$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Replacement V6 Coolant Cap
2 x SCNA Christmas Calendar
1 x 3 Point Hardware
1 x Con Rods V6 2.8L 155.8mm
1 x 9000 Shifter Bushing Repair Kit
2 x Moog Ball Joint
2 x c900 Performance Brake lines
2 x Clear Little Fender Blinkers Factory Saab
2 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x MTF0063 Manual Gear oil
1 x Spec Light Flywheel For 9-5 4cyl 99-09
2 x Rear Camber Shims Kit 6pcs
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Shift Rod Bushings
1 x Slave Cyl
1 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x PPC - Upgrade from stage 1 to stage 3
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x BSR 9-5 260Hp 2006-
1 x 9-5 Aero Sill Protection
1 x Hood Emblem 9-5 All
1 x Crush Sleeve F35 F25
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x 20th Viggen logo Shifter Top
1 x Head Stud Kit all 4cyl
1 x Front Camber Adjustment Bolts
2 x B207 Upper Radiator Coolant T
1 x 9-3 ng900 radio wires
1 x Machined Control Arm Kit
1 x Head Bolt Washers
1 x Mat Set Textile Jet Black 9-5 10-
2 x Alu Hybrid Flywheel For NG900/9-3
1 x Rear Engine Mount 4cyl
1 x Flywheel Twin Disk 7.25in B2xx
1 x Shifter Top Ghost Logo
1 x Aluminum Flywheel For NG900/9-3
2 x ARP Ring Gear Bolts F25/F35
1 x Floormats BSR 9-3SS/SC
1 x Oil Cap 9-3SS V6 "Griffin"
1 x 9-5 286mm REAR Brembo Disk (1) See Descr.
1 x Cat Back Exh for 9000 CS, CSE AERO
2 x BBS Center Cap for 9-2x RK small caps
1 x 9-5 High Performance Brake Line Kit
1 x 9000 High Performance Brake Line Kit '95-'98
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x Front Camber Adjustment Bolts
1 x Viggen Clutch Kit 99-02
1 x Brembo Brake Kit 315mm 9-3 SS
1 x Front Rotors PAIR 302mm Plain (Code: AB)
$11,278.17
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail