$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Limit Strap Coilover Add On Kit
3 x SCNA Christmas Calendar
1 x Con Rods V6 2.8L 155.8mm
3 x 9000 Shifter Bushing Repair Kit
1 x T7 Head Plug NGK
1 x Troll Head Plug
1 x Replacement V6 Coolant Cap
1 x PPC 3 Volvo Diagnostic System
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
3 x Saab black Keychain
1 x Viggen Titanium KeyChain
1 x IAT Weld Bung T5/Bosch
1 x Injectors Siemens 80lb 875cc (set 4)
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Head Bolt Washers
1 x Intake Flange B2x4 T5
3 x PPC - Upgrade from stage 1 to stage 3
3 x 9-5 Aero Sill Protection
1 x Replacement Hardware Pack 6-Point
4 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Genuine Saab 4cyl Oil Filters
2 x Fog light 9-3 left 99-00
2 x 20th Viggen logo Shifter Top
1 x Steering Coupler 9-3 99-02
1 x Floormats BSR 9-3 99-02 900 94-98
1 x Throttle Bend for T5 94-99
2 x 9-5 Blend Flap Limit Lever 99-04
1 x Rear Engine Mount 4cyl
2 x 9-3 /NG900 Grille
2 x Mass Airflow Meter T7
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x ARP Ring Gear Bolts F25/F35
2 x Crush Sleeve F35 F25
1 x Bulb Switch Light
2 x Crank Vent Kit #6 T7 4cyl
1 x Rear spring perches Adjustable NG900/9-3
1 x Floormats BSR 9-5
2 x Downpipe Hardware Kit
3 x Fuel Line Clip
4 x Shift Rod Bushings
1 x Slave Cyl
1 x 9-3 Rear Ashtray
1 x Headbolts (New Style)
1 x Aero Clutch Kit 9-5
1 x Direct Ignition T7 Black
1 x 9-5 Open Air Prefilter
1 x Shifter Top Ghost Logo
2 x Oil Filter Re-locator
1 x Cabin Vent Fan
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Cigarette Lighter
1 x Remote Button NG900
1 x Adaptor Harness Handsfree 01-
1 x 9-5 Textile Mats 98-07
1 x Drop in Sport Filter 9-5
1 x ARP Exhaust Manifold Stud kit Stainless
2 x T7 3.5 Bar Fuel Pressure Regulator
2 x Exhaust manifold Stud Kit
2 x Clear Little Fender Blinkers Factory Saab
1 x 9-5 Rear Brake rotor See Description
1 x BSR 9-5 2010-2011 V6 300Hp
1 x Transmission Nut F35 F25
1 x c900 Performance Brake lines
2 x Front Camber Adjustment Bolts
1 x Map/MAT sensor weld bung
1 x Injectors Siemens 60lb 630cc (set 4)
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
2 x BSR 9-5 260Hp 2006-
1 x BSR 9-5 3.0T V6 200Hp
1 x MTF0063 Manual Gear oil
1 x 9-5 Intercooler ETS
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x Machined Control Arm Kit
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
1 x Valve Cover Gasket Set 4cyl
1 x Rear Camber Shims Kit 6pcs
2 x Front Camber Adjustment Bolts
1 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x Shifter Mount Kit 93ss
1 x Universal / Special Request
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Short Shifter HHR Cobalt F35 F40
1 x Filter 9-5 Cabin Air
1 x Air Filter 06 version (All 9-5)
1 x Shifter Mount Kit Cobalt/ HHR
1 x Throttle Body T7
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Oil Cooler Adaptor B2X5
1 x Open Air Intake 9000 93-98
1 x Direct Ignition T5 RED
1 x Oil Cap 9-3SS "Ghost"
1 x 4 Cyl 2.0 Coolant Tank
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Rear Rotors PAIR 292mm XWD (Code: BC)
$17,355.38
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail