$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x Intake Flange B2x4 T5
2 x Fuel Pressure Regulator 4.0 bar
5 x Injectors Green Giant 42lb (set 4)
3 x AEM Wideband Gauge Kit
4 x Header Flange 1/2in Blended Transition B2x4,B2x5
5 x Rivetnuts Pair (2pcs)
3 x IAT Weld Bung T5/Bosch
5 x MTF0063 Manual Gear oil
2 x Moog Ball Joint
4 x K&N Filter Service Kit
1 x SCNA Christmas Calendar
1 x Viggen Titanium KeyChain
4 x c900 Performance Brake lines
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
3 x Basic Subframe Brace
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x 4340 Connecting Rods B204 B235
1 x Steering Rod Bushings NG900/93
1 x Map/MAT sensor weld bung
1 x Shifter Top Ghost Logo
1 x Replacement Hardware Pack 6-Point
3 x Shift Rod Bushings
1 x Quaife Differential 9-5 and Viggen (F35)
1 x 9-3 Rear Ashtray
2 x Crush Sleeve F35 F25
2 x 20th Viggen logo Shifter Top
3 x Downpipe Hardware Kit
1 x Adaptor Harness Handsfree 01-
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
2 x Mat Set Textile Shark Grey 9-5 10-
1 x 9-3 ng900 radio wires
1 x Replacement Filter for Open air 9-3 T7
1 x Mass Airflow Meter T7
1 x Replacement Flywheel Insert NG900/9-3
1 x Fuel Line Clip
1 x Remote Button NG900
4 x 9-3 99-02,03 CV Antenna Adaptor
3 x Aluminum Flywheel For NG900/9-3
1 x Direct Ignition T7 Black
2 x Slave Cyl
2 x Transmission Nut F35 F25
2 x Sport Transmission Mount 9-3/900 (Automatic)
2 x Exhaust Clamp Kit
1 x Direct Ignition T5 RED
1 x ARP Ring Gear Bolts F25/F35
1 x Genuine Saab 4cyl Oil Filters
3 x Mat Set Textile Parchment 9-5 10-
2 x Floormats BSR 9-3 99-02 900 94-98
2 x Flex Pipe 900 94-98 9-3 99-02
2 x 9-3 /NG900 Grille
1 x 9-3 ng900 Hood Protection Strip
1 x BSR 9-5 2010-2011 V6 300Hp
2 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
5 x T7 3.5 Bar Fuel Pressure Regulator
2 x Oil Cooler Adaptor B2X5
2 x Throttle Bend for T5 94-99
3 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x T7 Injector Spacer Kit
2 x Turbo Conversion Pipe 900 9-3 T5
1 x Fog light 9-3 left 99-00
1 x Cat back for Viggen 2.5in
4 x ARP Exhaust Manifold Stud kit Stainless
1 x Antenna Plug NG900/9-3 hatchback
2 x Viggen Fog Air Intake
1 x Fog light Replacement Panels
1 x Exhaust manifold Stud Kit
1 x Fog light 9-3 Right 99-00
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x ATF Saab 3309 (Automatic 02->)
1 x Filter 9-5 Cabin Air
1 x 9-3 SS Akebono Rear Pads
2 x 9-5 Open Air Prefilter
1 x Replacement V6 Coolant Cap
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Open Air Intake 9000 93-98
3 x 9000 Intercooler ETS
1 x V6 Tank Float - SparePart
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
2 x 9000 High Performance Brake Line Kit '95-'98
1 x PPC - Upgrade from stage 1 to stage 3
1 x BSR Optiflow Intake 4cyl w SAI
2 x 9-5 Blend Flap Limit Lever 99-04
2 x 9-3 / 900 Uprated Suspension Bushings Inner
3 x Clear Little Fender Blinkers Factory Saab
1 x BSR 9-5 3.0T V6 200Hp
1 x BSR Optiflow Intake 4cyl
1 x Injectors Siemens 60lb 630cc (set 4)
2 x Alu Hybrid Flywheel For NG900/9-3
2 x Griffin logo Shifter Top
1 x Viggen Clutch Kit 99-02
3 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Rear Engine Mount 4cyl
1 x 9-3/NG900 Shift Knobs Leather
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Custom Brake Lines RR 300mm Kit
1 x v6 header flange
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
2 x 9-5 Intercooler ETS
1 x BBS Center Cap for 9-2x RK small caps
1 x Rear Camber Shims Kit 6pcs
1 x v6 2.8t SAI Delete Kit
1 x Saab black Keychain
1 x Turbo to Downpipe Flange B207
1 x Drop in Sport Filter 9-5
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Shifter Alignment Pins (Set 2)
$28,450.97
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail