$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Viggen Titanium KeyChain
3 x SCNA Christmas Calendar
1 x Replacement V6 Coolant Cap
2 x T7 Head Plug NGK
2 x 9000 Shifter Bushing Repair Kit
1 x B207 Coolant Cap
1 x Con Rods V6 2.8L 155.8mm
1 x Limit Strap Coilover Add On Kit
1 x Injectors Siemens 80lb 875cc (set 4)
1 x Intake Flange B2x4 T5
1 x Fuel Pressure Regulator 4.0 bar
1 x PPC - Upgrade from stage 1 to stage 3
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
3 x 9-5 Aero Sill Protection
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Transmission Nut F35 F25
2 x Rear Camber Shims Kit 6pcs
2 x Rear Engine Mount 4cyl
1 x Shifter Top Ghost Logo
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x 4340 Connecting Rods B204 B235
2 x ARP Exhaust Manifold Stud kit Stainless
1 x Balance Shaft Tensioner Delete
2 x Headbolts (New Style)
1 x ARP Ring Gear Bolts F25/F35
1 x Slave Cyl
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x Oil Filter Re-locator
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Flywheel Twin Disk 7.25in B2xx
1 x Exhaust Clamp Kit
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Head Stud Kit all 4cyl
1 x Rod Bearings only Pauter Rods
1 x Cat back for Viggen 2.5in
1 x JE Piston Rings 90.0mm 235/205
1 x Replacement Flywheel Insert NG900/9-3
1 x Machined Control Arm Kit
1 x Steering Coupler 9-3 99-02
2 x Shift Rod Bushings
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Aluminum Flywheel For NG900/9-3
1 x Steering Rod Bushings NG900/93
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Flex Pipe 900 94-98 9-3 99-02
1 x Front Camber Adjustment Bolts
1 x Drop in Sport Filter 9-5
1 x Fog light Replacement Panels
1 x 9-3 / 900 Uprated Front ARB Bushings
3 x Crush Sleeve F35 F25
1 x Fog light 9-3 Right 99-00
1 x Coreganizer
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Fog light 9-3 left 99-00
1 x Replacement Hardware Pack 6-Point
1 x Griffin logo Shifter Top
1 x Fuel Line Clip
1 x Direct Ignition T7 Black
3 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Remote Button NG900
1 x T7 Injector Spacer Kit
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x 9-3 ng900 radio wires
1 x 20th Viggen logo Shifter Top
1 x 9-3 Rear Ashtray
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x Turbo Conversion Pipe 900 9-3 T5
1 x 9-5 Intercooler ETS
1 x 9-3 /NG900 Grille
1 x Filter 9-5 Cabin Air
1 x Cigarette Lighter
2 x Air Filter 06 version (All 9-5)
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Mass Airflow Meter T7
1 x Cabin Vent Fan
1 x Floormats BSR 9-5
1 x Genuine Saab 4cyl Oil Filters
1 x Aero Clutch Kit 9-5
1 x Fog light Replacement Panels 99-01
1 x 9-5 Exhaust Flex Pipe Stainless
1 x v6 header flange
1 x Moog Ball Joint
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x IAT Weld Bung T5/Bosch
1 x Saab black Keychain
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x Basic Subframe Brace
2 x PPC 3 Volvo Diagnostic System
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
$16,515.37
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail