$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
4 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
6 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
5 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
5 x Midpipe 2.0T 07-11 FWD (2wd)
3 x Shifter Mount Kit Cobalt/ HHR
3 x Flywheel Twin Disk 7.25in B2xx
8 x Clear Little Fender Blinkers Factory Saab
2 x Injectors 175hp Stg3 (Set4)
2 x Cat Back Exh Dual Exit for 9-3 SS/SC 2.8t
5 x BSR Optiflow Intake 4cyl
3 x Shifter Mount Kit 93ss
3 x Shifter Alignment Pins (Set 2)
5 x Downpipe 2.8T FWD (2wd)
4 x Saab black Keychain
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
2 x 9-5 Wheel 5-Spoke Twin 17in
2 x Oil Cap 9-3SS V6 "Ghost"
2 x Mat Set Textile Jet Black 9-5 10-
3 x Injectors Siemens 60lb 630cc (set 4)
3 x Universal / Special Request
8 x Adaptor Harness Handsfree 01-
3 x Open Air Intake 9-3 00-02 and Viggen (All T7)
5 x Moog Ball Joint
5 x Header Flange Stainless Blended Transition B2x4,B2x5
4 x Weld Bungs -Taper- Race Only
5 x Rivetnuts Pair (2pcs)
5 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x PPC 3 Volvo Diagnostic System
5 x Head Bolt Washers
3 x AEM Wideband Gauge Kit
3 x T7 3.5 Bar Fuel Pressure Regulator
3 x 9-5 Shift Knobs Leather
3 x Oil Cooler Adaptor B2X5
4 x Map/MAT sensor weld bung
2 x Fuel Pressure Regulator 4.0 bar
2 x Floormats BSR 9-5
5 x PPC - Upgrade from stage 1 to stage 3
4 x Header Flange 1/2in Blended Transition B2x4,B2x5
3 x Injectors Green Giant 42lb (set 4)
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
3 x T5 3.0 Bar Map Sensor Adaptor
6 x Intake Flange B2x4 T5
7 x IAT Weld Bung T5/Bosch
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
4 x ARP Exhaust Manifold Stud kit Stainless
2 x Flex Pipe 900 94-98 9-3 99-02
2 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
3 x Cat back for Viggen 2.5in
2 x Exhaust Clamp Kit
4 x Exhaust manifold Stud Kit
3 x Midpipe 2.8T FWD (2wd)
3 x Machined Control Arm Kit
2 x Limit Strap Coilover Add On Kit
5 x Griffin logo Shifter Top
1 x Midpipe 2.8T XWD (4wd)
3 x Floormats BSR 9-3SS/SC
4 x Coreganizer
3 x Metal Steering Wheel Buttons
3 x Oil Filter Re-locator
1 x Head Stud Kit all 4cyl
2 x Rod Bearings only Pauter Rods
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x 4340 Connecting Rods B204 B235
2 x Balance Shaft Tensioner Delete
1 x Headbolts (New Style)
1 x T7 Head Plug NGK
1 x JE Piston Rings 90.0mm 235/205
2 x 20th Viggen logo Shifter Top
2 x MTF0063 Manual Gear oil
2 x 9-3/NG900 Shift Knobs Leather
1 x 9-5 Exhaust Flex Pipe Stainless
2 x 9-3 ng900 radio wires
1 x Brembo Brake Kit 315mm 9-3 SS
2 x Floormats BSR 9-3 99-02 900 94-98
2 x 9-3 Rear Ashtray
1 x 9-3 99-02,03 CV Antenna Adaptor
3 x Basic Subframe Brace
3 x B207 Coolant Cap
2 x Brembo Brake Kit 315mm 9-5 02-->
2 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
3 x Torque Mount Insert V6 Manual (XWD and FWD)
3 x Front Camber Adjustment Bolts
2 x Fog light Replacement Panels 99-01
1 x Hood Emblem 9-5 All
1 x Rear Engine Mount 4cyl
2 x Rear Camber Shims Kit 6pcs
1 x Front Camber Adjustment Bolts
3 x K&N Filter Service Kit
2 x ShortShift Kit 93ss
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Steering Rod Bushings NG900/93
2 x Steering Coupler 9-3 99-02
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Short Shifter HHR Cobalt F35 F40
1 x "Griffin" Valve stem caps
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Viggen Titanium KeyChain
1 x BBS Center Cap for 9-2x RK small caps
2 x Shifter Top Ghost Logo
3 x Shift Rod Bushings
2 x v6 2.8t SAI Delete Kit
2 x BSR Optiflow Intake V6 2.8t
1 x Rear spring perches Adjustable NG900/9-3
2 x BSR Optiflow Replacement Filter V6 2.8
3 x 9-3 / 900 Uprated Front ARB Bushings
2 x v6oilcoolplate
1 x Turbo to Downpipe Flange B207
3 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x BSR Optiflow Intake 4cyl w SAI
2 x Replacement Hardware Pack 6-Point
1 x 9-5 Intercooler ETS
1 x Air Filter 06 version (All 9-5)
2 x Oil Cap 9-3SS "Ghost"
3 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Slave Cyl
1 x BSR 9-5 260Hp 2006-
2 x c900 Performance Brake lines
3 x Upgrade Valve Springs T5 Cars
3 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
2 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x 9-5 High Performance Brake Line Kit
2 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x Viggen Front Brake Disk Pair 308mm
2 x Brembo Kit 315mm Hawk HPS Pads
1 x T7 Injector Spacer Kit
1 x Injectors Siemens 80lb 875cc (set 4)
1 x Mat Set Textile Shark Grey 9-5 10-
1 x Mat Set Textile Parchment 9-5 10-
2 x Viggen Fog Air Intake
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Throttle Bend for T5 94-99
1 x Mat Set Black Rubber 9-5 10-
1 x Bulb Switch Light
2 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Forge Bypass Valve Cobalt/HHR TC
1 x Cigarette Lighter
2 x Genuine Saab 4cyl Oil Filters
1 x Sparkplugs 9-3SS
1 x SCNA Christmas Calendar
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Hawk HPS FRONT Pads 9-3 TurboX (345mm)
1 x 9-5 Blend Flap Limit Lever 99-04
1 x 9-5 Wheel 10-Spoke 16in.
2 x Troll Head Plug
1 x Aluminum Flywheel For NG900/9-3
1 x Replacement V6 Coolant Cap
1 x Valve Cover Gasket Set 4cyl
1 x Downpipe 2.8T XWD (4wd)
1 x Drop in Sport Filter 9-5
$53,802.91
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail