$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
7 x Clear Little Fender Blinkers Factory Saab
3 x Antenna Plug NG900/9-3 hatchback
6 x 9-3 ng900 Hood Protection Strip
2 x Con Rods V6 2.8L 155.8mm
2 x Replacement V6 Coolant Cap
5 x Cat back for Viggen 2.5in
5 x Exhaust manifold Stud Kit
3 x Exhaust Clamp Kit
4 x MTF0063 Manual Gear oil
2 x ATF Saab 3309 (Automatic 02->)
1 x K&N Filter Service Kit
2 x Fog light 9-3 Right 99-00
2 x Fog light Replacement Panels
1 x Rod Bearings only Pauter Rods
2 x 4340 Connecting Rods B204 B235
1 x Headbolts (New Style)
1 x T7 Head Plug NGK
3 x Head Stud Kit all 4cyl
1 x Balance Shaft Tensioner Delete
1 x JE Piston Rings 90.0mm 235/205
2 x PPC - Upgrade from stage 1 to stage 3
2 x 9-3/NG900 Shift Knobs Leather
2 x Transmission Nut F35 F25
1 x ARP Ring Gear Bolts F25/F35
1 x Bulb Switch Light
2 x 9-5 Intercooler ETS
1 x 9-5 Exhaust Flex Pipe Stainless
4 x 9-5 Aero Sill Protection
5 x Brake Vac pump seals
2 x Aero Clutch Kit 9-5
4 x v6 header flange
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-5 Textile Mats 98-07
1 x Hood Emblem 9-5 All
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
3 x 9-5 Wheel 10-Spoke 16in.
2 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Fog light Replacement Panels 99-01
1 x 9-5 Shift Knobs Leather
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x 9-5 Rear Brake rotor See Description
1 x Front Camber Adjustment Bolts
1 x Air Filter 06 version (All 9-5)
3 x Rear Camber Shims Kit 6pcs
1 x 9-3 /NG900 Grille
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
3 x Throttle Body T7
2 x Mass Airflow Meter T7
3 x Replacement Filter for Open air 9-3 T7
3 x Flex Pipe 900 94-98 9-3 99-02
3 x Turbo Bypass Valve
3 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
2 x Replacement Hardware Pack 6-Point
3 x Crank Vent Kit #6 T7 4cyl
4 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Torque Mount Insert V6 Manual (XWD and FWD)
2 x Downpipe 2.8T XWD (4wd)
1 x ShortShift Kit 93ss
1 x Custom Brake Lines RR 300mm Kit
1 x Limit Strap Coilover Add On Kit
3 x Oil Cap 9-3SS V6 "Ghost"
1 x Oil Cooler Adaptor B2X5
2 x Viggen Fog Air Intake
1 x T7 Injector Spacer Kit
1 x Turbo Conversion Pipe 900 9-3 T5
1 x Adaptor Harness Handsfree 01-
1 x Optical Cable Connector (Onstar Delete)
3 x Rear Pedestal Spoiler 9-3 SS
1 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x 9-3 / 900 Uprated Front ARB Bushings
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x 3 Point Hardware
2 x 20th Viggen logo Shifter Top
3 x Coreganizer
1 x Sparkplugs 9-3SS
2 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Metal Steering Wheel Buttons
2 x Headlight Connector Repair Kit 9-3SS 9-5
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x 4 Cyl 2.0 Coolant Tank
1 x Floormats BSR 9-3SS/SC
2 x Hood Emblem 9-3 SS/sc 03- All
2 x V6 Tank Float - SparePart
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
2 x B207 Upper Radiator Coolant T
2 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
2 x InjectorDynamics 725cc For 2.8V6 (Set6)
2 x B207 Coolant Cap
1 x Injectors 175hp Stg3 (Set4)
1 x Shifter Mount Kit 93ss
1 x Front Camber Adjustment Bolts
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x Coolant Bypass Valve 9-5
2 x Shift Rod Bushings
2 x SCNA Christmas Calendar
1 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x T7 3.5 Bar Fuel Pressure Regulator
2 x JE Piston Ring (1cyl) 90.5mm 235/205/204
2 x Griffin logo Shifter Top
1 x 9-5 Open Air Prefilter
1 x AEM Wideband Gauge Kit
1 x Upgrade Valve Springs T5 Cars
1 x Filter 9-5 Cabin Air
1 x 9-5 High Performance Brake Line Kit
2 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x BSR Optiflow Intake 4cyl
1 x Headlight Bulb H7 Longer Life
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Mat Set Textile Parchment 9-5 10-
1 x Mat Set Black Rubber 9-5 10-
1 x Valve Cover Gasket Set 4cyl
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Storage Tray / Ashtray Kit 9-5 10-
1 x Viggen Clutch Kit 99-02
1 x Downpipe Hardware Kit
1 x Rear Rotors PAIR 292mm XWD (Code: BC)
2 x Crush Sleeve F35 F25
1 x Rear Engine Mount 4cyl
1 x Saab black Keychain
1 x Remote Button NG900
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x Rivetnuts Pair (2pcs)
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x Cabin Vent Fan
3 x Shifter Alignment Pins (Set 2)
1 x Midpipe 2.8T FWD (2wd)
1 x Head Bolt Washers
1 x Brembo Brake Kit 315mm 9-5 02-->
1 x IAT Weld Bung T5/Bosch
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Troll Head Plug
1 x PPC 3 Volvo Diagnostic System
1 x Open Air Intake 9000 93-98
1 x Viggen Front Brake Disk Pair 308mm
1 x Replacement Flywheel Insert NG900/9-3
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x Rear Brake Pads 9-3 SS
1 x v6 2.8t SAI Delete Kit
1 x Short Shifter HHR Cobalt F35 F40
1 x Turbo to Downpipe Flange B207
1 x BSR Optiflow Replacement Filter V6 2.8
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Slave Cyl
1 x Fuel Pressure Regulator 4.0 bar
$42,436.30
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail