$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
4 x Clear Little Fender Blinkers Factory Saab
1 x c900 Performance Brake lines
1 x Rear Pedestal Spoiler 9-3 SS
3 x Torque Mount Insert V6 Manual (XWD and FWD)
3 x Saab black Keychain
4 x Sparkplugs 9-3SS
4 x Ignition Coil 9-3SS 2.8t and 2.8T
2 x 3 Point Hardware
5 x Replacement V6 Coolant Cap
2 x Hood Emblem 9-3 SS/sc 03- All
2 x Aero Clutch Kit 9-5
2 x 9-5 Wheel 10-Spoke 16in.
1 x 9-3 /NG900 Grille
4 x 9-5 Aero Sill Protection
1 x 9-3 ng900 Hood Protection Strip
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x ATF Saab 3309 (Automatic 02->)
2 x Antenna Plug NG900/9-3 hatchback
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x "Griffin" Valve stem caps
2 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x Oil Cap GM "HHR"
1 x Forge Bypass Valve Cobalt/HHR TC
2 x Downpipe 2.8T XWD (4wd)
1 x Rivetnuts Pair (2pcs)
1 x Injectors Siemens 60lb 630cc (set 4)
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x AEM Wideband Gauge Kit
1 x Intake Flange B2x4 T5
1 x IAT Weld Bung T5/Bosch
2 x Header Flange Stainless Blended Transition B2x4,B2x5
2 x Injectors Green Giant 42lb (set 4)
2 x Troll Head Plug
2 x B207 Coolant Cap
1 x MTF0063 Manual Gear oil
2 x SCNA Christmas Calendar
2 x ShortShift Kit 93ss
1 x Front Camber Adjustment Bolts
1 x BSR 9-5 2010-2011 V6 300Hp
4 x Shift Rod Bushings
1 x Oil Cap 9-3SS V6 "Ghost"
2 x Mat Set Black Rubber 9-5 10-
2 x Mat Set Textile Parchment 9-5 10-
1 x Oil Cap 9-3SS V6 "Griffin"
2 x Mat Set Textile Shark Grey 9-5 10-
3 x Rear Camber Shims Kit 6pcs
1 x 9-3 SS Akebono Rear Pads
1 x 9-5 Open Air Prefilter
3 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
1 x BSR 9-5 260Hp 2006-
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Headbolts (New Style)
2 x Headlight Bulb H7 Longer Life
1 x Coreganizer
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
3 x T7 3.5 Bar Fuel Pressure Regulator
1 x Transmission Nut F35 F25
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Rear Rotors PAIR 292mm Plain (Code: BB)
3 x Custom Brake Lines Brembo 315mm 9-3SS/SC
4 x Headlight Connector Repair Kit 9-3SS 9-5
3 x Goodridge Brake Lines 9-3 SS / SC 03-
2 x 9-5 Blend Flap Limit Lever 99-04
3 x Ceramic Low Dust Brake Pads 9-3 SS
2 x Slave Cyl
2 x Sport Transmission Mount 9-5 (Manual) 1998-1999
2 x Rear Rotors PAIR 292mm XWD (Code: BC)
2 x Exhaust manifold Stud Kit
1 x Crush Sleeve F35 F25
1 x Filter 9-5 Cabin Air
1 x Spec Light Flywheel For 9-5 4cyl 99-09
2 x Oil Pressure Switch
1 x ARP Exhaust Manifold Stud kit Stainless
2 x 9-5 Shift Knobs Leather
2 x Coolant Bypass Valve 9-5
1 x Hood Emblem 9-5 All
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x Brembo Brake Kit 315mm 9-3 SS
2 x Fog light Replacement Panels 99-01
1 x Head Stud Kit all 4cyl
1 x Basic Subframe Brace
1 x 9-3 / 900 Uprated Front ARB Bushings
2 x Brembo Kit 315mm Hawk HPS Pads
1 x Rear spring perches Adjustable NG900/9-3
1 x Steering Coupler 9-3 99-02
1 x Steering Rod Bushings NG900/93
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
2 x Exhaust Clamp Kit
1 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x Machined Control Arm Kit
1 x Midpipe 2.0T 07-11 FWD (2wd)
4 x Genuine Saab 4cyl Oil Filters
2 x Aluminum Flywheel For NG900/9-3
1 x 20th Viggen logo Shifter Top
2 x Ignition Coil 9-3SS 2.0t and 2.0T
2 x Replacement Flywheel Insert NG900/9-3
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Oil Cooler Adaptor B2X5
1 x Viggen Fog Air Intake
2 x 9-3 900 9-5 REAR Brembo Disk See Descr.
2 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
1 x Limit Strap Coilover Add On Kit
1 x BSR 9-5 3.0T V6 200Hp
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
2 x Drop in Sport Filter 9-5
2 x Bulb Switch Light
2 x Front Rotors PAIR 302mm Plain (Code: AB)
2 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x Front Camber Adjustment Bolts
2 x Rear Brake Pads 9-3 SS
1 x Adaptor Harness Handsfree 01-
3 x Air Filter 06 version (All 9-5)
3 x Crank Vent Kit #6 T7 4cyl
2 x V6 Tank Float - SparePart
1 x PPC - Upgrade from stage 1 to stage 3
1 x Floormats BSR 9-5
1 x Cabin Vent Fan
2 x 9-5 Intercooler ETS
2 x Mass Airflow Meter T7
3 x Fuel Line Clip
1 x T7 Injector Spacer Kit
3 x 9-5 Textile Mats 98-07
2 x Rear Rotors PAIR 278mm Plain (Code: BA)
2 x Cigarette Lighter
2 x Direct Ignition T7 Black
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
2 x 9-5 Exhaust Flex Pipe Stainless
3 x Downpipe Hardware Kit
1 x Injectors Siemens 80lb 875cc (set 4)
1 x Moog Ball Joint
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
2 x Custom Brake Lines RR 300mm Kit
1 x 9000 High Performance Brake Line Kit '95-'98
4 x Shifter Mount Kit 93ss
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x 9-3 Rear Ashtray
1 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x Fuel Pressure Regulator 4.0 bar
1 x 9-5 Rear Brake rotor See Description
1 x Viggen Clutch Kit 99-02
2 x Rear Engine Mount 4cyl
1 x BSR Optiflow Intake V6 2.8t
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x 9-5 High Performance Brake Line Kit
1 x 4 Cyl 2.0 Coolant Tank
1 x Turbo Bypass Valve
1 x BSR Optiflow Intake 4cyl
1 x Griffin logo Shifter Top
2 x Optical Cable Connector (Onstar Delete)
1 x Fog light 9-3 Right 99-00
1 x Injectors 175hp Stg3 (Set4)
1 x Replacement Hardware Pack 6-Point
1 x Replacement Filter for Open air 9-3 T7
1 x 9000 Intercooler ETS
$36,780.65
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail