$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x PPC - Upgrade from stage 1 to stage 3
3 x Short Shifter HHR Cobalt F35 F40
3 x Shifter Mount Kit Cobalt/ HHR
2 x Forge Bypass Valve Cobalt/HHR TC
3 x Oil Cap GM "HHR"
4 x Saab black Keychain
4 x SCNA Christmas Calendar
2 x Quaife Differential 9-5 and Viggen (F35)
2 x Aluminum Flywheel For NG900/9-3
3 x Fog light Replacement Panels
3 x Fog light 9-3 Right 99-00
2 x Transmission Nut F35 F25
1 x Flywheel Twin Disk 7.25in B2xx
1 x JE Piston Rings 90.0mm 235/205
2 x Upgrade Valve Springs T5 Cars
1 x 4340 Connecting Rods B204 B235
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
2 x PPC 3 Volvo Diagnostic System
3 x Head Stud Kit all 4cyl
2 x ATF Saab 3309 (Automatic 02->)
5 x Shifter Alignment Pins (Set 2)
4 x MTF0063 Manual Gear oil
1 x Fuel Line Clip
2 x Mass Airflow Meter T7
2 x Exhaust Clamp Kit
2 x Remote Button NG900
2 x Replacement Hardware Pack 6-Point
1 x Replacement Filter for Open air 9-3 T7
1 x Downpipe Hardware Kit
1 x Genuine Saab 4cyl Oil Filters
1 x Crush Sleeve F35 F25
2 x Flex Pipe 900 94-98 9-3 99-02
1 x Direct Ignition T5 RED
1 x Injectors Siemens 80lb 875cc (set 4)
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
3 x IAT Weld Bung T5/Bosch
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
4 x Exhaust manifold Stud Kit
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Cat back for Viggen 2.5in
2 x ARP Exhaust Manifold Stud kit Stainless
2 x Throttle Bend for T5 94-99
2 x Oil Cooler Adaptor B2X5
2 x Viggen Fog Air Intake
2 x Turbo Conversion Pipe 900 9-3 T5
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x 9-5 Wheel 5-Spoke Twin 17in
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
3 x 9-3 /NG900 Grille
1 x c900 Performance Brake lines
2 x B207 Coolant Cap
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
2 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Injectors 175hp Stg3 (Set4)
4 x Shift Rod Bushings
2 x V6 Tank Float - SparePart
2 x Torque Mount Insert V6 Manual (XWD and FWD)
2 x Midpipe 2.8T XWD (4wd)
2 x ShortShift Kit 93ss
2 x ARP Ring Gear Bolts F25/F35
1 x Replacement V6 Coolant Cap
2 x Front Camber Adjustment Bolts
3 x Brake Vac pump seals
1 x Hood Emblem 9-3 SS/sc 03- All
2 x BSR Optiflow Intake 4cyl
1 x Slave Cyl
1 x Floormats BSR 9-3SS/SC
1 x 3 Point Hardware
2 x Alu Hybrid Flywheel For NG900/9-3
1 x Metal Steering Wheel Buttons
2 x Viggen Clutch Kit 99-02
2 x Midpipe 2.8T FWD (2wd)
2 x Coreganizer
1 x BSR Optiflow Intake V6 2.8t
1 x T7 Head Plug NGK
3 x Balance Shaft Tensioner Delete
1 x Downpipe 2.8T FWD (2wd)
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x Oil Cap 9-3SS V6 "Griffin"
1 x Throttle Body T7
2 x Machined Control Arm Kit
1 x Steering Rod Bushings NG900/93
1 x Turbo to Downpipe Flange B207
2 x Griffin logo Shifter Top
1 x Downpipe 2.8T XWD (4wd)
1 x v6 header flange
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x v6 2.8t SAI Delete Kit
1 x B207 Upper Radiator Coolant T
2 x Shifter Top Ghost Logo
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Intake Flange B2x4 T5
2 x 9000 Shifter Bushing Repair Kit
3 x Rear Camber Shims Kit 6pcs
1 x 9-3 ng900 radio wires
1 x 9-3/NG900 Shift Knobs Leather
2 x 20th Viggen logo Shifter Top
1 x 9-5 Wheel 10-Spoke 16in.
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x v6oilcoolplate
1 x Limit Strap Coilover Add On Kit
1 x Steering Coupler 9-3 99-02
2 x Map/MAT sensor weld bung
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Shifter Mount Kit 93ss
1 x Oil Cap 9-3SS "Ghost"
2 x Header Flange Stainless Blended Transition B2x4,B2x5
2 x Head Bolt Washers
1 x Oil Filter Re-locator
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Rear spring perches Adjustable NG900/9-3
1 x Brembo Brake Kit 315mm 9-3 SS
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Weld Bungs -Taper- Race Only
1 x 9-5 Blend Flap Limit Lever 99-04
1 x Troll Head Plug
1 x Open Air Intake 9000 93-98
1 x 9-5 Exhaust Flex Pipe Stainless
2 x Clear Little Fender Blinkers Factory Saab
$31,987.71
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail