$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x Con Rods V6 2.8L 155.8mm
3 x Moog Ball Joint
4 x Sport Transmission Mount 9-3/900 (Automatic)
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x ARP Ring Gear Bolts F25/F35
3 x SCNA Christmas Calendar
2 x Rear Camber Shims Kit 6pcs
2 x Machined Control Arm Kit
2 x PPC 3 Volvo Diagnostic System
1 x Antenna Plug NG900/9-3 hatchback
2 x PPC - Upgrade from stage 1 to stage 3
2 x Map/MAT sensor weld bung
1 x 9-3 ng900 Hood Protection Strip
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x Universal / Special Request
2 x Injectors Siemens 80lb 875cc (set 4)
2 x Header Flange Stainless Blended Transition B2x4,B2x5
2 x Intake Flange B2x4 T5
1 x Fog light Replacement Panels
2 x IAT Weld Bung T5/Bosch
2 x 9-3 /NG900 Grille
1 x Fog light 9-3 Right 99-00
1 x Rivetnuts Pair (2pcs)
2 x Fuel Pressure Regulator 4.0 bar
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Fog light 9-3 left 99-00
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Head Bolt Washers
1 x Injectors Siemens 60lb 630cc (set 4)
2 x Clear Little Fender Blinkers Factory Saab
2 x Oil Cap 9-3SS "Ghost"
1 x Balance Shaft Tensioner Delete
1 x Throttle Bend for T5 94-99
1 x Head Stud Kit all 4cyl
3 x Oil Filter Re-locator
1 x Headbolts (New Style)
1 x T7 Injector Spacer Kit
1 x T7 Head Plug NGK
1 x Troll Head Plug
1 x B207 Coolant Cap
1 x Shifter Mount Kit Cobalt/ HHR
1 x Oil Cap GM "HHR"
1 x 20th Viggen logo Shifter Top
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x 9-5 Blend Flap Limit Lever 99-04
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Forge Bypass Valve Cobalt/HHR TC
1 x Short Shifter HHR Cobalt F35 F40
1 x Flex Pipe 900 94-98 9-3 99-02
2 x MTF0063 Manual Gear oil
1 x Exhaust Clamp Kit
1 x ATF Saab 3309 (Automatic 02->)
1 x B207 Upper Radiator Coolant T
1 x BSR Optiflow Intake 4cyl
1 x Downpipe 2.8T XWD (4wd)
2 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Downpipe 2.8T FWD (2wd)
1 x Adaptor Harness Handsfree 01-
2 x BBS Center Cap for 9-2x RK small caps
2 x Viggen Clutch Kit 99-02
1 x Saab black Keychain
1 x Rear Engine Mount 4cyl
1 x Aluminum Flywheel For NG900/9-3
2 x Flywheel Twin Disk 7.25in B2xx
1 x Slave Cyl
2 x Replacement Flywheel Insert NG900/9-3
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x Steering Rod Bushings NG900/93
1 x Rear spring perches Adjustable NG900/9-3
1 x Steering Coupler 9-3 99-02
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Mat Set Textile Parchment 9-5 10-
2 x 9-5 Wheel 10-Spoke 16in.
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Mat Set Black Rubber 9-5 10-
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-5 Aero Sill Protection
1 x Fog light Replacement Panels 99-01
1 x 9-5 Intercooler ETS
1 x Mass Airflow Meter T7
1 x BSR 9-5 260Hp 2006-
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Fuel Line Clip
1 x Direct Ignition T7 Black
1 x Turbo to Downpipe Flange B207
1 x v6oilcoolplate
1 x Midpipe 2.8T XWD (4wd)
1 x Shift Rod Bushings
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
2 x Alu Hybrid Flywheel For NG900/9-3
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Quaife Differential 9-5 and Viggen (F35)
1 x ARP Exhaust Manifold Stud kit Stainless
1 x Spec Light Flywheel For 9-5 4cyl 99-09
$21,454.64
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail