$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x Shifter Mount Kit Cobalt/ HHR
5 x Short Shifter HHR Cobalt F35 F40
1 x Shifter Alignment Pins (Set 2)
1 x Con Rods V6 2.8L 155.8mm
1 x Troll Head Plug
1 x 9000 Shifter Bushing Repair Kit
1 x SCNA Christmas Calendar
1 x MTF0063 Manual Gear oil
1 x Replacement V6 Coolant Cap
1 x K&N Filter Service Kit
2 x ATF Saab 3309 (Automatic 02->)
1 x T7 Head Plug NGK
1 x Limit Strap Coilover Add On Kit
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Griffin logo Shifter Top
1 x PPC - Upgrade from stage 1 to stage 3
1 x Shifter Top Ghost Logo
1 x Direct Ignition T5 RED
1 x 4340 Connecting Rods B204 B235
2 x Oil Filter Re-locator
3 x Exhaust Clamp Kit
3 x Genuine Saab 4cyl Oil Filters
1 x Mass Airflow Meter T7
2 x Fuel Line Clip
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Headbolts (New Style)
1 x Replacement Flywheel Insert NG900/9-3
2 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Flywheel Twin Disk 7.25in B2xx
1 x JE Piston Rings 90.0mm 235/205
1 x Turbo Conversion Pipe 900 9-3 T5
2 x Antenna Plug NG900/9-3 hatchback
1 x Fog light 9-3 left 99-00
1 x Cat back for Viggen 2.5in
1 x Exhaust manifold Stud Kit
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Fog light 9-3 Right 99-00
1 x 9-3 ng900 Hood Protection Strip
2 x ARP Exhaust Manifold Stud kit Stainless
1 x 9-3 /NG900 Grille
2 x Flex Pipe 900 94-98 9-3 99-02
1 x Fog light Replacement Panels
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
3 x Oil Cap GM "HHR"
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x 9-5 Shift Knobs Leather
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x c900 Performance Brake lines
1 x 9-5 Rear Brake rotor See Description
1 x Air Filter 06 version (All 9-5)
1 x 9-3/NG900 Shift Knobs Leather
2 x Clear Little Fender Blinkers Factory Saab
1 x Aero Clutch Kit 9-5
1 x IAT Weld Bung T5/Bosch
1 x Rear Camber Shims Kit 6pcs
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x 9-3 ng900 radio wires
2 x 20th Viggen logo Shifter Top
1 x Adaptor Harness Handsfree 01-
2 x 9-3 Rear Ashtray
1 x B207 Upper Radiator Coolant T
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Oil Cap 9-3SS "Ghost"
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Throttle Bend for T5 94-99
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x Head Stud Kit all 4cyl
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
2 x Custom Brake Lines RR 300mm Kit
1 x Upgrade Valve Springs T5 Cars
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x 9-5 Open Air Prefilter
1 x Mat Set Textile Jet Black 9-5 10-
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Forge Bypass Valve Cobalt/HHR TC
1 x Oil Cooler Adaptor B2X5
$11,890.91
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail