$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x Intake Flange B2x4 T5
4 x Moog Ball Joint
2 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
2 x Injectors Siemens 60lb 630cc (set 4)
3 x T5 3.0 Bar Map Sensor Adaptor
4 x Header Flange Stainless Blended Transition B2x4,B2x5
4 x Map/MAT sensor weld bung
2 x Clear Little Fender Blinkers Factory Saab
2 x ATF Saab 3309 (Automatic 02->)
2 x MTF0063 Manual Gear oil
3 x 9-5 Wheel 10-Spoke 16in.
1 x Shifter Alignment Pins (Set 2)
1 x "Griffin" Valve stem caps
1 x K&N Filter Service Kit
2 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x BSR 9-5 2010-2011 V6 300Hp
2 x Floormats BSR 9-3SS/SC
1 x Metal Steering Wheel Buttons
1 x 9-5 Textile Mats 98-07
1 x 20th Viggen logo Shifter Top
2 x Front Camber Adjustment Bolts
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x Shifter Mount Kit 93ss
2 x Torque Mount Insert V6 Manual (XWD and FWD)
2 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x 9-5 Blend Flap Limit Lever 99-04
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x Headlight Connector Repair Kit 9-3SS 9-5
2 x Optical Cable Connector (Onstar Delete)
1 x V6 Tank Float - SparePart
2 x 9000 High Performance Brake Line Kit '95-'98
2 x Brake Vac pump seals
1 x Cat Back Exh for 9000 CS, CSE AERO
2 x 3 Point Hardware
1 x 9000 Intercooler ETS
1 x Replacement V6 Coolant Cap
1 x Hood Emblem 9-3 SS/sc 03- All
4 x ARP Exhaust Manifold Stud kit Stainless
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x Open Air Intake 9000 93-98
5 x BSR Optiflow Intake 4cyl
2 x 9000 Shifter Bushing Repair Kit
2 x Sparkplugs 9-3SS
3 x Crush Sleeve F35 F25
2 x Exhaust manifold Stud Kit
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x B207 Upper Radiator Coolant T
4 x Shift Rod Bushings
1 x B207 Coolant Cap
1 x Downpipe 2.8T FWD (2wd)
1 x Injectors 175hp Stg3 (Set4)
2 x IAT Weld Bung T5/Bosch
1 x BSR Optiflow Intake V6 2.8t
1 x Midpipe 2.8T FWD (2wd)
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
3 x Weld Bungs -Taper- Race Only
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Downpipe 2.8T XWD (4wd)
1 x Con Rods V6 2.8L 155.8mm
2 x Universal / Special Request
2 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
2 x Injectors Siemens 80lb 875cc (set 4)
1 x Rivetnuts Pair (2pcs)
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Injectors Green Giant 42lb (set 4)
2 x Midpipe 2.0T 07-11 FWD (2wd)
2 x Mat Set Black Rubber 9-5 10-
1 x Mat Set Textile Parchment 9-5 10-
3 x Shifter Mount Kit Cobalt/ HHR
2 x Forge Bypass Valve Cobalt/HHR TC
3 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Slave Cyl
1 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x Replacement Hardware Pack 6-Point
1 x Oil Filter Re-locator
1 x Remote Button NG900
1 x 4340 Connecting Rods B204 B235
1 x Rod Bearings only Pauter Rods
1 x Fog light Replacement Panels
1 x Mat Set Textile Shark Grey 9-5 10-
2 x Oil Cap GM "HHR"
2 x Short Shifter HHR Cobalt F35 F40
1 x Ceramic Low Dust Brake Pads 9-3 SS
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x Valve Cover Gasket Set 4cyl
1 x Adaptor Harness Handsfree 01-
1 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Fog light 9-3 left 99-00
1 x Rear Pedestal Spoiler 9-3 SS
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x Coreganizer
1 x Cigarette Lighter
1 x SCNA Christmas Calendar
1 x Turbo Conversion Pipe 900 9-3 T5
1 x v6oilcoolplate
1 x Transmission Nut F35 F25
1 x Shifter Top Ghost Logo
1 x Steering Rod Bushings NG900/93
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x Custom Brake Lines RR 300mm Kit
1 x Viggen Front Brake Disk Pair 308mm
1 x Oil Cap 9-3SS "Ghost"
1 x BSR Optiflow Intake 4cyl w SAI
1 x v6 2.8t SAI Delete Kit
2 x PPC - Upgrade from stage 1 to stage 3
1 x Downpipe Hardware Kit
1 x Front Camber Adjustment Bolts
1 x Rear Camber Shims Kit 6pcs
1 x T7 Head Plug NGK
1 x Fuel Line Clip
1 x 9-5 High Performance Brake Line Kit
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
2 x Headlight Bulb H7 Longer Life
1 x Mass Airflow Meter T7
2 x 9-3 /NG900 Grille
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Steering Coupler 9-3 99-02
1 x AEM Wideband Gauge Kit
2 x 9-5 Rear Brake rotor See Description
1 x 9-5 286mm REAR Brembo Disk (1) See Descr.
1 x 9-5 Shift Knobs Leather
1 x Aero Clutch Kit 9-5
1 x Mat Set Textile Jet Black 9-5 10-
1 x Bulb Switch Light
$30,779.72
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail