$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Rod Bearings only Pauter Rods
2 x JE Piston Ring (1cyl) 90.5mm 235/205/204
4 x Balance Shaft Tensioner Delete
1 x 4340 Connecting Rods B204 B235
2 x JE Piston Rings 90.0mm 235/205
2 x Replacement Filter for Open air 9-3 T7
4 x Crush Sleeve F35 F25
4 x 20th Viggen logo Shifter Top
4 x 9-3 Rear Ashtray
3 x Flex Pipe 900 94-98 9-3 99-02
3 x Rear Engine Mount 4cyl
2 x Remote Button NG900
1 x Fog light 9-3 left 99-00
2 x 9-3 /NG900 Grille
2 x 9-3 ng900 Hood Protection Strip
1 x Fog light Replacement Panels
2 x Antenna Plug NG900/9-3 hatchback
1 x Saab black Keychain
1 x Viggen Titanium KeyChain
2 x ARP Exhaust Manifold Stud kit Stainless
2 x c900 Performance Brake lines
5 x T7 3.5 Bar Fuel Pressure Regulator
1 x 9000 Shifter Bushing Repair Kit
3 x Troll Head Plug
2 x Replacement V6 Coolant Cap
1 x Limit Strap Coilover Add On Kit
1 x Steering Rod Bushings NG900/93
2 x IAT Weld Bung T5/Bosch
1 x Shifter Top Ghost Logo
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x Transmission Nut F35 F25
1 x Short Shifter HHR Cobalt F35 F40
2 x Alu Hybrid Flywheel For NG900/9-3
1 x Shifter Alignment Pins (Set 2)
1 x Viggen Fog Air Intake
1 x K&N Filter Service Kit
2 x T7 Injector Spacer Kit
1 x Oil Filter Re-locator
4 x Shift Rod Bushings
1 x Basic Subframe Brace
3 x Griffin logo Shifter Top
4 x Crank Vent Kit #6 T7 4cyl
3 x 9-3/NG900 Shift Knobs Leather
1 x Coreganizer
2 x Turbo Bypass Valve
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x Floormats BSR 9-3 99-02 900 94-98
5 x Adaptor Harness Handsfree 01-
2 x BBS Center Cap for 9-2x RK small caps
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
4 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x 9-5 Blend Flap Limit Lever 99-04
1 x 9-5 Wheel 10-Spoke 16in.
1 x Fog light Replacement Panels 99-01
2 x 9-5 Exhaust Flex Pipe Stainless
2 x Genuine Saab 4cyl Oil Filters
2 x Sport Transmission Mount 9-5 (Manual) 1998-1999
2 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Headbolts (New Style)
2 x Coolant Bypass Valve 9-5
2 x Cigarette Lighter
2 x Floormats BSR 9-5
2 x 9-5 Open Air Prefilter
2 x Air Filter 06 version (All 9-5)
1 x Downpipe Hardware Kit
1 x Oil Cap GM "HHR"
2 x Replacement Hardware Pack 6-Point
5 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Fog light 9-5 Aero 04-05, 06-08 All Left
2 x Hood Emblem 9-5 All
3 x Mass Airflow Meter T7
1 x BSR 9-5 3.0T V6 200Hp
1 x Filter 9-5 Cabin Air
3 x Direct Ignition T7 Black
2 x Oil Pressure Switch
2 x 9-5 Shift Knobs Leather
2 x Aero Clutch Kit 9-5
2 x PPC - Upgrade from stage 1 to stage 3
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x Headlight Bulb H7 Longer Life
2 x Cabin Vent Fan
4 x Fuel Line Clip
1 x 9-5 Textile Mats 98-07
2 x Bulb Switch Light
1 x Slave Cyl
1 x BSR 9-5 260Hp 2006-
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
3 x Rear Camber Shims Kit 6pcs
1 x Head Stud Kit all 4cyl
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x 9-5 Intercooler ETS
2 x Drop in Sport Filter 9-5
1 x Front Camber Adjustment Bolts
2 x Exhaust manifold Stud Kit
1 x 9-5 Aero Sill Protection
1 x Exhaust Clamp Kit
1 x Machined Control Arm Kit
1 x MTF0063 Manual Gear oil
1 x Moog Ball Joint
1 x Downpipe 2.8T XWD (4wd)
1 x Brake Vac pump seals
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
2 x Clear Little Fender Blinkers Factory Saab
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
1 x 9-3 ng900 radio wires
1 x T5 3.0 Bar Map Sensor Adaptor
1 x B207 Coolant Cap
1 x B207 Upper Radiator Coolant T
1 x Valve Cover Gasket Set 4cyl
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Forge Bypass Valve Cobalt/HHR TC
1 x Replacement Flywheel Insert NG900/9-3
1 x Aluminum Flywheel For NG900/9-3
1 x Brembo Kit 315mm Hawk HPS Pads
$23,720.78
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail