$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x T5 3.0 Bar Map Sensor Adaptor
1 x IAT Weld Bung T5/Bosch
2 x Injectors Siemens 80lb 875cc (set 4)
2 x Head Bolt Washers
3 x AEM Wideband Gauge Kit
2 x Universal / Special Request
2 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
4 x Injectors Siemens 60lb 630cc (set 4)
4 x Rivetnuts Pair (2pcs)
3 x PPC - Upgrade from stage 1 to stage 3
3 x MTF0063 Manual Gear oil
2 x K&N Filter Service Kit
1 x Viggen Titanium KeyChain
2 x Shifter Alignment Pins (Set 2)
1 x Con Rods V6 2.8L 155.8mm
1 x 9000 Shifter Bushing Repair Kit
3 x 9-5 Aero Sill Protection
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x 9-5 Shift Knobs Leather
2 x 9-5 Textile Mats 98-07
1 x 9-5 Rear Brake rotor See Description
1 x 9-3 ng900 Hood Protection Strip
3 x Air Filter 06 version (All 9-5)
2 x Antenna Plug NG900/9-3 hatchback
1 x Aero Clutch Kit 9-5
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x 9-5 Wheel 10-Spoke 16in.
1 x 9-3 /NG900 Grille
1 x 9-5 Open Air Prefilter
1 x Coolant Bypass Valve 9-5
1 x 9-5 Blend Flap Limit Lever 99-04
3 x Fuel Line Clip
3 x Mass Airflow Meter T7
3 x Intake Flange B2x4 T5
1 x 9-5 Exhaust Flex Pipe Stainless
4 x Genuine Saab 4cyl Oil Filters
2 x Fuel Pressure Regulator 4.0 bar
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x Slave Cyl
1 x Shift Rod Bushings
3 x Weld Bungs -Taper- Race Only
2 x Cigarette Lighter
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
3 x Injectors Green Giant 42lb (set 4)
1 x 9-5 Intercooler ETS
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Rear Camber Shims Kit 6pcs
1 x Aluminum Flywheel For NG900/9-3
1 x Flex Pipe 900 94-98 9-3 99-02
1 x Replacement Filter for Open air 9-3 T7
1 x Clear Little Fender Blinkers Factory Saab
1 x Direct Ignition T7 Black
1 x Rear Engine Mount 4cyl
2 x Crank Vent Kit #6 T7 4cyl
1 x Replacement Hardware Pack 6-Point
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x c900 Performance Brake lines
1 x Downpipe Hardware Kit
1 x Remote Button NG900
1 x Crush Sleeve F35 F25
1 x ShortShift Kit 93ss
1 x Shifter Mount Kit 93ss
1 x ATF Saab 3309 (Automatic 02->)
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x BSR 9-5 260Hp 2006-
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Replacement V6 Coolant Cap
1 x Custom Brake Lines RR 300mm Kit
2 x Headlight Bulb H7 Longer Life
2 x Turbo Bypass Valve
1 x Valve Cover Gasket Set 4cyl
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x 9-5 286mm REAR Brembo Disk (1) See Descr.
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Rear Rotors PAIR 292mm XWD (Code: BC)
2 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Head Stud Kit all 4cyl
1 x Mat Set Black Rubber 9-5 10-
1 x Mat Set Textile Jet Black 9-5 10-
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Mat Set Textile Parchment 9-5 10-
1 x Hood Emblem 9-3 SS/sc 03- All
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x B207 Upper Radiator Coolant T
$15,818.00
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail