$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
5 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
7 x BSR Optiflow Intake 4cyl w SAI
3 x Downpipe 2.8T XWD (4wd)
5 x BSR Optiflow Intake 4cyl
10 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
3 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
4 x Injectors 175hp Stg3 (Set4)
5 x Ignition Coil 9-3SS 2.0t and 2.0T
5 x Replacement V6 Coolant Cap
2 x Hood Emblem 9-3 SS/sc 03- All
3 x Oil Cap GM "HHR"
3 x Short Shifter HHR Cobalt F35 F40
5 x Oil Cap 9-3SS "Ghost"
4 x v6 header flange
3 x Turbo to Downpipe Flange B207
7 x Oil Cap 9-3SS V6 "Ghost"
4 x Con Rods V6 2.8L 155.8mm
4 x B207 Coolant Cap
3 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
5 x Midpipe 2.8T XWD (4wd)
1 x Downpipe 2.8T FWD (2wd)
4 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Head Bolt Washers
1 x Rivetnuts Pair (2pcs)
3 x Clear Little Fender Blinkers Factory Saab
1 x Map/MAT sensor weld bung
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
2 x Filter 9-5 Cabin Air
2 x 9-5 Open Air Prefilter
2 x Air Filter 06 version (All 9-5)
3 x BSR 9-5 3.0T V6 200Hp
3 x 3 Point Hardware
2 x Floormats BSR 9-5
3 x Midpipe 2.0T 07-11 FWD (2wd)
2 x Head Stud Kit all 4cyl
2 x B207 Upper Radiator Coolant T
2 x BSR Optiflow Replacement Filter V6 2.8
3 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x 9-5 Intercooler ETS
2 x Cigarette Lighter
3 x ARP Exhaust Manifold Stud kit Stainless
2 x 9-5 Textile Mats 98-07
2 x Bulb Switch Light
3 x Drop in Sport Filter 9-5
2 x BSR 9-5 260Hp 2006-
6 x BSR Optiflow Intake V6 2.8t
3 x 9-3 / 900 Uprated Front ARB Bushings
1 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x BSR 9-5 2010-2011 V6 300Hp
2 x 9-5 Blend Flap Limit Lever 99-04
3 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
2 x Rear Camber Shims Kit 6pcs
2 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
2 x Front Camber Adjustment Bolts
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x 20th Viggen logo Shifter Top
1 x 9-5 Aero Sill Protection
1 x Downpipe Hardware Kit
1 x T7 Injector Spacer Kit
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Antenna Plug NG900/9-3 hatchback
3 x T7 3.5 Bar Fuel Pressure Regulator
1 x Turbo Conversion Pipe 900 9-3 T5
2 x Exhaust Clamp Kit
2 x Crush Sleeve F35 F25
1 x Midpipe 2.8T FWD (2wd)
1 x Remote Button NG900
2 x Forge Bypass Valve Cobalt/HHR TC
1 x Mass Airflow Meter T7
3 x Shifter Mount Kit Cobalt/ HHR
2 x Limit Strap Coilover Add On Kit
1 x Crank Vent Kit #6 T7 4cyl
1 x 9-3 ng900 Hood Protection Strip
1 x Griffin logo Shifter Top
1 x ARP Ring Gear Bolts F25/F35
1 x Rear Engine Mount 4cyl
1 x Transmission Nut F35 F25
1 x v6oilcoolplate
1 x Slave Cyl
1 x Aluminum Flywheel For NG900/9-3
2 x T7 Head Plug NGK
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Oil Filter Re-locator
1 x 9-3 ng900 radio wires
3 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
1 x ATF Saab 3309 (Automatic 02->)
4 x Rear Rotors PAIR 292mm XWD (Code: BC)
1 x Front Rotors PAIR 302mm Plain (Code: AB)
2 x Rear Rotors PAIR 292mm Plain (Code: BB)
2 x Saab black Keychain
2 x 9-5 Rear Brake rotor See Description
1 x 9-5 Wheel 5-Spoke Twin 17in
2 x Oil Cooler Adaptor B2X5
2 x Steering Coupler 9-3 99-02
1 x Injectors Siemens 60lb 630cc (set 4)
1 x Weld Bungs -Taper- Race Only
3 x PPC - Upgrade from stage 1 to stage 3
2 x Moog Ball Joint
2 x Injectors Green Giant 42lb (set 4)
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
2 x 9-3 SS Akebono Rear Pads
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Ceramic Low Dust Brake Pads 9-3 SS
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x Rear Brake Pads 9-3 SS
1 x Brembo Brake Kit 315mm 9-3 SS
2 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x Brembo Kit 315mm Hawk HPS Pads
1 x SCNA Christmas Calendar
3 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x Exhaust manifold Stud Kit
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x Machined Control Arm Kit
1 x IAT Weld Bung T5/Bosch
1 x 9-5 High Performance Brake Line Kit
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x 9-5 286mm REAR Brembo Disk (1) See Descr.
2 x MTF0063 Manual Gear oil
1 x PPC 3 Volvo Diagnostic System
1 x Cat back for Viggen 2.5in
1 x Basic Subframe Brace
3 x Shift Rod Bushings
1 x Troll Head Plug
1 x Floormats BSR 9-3SS/SC
2 x Optical Cable Connector (Onstar Delete)
1 x Oil Cap 9-3SS V6 "Griffin"
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
2 x Viggen Front Brake Disk Pair 308mm
2 x Rod Bearings only Pauter Rods
1 x Shifter Mount Kit 93ss
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
2 x 4340 Connecting Rods B204 B235
1 x Throttle Bend for T5 94-99
1 x 4 Cyl 2.0 Coolant Tank
1 x Sparkplugs 9-3SS
1 x Throttle Body T7
1 x Shifter Alignment Pins (Set 2)
1 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x Coreganizer
1 x Open Air Intake 9000 93-98
1 x Headbolts (New Style)
1 x Upgrade Valve Springs T5 Cars
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x Mat Set Textile Parchment 9-5 10-
$57,069.97
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail