$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
4 x Forge Bypass Valve Cobalt/HHR TC
1 x Oil Cap GM "HHR"
5 x 9000 High Performance Brake Line Kit '95-'98
4 x Cat Back Exh for 9000 CS, CSE AERO
3 x ARP Exhaust Manifold Stud kit Stainless
5 x Crush Sleeve F35 F25
3 x Injectors Green Giant 42lb (set 4)
2 x Exhaust manifold Stud Kit
2 x Shift Rod Bushings
1 x ShortShift Kit 93ss
2 x BBS Center Cap for 9-2x RK small caps
2 x Antenna Plug NG900/9-3 hatchback
2 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x 9-5 Shift Knobs Leather
2 x ATF Saab 3309 (Automatic 02->)
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
3 x 9-5 Aero Sill Protection
2 x 9-3/NG900 Shift Knobs Leather
1 x 9-5 Rear Brake rotor See Description
2 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-3 ng900 Hood Protection Strip
1 x 9-3 /NG900 Grille
3 x SCNA Christmas Calendar
1 x Optical Cable Connector (Onstar Delete)
1 x Con Rods V6 2.8L 155.8mm
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
3 x Adaptor Harness Handsfree 01-
1 x Injectors 175hp Stg3 (Set4)
1 x B207 Coolant Cap
1 x Midpipe 2.8T XWD (4wd)
1 x Metal Steering Wheel Buttons
3 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
2 x BSR Optiflow Intake 4cyl w SAI
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
3 x V6 Tank Float - SparePart
2 x B207 Upper Radiator Coolant T
2 x 3 Point Hardware
2 x Replacement V6 Coolant Cap
1 x Floormats BSR 9-3SS/SC
1 x Downpipe 2.8T XWD (4wd)
2 x Basic Subframe Brace
1 x Downpipe 2.8T FWD (2wd)
4 x Sparkplugs 9-3SS
1 x BSR Optiflow Intake V6 2.8t
2 x Hood Emblem 9-3 SS/sc 03- All
1 x Midpipe 2.8T FWD (2wd)
1 x Headlight Connector Repair Kit 9-3SS 9-5
2 x Saab black Keychain
2 x Coreganizer
3 x Midpipe 2.0T 07-11 FWD (2wd)
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Ignition Coil 9-3SS 2.0t and 2.0T
4 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Head Stud Kit all 4cyl
2 x 9-5 Wheel 10-Spoke 16in.
1 x Headbolts (New Style)
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Headlight Bulb H7 Longer Life
2 x 9-5 Open Air Prefilter
1 x Mass Airflow Meter T7
2 x Downpipe Hardware Kit
1 x Fuel Line Clip
1 x Oil Pressure Switch
1 x Coolant Bypass Valve 9-5
2 x 9-5 Blend Flap Limit Lever 99-04
1 x Air Filter 06 version (All 9-5)
2 x Filter 9-5 Cabin Air
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x 9-5 Intercooler ETS
1 x BSR 9-5 260Hp 2006-
2 x Hood Emblem 9-5 All
2 x Slave Cyl
1 x T7 Injector Spacer Kit
2 x Sport Transmission Mount 9-5 (Manual) 1998-1999
2 x Spec Light Flywheel For 9-5 4cyl 99-09
4 x T7 3.5 Bar Fuel Pressure Regulator
1 x Aero Clutch Kit 9-5
2 x Clear Little Fender Blinkers Factory Saab
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
2 x 20th Viggen logo Shifter Top
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x 9000 Shifter Bushing Repair Kit
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Rear Engine Mount 4cyl
1 x Rear spring perches Adjustable NG900/9-3
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Genuine Saab 4cyl Oil Filters
8 x Open Air Intake 9000 93-98
2 x 9-3 Rear Ashtray
2 x Rivetnuts Pair (2pcs)
3 x 9-3 99-02,03 CV Antenna Adaptor
2 x MTF0063 Manual Gear oil
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
2 x BSR Optiflow Intake 4cyl
1 x Goodridge Brake Lines 9-3 SS / SC 03-
2 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Rear Brake Pads 9-3 SS
1 x Remote Button NG900
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
1 x Brake Vac pump seals
1 x v6 2.8t SAI Delete Kit
3 x Oil Cap 9-3SS V6 "Griffin"
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
2 x Viggen Front Brake Disk Pair 308mm
1 x Front Camber Adjustment Bolts
1 x Cigarette Lighter
2 x Front Brake Pads 9-5 9-3 900 LOW DUST
2 x Rear Rotors PAIR 292mm XWD (Code: BC)
1 x Rear Pedestal Spoiler 9-3 SS
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Viggen Clutch Kit 99-02
1 x Valve Cover Gasket Set 4cyl
1 x Rear Brake Pads 9-5 Later Style
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
3 x Steering Rod Bushings NG900/93
1 x Oil Cap 9-3SS "Ghost"
2 x Shifter Top Ghost Logo
1 x 9000 Intercooler ETS
1 x BSR 9-5 3.0T V6 200Hp
1 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
1 x AEM Wideband Gauge Kit
1 x Griffin logo Shifter Top
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x Shifter Mount Kit Cobalt/ HHR
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Steering Coupler 9-3 99-02
1 x Universal / Special Request
1 x Floormats BSR 9-3 99-02 900 94-98
1 x Fuel Pressure Regulator 4.0 bar
1 x Drop in Sport Filter 9-5
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Upgrade Valve Springs T5 Cars
1 x 9-3 SS Akebono Rear Pads
1 x Bulb Switch Light
$31,864.28
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail