$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Exhaust manifold Stud Kit
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
2 x Floormats BSR 9-3SS/SC
1 x Antenna Plug NG900/9-3 hatchback
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x 9-5 AERO 308mm Front Brake Rotor / Disk
3 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x BSR Optiflow Replacement Filter V6 2.8
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
2 x Head Stud Kit all 4cyl
1 x Floormats BSR 9-3 99-02 900 94-98
1 x 9-3 /NG900 Grille
1 x Cat back for Viggen 2.5in
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x ARP Exhaust Manifold Stud kit Stainless
2 x Adaptor Harness Handsfree 01-
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x ATF Saab 3309 (Automatic 02->)
2 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x 9-5 Rear Brake rotor See Description
1 x 9-5 Textile Mats 98-07
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x ARP Ring Gear Bolts F25/F35
1 x Aluminum Flywheel For NG900/9-3
1 x Air Filter 06 version (All 9-5)
1 x Optical Cable Connector (Onstar Delete)
2 x 9-3 ng900 radio wires
1 x Fog light Replacement Panels
1 x Shift Rod Bushings
1 x Oil Cap 9-3SS V6 "Griffin"
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x Rear Engine Mount 4cyl
1 x Flex Pipe 900 94-98 9-3 99-02
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Fog light Replacement Panels 99-01
1 x Replacement V6 Coolant Cap
1 x Midpipe 2.8T FWD (2wd)
1 x MTF0063 Manual Gear oil
1 x 20th Viggen logo Shifter Top
$10,312.49
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail