$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Limit Strap Coilover Add On Kit
2 x Forge Bypass Valve Cobalt/HHR TC
1 x SCNA Christmas Calendar
1 x Troll Head Plug
3 x Replacement V6 Coolant Cap
1 x Oil Cap GM "HHR"
1 x Short Shifter HHR Cobalt F35 F40
1 x B207 Coolant Cap
1 x Shifter Mount Kit Cobalt/ HHR
1 x 9000 Shifter Bushing Repair Kit
1 x 4 Cyl 2.0 Coolant Tank
2 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Optical Cable Connector (Onstar Delete)
3 x V6 Tank Float - SparePart
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x 3 Point Hardware
1 x Ignition Coil 9-3SS 2.0t and 2.0T
2 x Brake Vac pump seals
2 x Sparkplugs 9-3SS
1 x B207 Upper Radiator Coolant T
1 x Shift Rod Bushings
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x T7 Injector Spacer Kit
2 x Throttle Bend for T5 94-99
1 x Viggen Fog Air Intake
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Downpipe 2.8T XWD (4wd)
2 x Hood Emblem 9-3 SS/sc 03- All
3 x Shifter Alignment Pins (Set 2)
1 x Header Flange Stainless Blended Transition B2x4,B2x5
2 x Rear Camber Shims Kit 6pcs
2 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x 9-5 Aero Sill Protection
1 x BSR 9-5 3.0T V6 200Hp
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Oil Cooler Adaptor B2X5
1 x MTF0063 Manual Gear oil
1 x PPC 3 Volvo Diagnostic System
1 x Viggen Front Brake Disk Pair 308mm
2 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x K&N Filter Service Kit
1 x ATF Saab 3309 (Automatic 02->)
1 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x Coreganizer
1 x Fog light 9-3 Right 99-00
1 x Clear Little Fender Blinkers Factory Saab
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x Ceramic Low Dust Brake Pads 9-3 SS
1 x Moog Ball Joint
1 x 9-3 SS Akebono Rear Pads
1 x Rivetnuts Pair (2pcs)
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x Upgrade Valve Springs T5 Cars
1 x Filter 9-5 Cabin Air
1 x 9-5 Open Air Prefilter
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Downpipe Hardware Kit
1 x Aero Clutch Kit 9-5
$8,805.15
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail