x Shifter Mount Kit 93ss
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
2 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
2 x Sparkplugs 9-3SS
2 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x Ignition Coil 9-3SS 2.0t and 2.0T
2 x ShortShift Kit 93ss
1 x Metal Steering Wheel Buttons
2 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
4 x Midpipe 2.8T XWD (4wd)
3 x Midpipe 2.8T FWD (2wd)
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
3 x Coreganizer
1 x Injectors 175hp Stg3 (Set4)
2 x Downpipe 2.8T FWD (2wd)
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x V6 Tank Float - SparePart
3 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Hood Emblem 9-3 SS/sc 03- All
4 x Adaptor Harness Handsfree 01-
1 x 9-5 Blend Flap Limit Lever 99-04
2 x 20th Viggen logo Shifter Top
2 x BSR Optiflow Intake 4cyl
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
2 x 9-3 / 900 Uprated Front ARB Bushings
2 x 3 Point Hardware
1 x B207 Upper Radiator Coolant T
1 x Rear Pedestal Spoiler 9-3 SS
1 x BSR Optiflow Intake V6 2.8t
2 x BSR Optiflow Replacement Filter V6 2.8
3 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
2 x Optical Cable Connector (Onstar Delete)
2 x Downpipe 2.8T XWD (4wd)
2 x BSR Optiflow Intake 4cyl w SAI
2 x K&N Filter Service Kit
2 x Replacement V6 Coolant Cap
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
4 x PPC - Upgrade from stage 1 to stage 3
1 x Floormats BSR 9-3SS/SC
2 x Front Camber Adjustment Bolts
1 x 9000 Intercooler ETS
1 x 9-5 Rear Brake rotor See Description
1 x Aluminum Flywheel For NG900/9-3
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Machined Control Arm Kit
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Fog light Replacement Panels
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x Downpipe Hardware Kit
1 x Direct Ignition T5 RED
1 x Throttle Bend for T5 94-99
1 x T7 Head Plug NGK
1 x Floormats BSR 9-3 99-02 900 94-98
1 x 9-3/NG900 Shift Knobs Leather
1 x Crank Vent Kit #6 T7 4cyl
1 x Exhaust manifold Stud Kit
2 x Flex Pipe 900 94-98 9-3 99-02
1 x Crush Sleeve F35 F25
2 x T7 Injector Spacer Kit
2 x Headbolts (New Style)
1 x Flywheel Twin Disk 7.25in B2xx
2 x Fuel Line Clip
1 x Basic Subframe Brace
3 x Rear Camber Shims Kit 6pcs
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Replacement Filter for Open air 9-3 T7
1 x Genuine Saab 4cyl Oil Filters
2 x Sport Transmission Mount 9-3/900 (Automatic)
1 x 9-3 Rear Ashtray
1 x Rod Bearings only Pauter Rods
1 x ARP Exhaust Manifold Stud kit Stainless
2 x Direct Ignition T7 Black
1 x Balance Shaft Tensioner Delete
2 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x 9-5 Aero Sill Protection
1 x 9-5 Shift Knobs Leather
2 x Fog light Replacement Panels 99-01
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
7 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x 9-5 High Performance Brake Line Kit
2 x Custom Brake Lines Brembo 315mm 9-3SS/SC
2 x 9000 High Performance Brake Line Kit '95-'98
3 x Custom Brake Lines RR 300mm Kit
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
3 x Steering Coupler 9-3 99-02
2 x Mass Airflow Meter T7
2 x Rear Engine Mount 4cyl
2 x Oil Filter Re-locator
3 x Steering Rod Bushings NG900/93
1 x Shifter Top Ghost Logo
2 x Exhaust Clamp Kit
3 x Shift Rod Bushings
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Oil Cooler Adaptor B2X5
1 x Cat back for Viggen 2.5in
2 x Griffin logo Shifter Top
1 x Rear spring perches Adjustable NG900/9-3
1 x 4340 Connecting Rods B204 B235
1 x Fog light 9-3 left 99-00
2 x Transmission Nut F35 F25
1 x Replacement Flywheel Insert NG900/9-3
1 x 9-3 ng900 radio wires
1 x 9-3 /NG900 Grille
1 x 9-3 ng900 Hood Protection Strip
1 x Slave Cyl
2 x Turbo Conversion Pipe 900 9-3 T5
3 x Limit Strap Coilover Add On Kit
2 x JE Piston Rings 90.0mm 235/205
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x ARP Ring Gear Bolts F25/F35
2 x Replacement Hardware Pack 6-Point
1 x Fog light 9-3 Right 99-00
2 x Head Stud Kit all 4cyl
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Antenna Plug NG900/9-3 hatchback
1 x Viggen Fog Air Intake
1 x Bulb Switch Light
1 x ATF Saab 3309 (Automatic 02->)
2 x v6oilcoolplate
1 x Rear Brake Pads 9-3 SS
2 x Rear Rotors PAIR 292mm XWD (Code: BC)
1 x 9000 Shifter Bushing Repair Kit
3 x Oil Cap 9-3SS V6 "Ghost"
1 x Con Rods V6 2.8L 155.8mm
1 x Front Rotors PAIR 302mm Plain (Code: AB)
3 x Shifter Alignment Pins (Set 2)
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x Universal / Special Request
1 x Oil Cap 9-3SS "Ghost"
1 x Weld Bungs -Taper- Race Only
1 x v6 header flange
1 x Oil Cap 9-3SS V6 "Griffin"
1 x v6 2.8t SAI Delete Kit
2 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
2 x Remote Button NG900
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x Viggen Clutch Kit 99-02
1 x Throttle Body T7
$45,172.72
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail