$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x IAT Weld Bung T5/Bosch
2 x SCNA Christmas Calendar
1 x AEM Wideband Gauge Kit
3 x Header Flange Stainless Blended Transition B2x4,B2x5
3 x Clear Little Fender Blinkers Factory Saab
1 x 9-5 Aero Sill Protection
2 x c900 Performance Brake lines
2 x Basic Subframe Brace
1 x BBS Center Cap for 9-2x RK small caps
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-5 Wheel 10-Spoke 16in.
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Rear Engine Mount 4cyl
2 x Quaife Differential 9-5 and Viggen (F35)
1 x Rear spring perches Adjustable NG900/9-3
1 x Rear Camber Shims Kit 6pcs
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Replacement Flywheel Insert NG900/9-3
2 x Viggen Fog Air Intake
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Aluminum Flywheel For NG900/9-3
1 x Fog light Replacement Panels
1 x JE Piston Rings 90.0mm 235/205
2 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Steering Coupler 9-3 99-02
1 x Crank Vent Kit #6 T7 4cyl
1 x Cat back for Viggen 2.5in
1 x Oil Filter Re-locator
1 x Limit Strap Coilover Add On Kit
1 x 4340 Connecting Rods B204 B235
1 x ARP Exhaust Manifold Stud kit Stainless
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x Exhaust Clamp Kit
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x 9-3 99-02,03 CV Antenna Adaptor
2 x Flex Pipe 900 94-98 9-3 99-02
2 x 9-3 / 900 Uprated Front ARB Bushings
2 x Rear Pedestal Spoiler 9-3 SS
1 x Coreganizer
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Downpipe 2.8T XWD (4wd)
2 x Injectors 175hp Stg3 (Set4)
1 x Hood Emblem 9-3 SS/sc 03- All
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x Sparkplugs 9-3SS
1 x ShortShift Kit 93ss
1 x 3 Point Hardware
2 x Ignition Coil 9-3SS 2.8t and 2.8T
4 x PPC - Upgrade from stage 1 to stage 3
2 x Front Camber Adjustment Bolts
1 x Optical Cable Connector (Onstar Delete)
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x V6 Tank Float - SparePart
2 x BSR Optiflow Intake V6 2.8t
1 x Floormats BSR 9-5
2 x Fuel Pressure Regulator 4.0 bar
1 x Machined Control Arm Kit
2 x Shifter Mount Kit Cobalt/ HHR
1 x B207 Upper Radiator Coolant T
1 x BSR Optiflow Intake 4cyl
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x Floormats BSR 9-3SS/SC
3 x Shifter Mount Kit 93ss
2 x Adaptor Harness Handsfree 01-
1 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
1 x Downpipe 2.8T FWD (2wd)
2 x B207 Coolant Cap
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
3 x Midpipe 2.8T XWD (4wd)
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x Con Rods V6 2.8L 155.8mm
3 x Midpipe 2.8T FWD (2wd)
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x BSR Optiflow Intake 4cyl w SAI
1 x Replacement V6 Coolant Cap
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Metal Steering Wheel Buttons
1 x Front Camber Adjustment Bolts
1 x Genuine Saab 4cyl Oil Filters
1 x BSR 9-5 260Hp 2006-
1 x 9000 Shifter Bushing Repair Kit
1 x Viggen Clutch Kit 99-02
1 x Shifter Top Ghost Logo
3 x Turbo to Downpipe Flange B207
1 x v6 2.8t SAI Delete Kit
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Oil Cap 9-3SS "Ghost"
2 x Rear Rotors PAIR 292mm XWD (Code: BC)
2 x Remote Button NG900
2 x Ceramic Low Dust Brake Pads 9-3 SS
2 x Head Bolt Washers
2 x Injectors Siemens 60lb 630cc (set 4)
2 x Shift Rod Bushings
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Map/MAT sensor weld bung
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Moog Ball Joint
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
3 x Transmission Nut F35 F25
1 x Oil Cap 9-3SS V6 "Griffin"
1 x MTF0063 Manual Gear oil
1 x ARP Ring Gear Bolts F25/F35
1 x Fog light 9-3 Right 99-00
1 x Antenna Plug NG900/9-3 hatchback
1 x Weld Bungs -Taper- Race Only
1 x Turbo Conversion Pipe 900 9-3 T5
1 x Throttle Bend for T5 94-99
1 x Fuel Line Clip
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x Replacement Hardware Pack 6-Point
1 x v6oilcoolplate
2 x Oil Cap 9-3SS V6 "Ghost"
1 x v6 header flange
1 x Brake Vac pump seals
1 x Aero Clutch Kit 9-5
1 x Goodridge Brake Lines 9-3 SS / SC 03-
2 x Troll Head Plug
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
2 x Throttle Body T7
1 x Crush Sleeve F35 F25
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Rear Brake Pads 9-3 SS
1 x Coolant Bypass Valve 9-5
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x T7 Head Plug NGK
1 x Downpipe Hardware Kit
1 x Turbo Bypass Valve
1 x Custom Brake Lines RR 300mm Kit
$32,999.03
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail