$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x Short Shifter HHR Cobalt F35 F40
4 x Forge Bypass Valve Cobalt/HHR TC
5 x Oil Cap GM "HHR"
2 x Shifter Mount Kit Cobalt/ HHR
2 x B207 Coolant Cap
1 x Con Rods V6 2.8L 155.8mm
3 x Replacement V6 Coolant Cap
1 x 9000 Shifter Bushing Repair Kit
3 x Limit Strap Coilover Add On Kit
1 x 3 Point Hardware
2 x Fuel Pressure Regulator 4.0 bar
3 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Map/MAT sensor weld bung
3 x PPC - Upgrade from stage 1 to stage 3
3 x Injectors Green Giant 42lb (set 4)
3 x T5 3.0 Bar Map Sensor Adaptor
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x AEM Wideband Gauge Kit
3 x Intake Flange B2x4 T5
2 x IAT Weld Bung T5/Bosch
1 x Injectors Siemens 60lb 630cc (set 4)
2 x Head Bolt Washers
3 x Universal / Special Request
1 x K&N Filter Service Kit
1 x Troll Head Plug
1 x T7 Head Plug NGK
2 x Crush Sleeve F35 F25
2 x 9-5 Blend Flap Limit Lever 99-04
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
2 x Exhaust manifold Stud Kit
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x Fog light 9-3 left 99-00
3 x Exhaust Clamp Kit
1 x Shift Rod Bushings
1 x Fog light Replacement Panels
2 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x Saab black Keychain
1 x 9-3 ng900 Hood Protection Strip
2 x ARP Exhaust Manifold Stud kit Stainless
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Cat back for Viggen 2.5in
1 x Fog light 9-3 Right 99-00
1 x 9000 Intercooler ETS
1 x 9000 High Performance Brake Line Kit '95-'98
1 x 9-3 / 900 Uprated Front ARB Bushings
2 x 20th Viggen logo Shifter Top
2 x Clear Little Fender Blinkers Factory Saab
1 x 9-3 /NG900 Grille
1 x Antenna Plug NG900/9-3 hatchback
1 x Viggen Fog Air Intake
1 x Replacement Filter for Open air 9-3 T7
1 x Direct Ignition T7 Black
2 x Oil Cooler Adaptor B2X5
1 x Remote Button NG900
1 x Slave Cyl
3 x SCNA Christmas Calendar
2 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Replacement Flywheel Insert NG900/9-3
1 x Aluminum Flywheel For NG900/9-3
1 x Crank Vent Kit #6 T7 4cyl
2 x Rear Engine Mount 4cyl
1 x T7 Injector Spacer Kit
1 x Fuel Line Clip
1 x Genuine Saab 4cyl Oil Filters
1 x Filter 9-5 Cabin Air
1 x 9-3 ng900 radio wires
1 x Oil Cap 9-3SS V6 "Ghost"
1 x B207 Upper Radiator Coolant T
1 x Griffin logo Shifter Top
2 x Hood Emblem 9-5 All
1 x Steering Coupler 9-3 99-02
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
2 x Oil Cap 9-3SS V6 "Griffin"
1 x Oil Cap 9-3SS "Ghost"
1 x Injectors Siemens 80lb 875cc (set 4)
2 x Weld Bungs -Taper- Race Only
2 x Rivetnuts Pair (2pcs)
3 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x 9-3/NG900 Shift Knobs Leather
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
2 x MTF0063 Manual Gear oil
2 x Shifter Top Ghost Logo
2 x 9-5 Aero Sill Protection
1 x ATF Saab 3309 (Automatic 02->)
1 x 9-5 Textile Mats 98-07
1 x Air Filter 06 version (All 9-5)
1 x 9-5 Shift Knobs Leather
1 x Midpipe 2.8T FWD (2wd)
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x Rear spring perches Adjustable NG900/9-3
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Throttle Body T7
1 x ShortShift Kit 93ss
1 x Steering Rod Bushings NG900/93
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Flex Pipe 900 94-98 9-3 99-02
1 x ARP Ring Gear Bolts F25/F35
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
1 x Custom Brake Lines RR 300mm Kit
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x Fog light Replacement Panels 99-01
1 x Basic Subframe Brace
1 x Moog Ball Joint
$17,144.24
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail