$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x PPC 3 Volvo Diagnostic System
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x ATF Saab 3309 (Automatic 02->)
1 x Shifter Alignment Pins (Set 2)
1 x K&N Filter Service Kit
1 x MTF0063 Manual Gear oil
1 x Viggen Titanium KeyChain
1 x T5 3.0 Bar Map Sensor Adaptor
2 x Fuel Pressure Regulator 4.0 bar
1 x Header Flange Stainless Blended Transition B2x4,B2x5
2 x SCNA Christmas Calendar
1 x Moog Ball Joint
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x Saab black Keychain
2 x IAT Weld Bung T5/Bosch
2 x Injectors Green Giant 42lb (set 4)
1 x Injectors Siemens 80lb 875cc (set 4)
1 x Map/MAT sensor weld bung
2 x Intake Flange B2x4 T5
2 x Head Bolt Washers
1 x Rivetnuts Pair (2pcs)
1 x Universal / Special Request
1 x Injectors Siemens 60lb 630cc (set 4)
3 x PPC - Upgrade from stage 1 to stage 3
1 x Troll Head Plug
1 x B207 Coolant Cap
2 x Replacement V6 Coolant Cap
2 x T7 Head Plug NGK
2 x Limit Strap Coilover Add On Kit
1 x Slave Cyl
1 x Flywheel Twin Disk 7.25in B2xx
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x T7 Injector Spacer Kit
2 x Fuel Line Clip
2 x Remote Button NG900
2 x Flex Pipe 900 94-98 9-3 99-02
3 x Exhaust Clamp Kit
2 x Turbo Conversion Pipe 900 9-3 T5
2 x Viggen Fog Air Intake
2 x Replacement Hardware Pack 6-Point
2 x Throttle Bend for T5 94-99
2 x Direct Ignition T7 Black
1 x Replacement Filter for Open air 9-3 T7
1 x Direct Ignition T5 RED
3 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Cat back for Viggen 2.5in
2 x 20th Viggen logo Shifter Top
2 x Steering Rod Bushings NG900/93
3 x Coreganizer
2 x Clear Little Fender Blinkers Factory Saab
1 x 9-3 ng900 radio wires
2 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x 9-3 Rear Ashtray
1 x Machined Control Arm Kit
2 x Floormats BSR 9-3 99-02 900 94-98
2 x 9-3 / 900 Uprated Front ARB Bushings
1 x Antenna Plug NG900/9-3 hatchback
1 x 9-3 ng900 Hood Protection Strip
1 x Fog light 9-3 left 99-00
1 x 9-5 Blend Flap Limit Lever 99-04
1 x 9-3 /NG900 Grille
2 x Rear spring perches Adjustable NG900/9-3
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x Basic Subframe Brace
1 x 9-3/NG900 Shift Knobs Leather
2 x Fog light 9-3 Right 99-00
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x Fog light Replacement Panels
2 x Griffin logo Shifter Top
1 x Rear Camber Shims Kit 6pcs
1 x Adaptor Harness Handsfree 01-
2 x Shift Rod Bushings
2 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Head Stud Kit all 4cyl
1 x Balance Shaft Tensioner Delete
1 x Rod Bearings only Pauter Rods
1 x Oil Filter Re-locator
1 x JE Piston Rings 90.0mm 235/205
1 x 9000 Intercooler ETS
1 x Open Air Intake 9000 93-98
2 x 9000 Shifter Bushing Repair Kit
1 x 9000 High Performance Brake Line Kit '95-'98
1 x Headlight Bulb H7 Longer Life
1 x BSR Optiflow Intake 4cyl
2 x B207 Upper Radiator Coolant T
2 x Filter 9-5 Cabin Air
1 x Hood Emblem 9-5 All
1 x Cabin Vent Fan
1 x Oil Pressure Switch
2 x Throttle Body T7
1 x 9-3 SS Akebono Rear Pads
1 x Exhaust manifold Stud Kit
1 x 9-5 Open Air Prefilter
1 x Downpipe 2.8T FWD (2wd)
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Drop in Sport Filter 9-5
1 x Fog light Replacement Panels 99-01
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Shifter Mount Kit Cobalt/ HHR
1 x Oil Cooler Adaptor B2X5
2 x Downpipe Hardware Kit
1 x Genuine Saab 4cyl Oil Filters
1 x Crank Vent Kit #6 T7 4cyl
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Turbo to Downpipe Flange B207
1 x Shifter Top Ghost Logo
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Brake Vac pump seals
$19,429.98
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail