$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x T7 Injector Spacer Kit
1 x Steering Rod Bushings NG900/93
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x Limit Strap Coilover Add On Kit
2 x Steering Coupler 9-3 99-02
2 x Rear spring perches Adjustable NG900/9-3
2 x SCNA Christmas Calendar
2 x Saab black Keychain
1 x Viggen Titanium KeyChain
1 x Griffin logo Shifter Top
1 x 20th Viggen logo Shifter Top
2 x 9-3 99-02,03 CV Antenna Adaptor
1 x Floormats BSR 9-3 99-02 900 94-98
1 x 9-3 Rear Ashtray
1 x 9-3 ng900 radio wires
1 x Adaptor Harness Handsfree 01-
1 x 9-3/NG900 Shift Knobs Leather
3 x Con Rods V6 2.8L 155.8mm
1 x Crush Sleeve F35 F25
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Downpipe Hardware Kit
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
2 x Flex Pipe 900 94-98 9-3 99-02
1 x Cat back for Viggen 2.5in
1 x Exhaust manifold Stud Kit
1 x Head Bolt Washers
2 x Head Stud Kit all 4cyl
3 x T7 3.5 Bar Fuel Pressure Regulator
1 x ARP Exhaust Manifold Stud kit Stainless
2 x Turbo Conversion Pipe 900 9-3 T5
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x 9-3 / 900 Uprated Front ARB Bushings
3 x PPC - Upgrade from stage 1 to stage 3
1 x Custom Brake Lines RR 300mm Kit
1 x Basic Subframe Brace
1 x Shift Rod Bushings
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x Mat Set Textile Parchment 9-5 10-
2 x Fog light 9-3 Right 99-00
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Injectors Siemens 80lb 875cc (set 4)
1 x Universal / Special Request
1 x IAT Weld Bung T5/Bosch
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Shifter Alignment Pins (Set 2)
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x MTF0063 Manual Gear oil
2 x Antenna Plug NG900/9-3 hatchback
2 x 9-3 /NG900 Grille
4 x Clear Little Fender Blinkers Factory Saab
2 x 9-3 ng900 Hood Protection Strip
1 x T7 Head Plug NGK
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x JE Piston Rings 90.0mm 235/205
1 x Viggen Fog Air Intake
1 x Replacement V6 Coolant Cap
1 x Filter 9-5 Cabin Air
1 x ARP Ring Gear Bolts F25/F35
1 x c900 Performance Brake lines
1 x Machined Control Arm Kit
1 x Moog Ball Joint
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x v6oilcoolplate
1 x Turbo to Downpipe Flange B207
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Exhaust Clamp Kit
1 x Fuel Pressure Regulator 4.0 bar
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Weld Bungs -Taper- Race Only
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x ATF Saab 3309 (Automatic 02->)
$12,793.33
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail