$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
4 x PPC - Upgrade from stage 1 to stage 3
3 x Injectors Siemens 80lb 875cc (set 4)
4 x Rivetnuts Pair (2pcs)
3 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x PPC 3 Volvo Diagnostic System
1 x Replacement V6 Coolant Cap
2 x T7 Head Plug NGK
2 x Downpipe Hardware Kit
1 x Aluminum Flywheel For NG900/9-3
1 x Filter 9-5 Cabin Air
1 x Cabin Vent Fan
1 x Sport Transmission Mount 9-3/900 (Automatic)
2 x Fuel Line Clip
1 x Slave Cyl
2 x Crush Sleeve F35 F25
3 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x 9-5 Exhaust Flex Pipe Stainless
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x Throttle Bend for T5 94-99
1 x Steering Rod Bushings NG900/93
1 x Machined Control Arm Kit
1 x Floormats BSR 9-3 99-02 900 94-98
1 x 9-3 Rear Ashtray
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Coreganizer
1 x Oil Filter Re-locator
1 x 9-3 ng900 radio wires
2 x Rear Camber Shims Kit 6pcs
3 x Moog Ball Joint
2 x Headbolts (New Style)
2 x 9-3 ng900 Hood Protection Strip
1 x Rear spring perches Adjustable NG900/9-3
2 x 9-3 /NG900 Grille
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Adaptor Harness Handsfree 01-
2 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Basic Subframe Brace
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Fog light 9-3 left 99-00
1 x Viggen Fog Air Intake
1 x Limit Strap Coilover Add On Kit
3 x Weld Bungs -Taper- Race Only
1 x Rod Bearings only Pauter Rods
1 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x 9-3 99-02,03 CV Antenna Adaptor
2 x Clear Little Fender Blinkers Factory Saab
1 x Head Stud Kit all 4cyl
2 x Antenna Plug NG900/9-3 hatchback
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x Replacement Hardware Pack 6-Point
1 x Genuine Saab 4cyl Oil Filters
1 x 9-5 Shift Knobs Leather
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
2 x Flex Pipe 900 94-98 9-3 99-02
2 x Exhaust Clamp Kit
1 x 9-5 Rear Brake rotor See Description
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
2 x 9-5 Aero Sill Protection
1 x Rear Engine Mount 4cyl
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Front Camber Adjustment Bolts
1 x Mass Airflow Meter T7
2 x Direct Ignition T7 Black
1 x Direct Ignition T5 RED
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
2 x Aero Clutch Kit 9-5
1 x 9-3/NG900 Shift Knobs Leather
1 x 9-5 Wheel 10-Spoke 16in.
1 x Fog light Replacement Panels 99-01
1 x Replacement Filter for Open air 9-3 T7
3 x Crank Vent Kit #6 T7 4cyl
1 x Air Filter 06 version (All 9-5)
1 x 9-5 Textile Mats 98-07
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
2 x ARP Exhaust Manifold Stud kit Stainless
1 x Cat back for Viggen 2.5in
2 x Hood Emblem 9-5 All
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Exhaust manifold Stud Kit
1 x Remote Button NG900
2 x ATF Saab 3309 (Automatic 02->)
1 x Head Bolt Washers
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x Intake Flange B2x4 T5
1 x BSR 9-5 2010-2011 V6 300Hp
1 x Fuel Pressure Regulator 4.0 bar
1 x Universal / Special Request
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x AEM Wideband Gauge Kit
2 x Shift Rod Bushings
1 x IAT Weld Bung T5/Bosch
1 x Saab black Keychain
1 x SCNA Christmas Calendar
1 x Injectors Siemens 60lb 630cc (set 4)
2 x Mat Set Black Rubber 9-5 10-
1 x Mat Set Textile Shark Grey 9-5 10-
1 x Mat Set Textile Parchment 9-5 10-
1 x Mat Set Textile Jet Black 9-5 10-
1 x 9000 Intercooler ETS
1 x Flywheel Twin Disk 7.25in B2xx
1 x Transmission Nut F35 F25
1 x Oil Cap GM "HHR"
1 x Short Shifter HHR Cobalt F35 F40
1 x BSR Optiflow Intake 4cyl w SAI
1 x BSR Optiflow Replacement Filter V6 2.8
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Midpipe 2.8T FWD (2wd)
1 x BSR Optiflow Intake V6 2.8t
1 x 4 Cyl 2.0 Coolant Tank
1 x BBS Center Cap for 9-2x RK small caps
1 x K&N Filter Service Kit
1 x Upgrade Valve Springs T5 Cars
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Valve Cover Gasket Set 4cyl
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Turbo Conversion Pipe 900 9-3 T5
1 x MTF0063 Manual Gear oil
1 x Sparkplugs 9-3SS
1 x Griffin logo Shifter Top
1 x Fog light 9-3 Right 99-00
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Bulb Switch Light
1 x Viggen Clutch Kit 99-02
1 x Viggen Front Brake Disk Pair 308mm
1 x Throttle Body T7
$27,828.82
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail