$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
17 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x B207 Coolant Cap
1 x Con Rods V6 2.8L 155.8mm
1 x Limit Strap Coilover Add On Kit
3 x SCNA Christmas Calendar
2 x 3 Point Hardware
1 x 9000 Shifter Bushing Repair Kit
4 x PPC - Upgrade from stage 1 to stage 3
4 x Universal / Special Request
3 x Fuel Pressure Regulator 4.0 bar
3 x Injectors Green Giant 42lb (set 4)
2 x IAT Weld Bung T5/Bosch
2 x T5 3.0 Bar Map Sensor Adaptor
3 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
2 x PPC 3 Volvo Diagnostic System
1 x Floormats BSR 9-3SS/SC
2 x Coreganizer
2 x Adaptor Harness Handsfree 01-
1 x Saab black Keychain
2 x Metal Steering Wheel Buttons
1 x Viggen Titanium KeyChain
2 x Sparkplugs 9-3SS
1 x B207 Upper Radiator Coolant T
1 x Optical Cable Connector (Onstar Delete)
2 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x V6 Tank Float - SparePart
1 x Brake Vac pump seals
3 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
3 x 9-5 Blend Flap Limit Lever 99-04
1 x 9-3 / 900 Uprated Front ARB Bushings
3 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x 20th Viggen logo Shifter Top
2 x Fog light 9-5 Aero 04-05, 06-08 All Right
3 x Exhaust manifold Stud Kit
2 x T7 Injector Spacer Kit
3 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x 9-5 Shift Knobs Leather
1 x 9-5 Intercooler ETS
1 x Brembo Kit 315mm Hawk HPS Pads
1 x Drop in Sport Filter 9-5
3 x Ceramic Low Dust Brake Pads 9-3 SS
2 x Fog light 9-5 Aero 04-05, 06-08 All Left
2 x Brembo Brake Kit 315mm 9-3 SS
4 x Clear Little Fender Blinkers Factory Saab
2 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x T7 3.5 Bar Fuel Pressure Regulator
2 x ARP Exhaust Manifold Stud kit Stainless
3 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
2 x Head Stud Kit all 4cyl
1 x Cigarette Lighter
1 x 9-5 Textile Mats 98-07
1 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
1 x Fog light Replacement Panels 99-01
2 x Custom Brake Lines Brembo 315mm 9-3SS/SC
2 x Front Rotors PAIR 285mm Plain (Code: AA)
2 x Coolant Bypass Valve 9-5
1 x ShortShift Kit 93ss
2 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Headlight Bulb H7 Longer Life
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Air Filter 06 version (All 9-5)
1 x Rear Rotors PAIR 292mm XWD (Code: BC)
2 x Rear Rotors PAIR 292mm Plain (Code: BB)
2 x Weld Bungs -Taper- Race Only
1 x Mass Airflow Meter T7
3 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x Oil Pressure Switch
2 x Shift Rod Bushings
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x Headbolts (New Style)
3 x Crush Sleeve F35 F25
2 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Aero Clutch Kit 9-5
3 x Shifter Mount Kit 93ss
3 x Downpipe Hardware Kit
3 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Front Camber Adjustment Bolts
1 x Cabin Vent Fan
1 x Filter 9-5 Cabin Air
1 x 9-3 SS Akebono Rear Pads
3 x Crank Vent Kit #6 T7 4cyl
2 x Genuine Saab 4cyl Oil Filters
1 x Head Bolt Washers
1 x 9-5 Open Air Prefilter
1 x Direct Ignition T7 Black
2 x Intake Flange B2x4 T5
1 x Moog Ball Joint
2 x Fuel Line Clip
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
3 x 9-5 Exhaust Flex Pipe Stainless
1 x Injectors Siemens 60lb 630cc (set 4)
1 x Rear Brake Pads 9-3 SS
2 x Injectors Siemens 80lb 875cc (set 4)
2 x Map/MAT sensor weld bung
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x BBS Center Cap for 9-2x RK small caps
2 x Griffin logo Shifter Top
1 x Ignition Coil 9-3SS 2.8t and 2.8T
2 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x Oil Cap GM "HHR"
1 x Replacement V6 Coolant Cap
1 x Direct Ignition T5 RED
1 x Basic Subframe Brace
1 x Exhaust Clamp Kit
1 x Viggen Front Brake Disk Pair 308mm
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
2 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x Valve Cover Gasket Set 4cyl
1 x Steering Rod Bushings NG900/93
1 x 9000 Intercooler ETS
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Transmission Nut F35 F25
1 x Downpipe 2.8T XWD (4wd)
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x AEM Wideband Gauge Kit
1 x Shifter Mount Kit Cobalt/ HHR
1 x 9-5 286mm REAR Brembo Disk (1) See Descr.
1 x 4 Cyl 2.0 Coolant Tank
1 x Rear Engine Mount 4cyl
1 x Slave Cyl
1 x Shifter Top Ghost Logo
1 x Front Camber Adjustment Bolts
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x Turbo Conversion Pipe 900 9-3 T5
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Midpipe 2.8T FWD (2wd)
$33,988.40
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail