$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x 9-5 Textile Mats 98-07
1 x Viggen Titanium KeyChain
1 x 9-5 Wheel 5-Spoke Twin 17in
2 x Air Filter 06 version (All 9-5)
2 x 9-5 Shift Knobs Leather
2 x Aero Clutch Kit 9-5
4 x Rear Camber Shims Kit 6pcs
2 x Universal / Special Request
1 x T5 3.0 Bar Map Sensor Adaptor
2 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x Fuel Pressure Regulator 4.0 bar
3 x Intake Flange B2x4 T5
5 x PPC - Upgrade from stage 1 to stage 3
2 x IAT Weld Bung T5/Bosch
4 x Injectors Green Giant 42lb (set 4)
2 x Head Bolt Washers
4 x Moog Ball Joint
3 x Header Flange Stainless Blended Transition B2x4,B2x5
3 x Injectors Siemens 80lb 875cc (set 4)
2 x Map/MAT sensor weld bung
5 x Clear Little Fender Blinkers Factory Saab
2 x c900 Performance Brake lines
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x 9000 Shifter Bushing Repair Kit
1 x Troll Head Plug
1 x B207 Coolant Cap
1 x BSR 9-5 260Hp 2006-
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x T7 Head Plug NGK
1 x Con Rods V6 2.8L 155.8mm
1 x BSR 9-5 3.0T V6 200Hp
2 x Limit Strap Coilover Add On Kit
1 x Replacement V6 Coolant Cap
1 x Forge Bypass Valve Cobalt/HHR TC
1 x Oil Cap GM "HHR"
3 x Bulb Switch Light
1 x Shifter Mount Kit Cobalt/ HHR
2 x BSR 9-5 2010-2011 V6 300Hp
2 x Storage Tray / Ashtray Kit 9-5 10-
3 x Mat Set Textile Shark Grey 9-5 10-
3 x Oil Cap 9-3SS V6 "Ghost"
2 x Mat Set Black Rubber 9-5 10-
2 x Oil Cap 9-3SS V6 "Griffin"
4 x Mat Set Textile Parchment 9-5 10-
3 x Mat Set Textile Jet Black 9-5 10-
2 x Direct Ignition T7 Black
1 x Direct Ignition T5 RED
3 x Oil Pressure Switch
3 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x Coolant Bypass Valve 9-5
4 x Fog light 9-5 Aero 04-05, 06-08 All Left
2 x Coreganizer
1 x Rear Brake Pads 9-3 SS
2 x Hood Emblem 9-5 All
2 x Rear Brake Pads 9-5 Later Style
1 x Cabin Vent Fan
2 x Metal Steering Wheel Buttons
1 x Ceramic Low Dust Brake Pads 9-3 SS
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
2 x Fog light 9-5 Aero 04-05, 06-08 All Right
2 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Front Rotors PAIR 285mm Plain (Code: AA)
2 x Cigarette Lighter
2 x Fog light 9-3 Right 99-00
1 x Injectors 175hp Stg3 (Set4)
3 x Exhaust Clamp Kit
1 x Headbolts (New Style)
2 x Crank Vent Kit #6 T7 4cyl
4 x Genuine Saab 4cyl Oil Filters
2 x Rear Rotors PAIR 292mm XWD (Code: BC)
3 x Fuel Line Clip
1 x Sparkplugs 9-3SS
2 x Rear Rotors PAIR 292mm Plain (Code: BB)
1 x Optical Cable Connector (Onstar Delete)
4 x Throttle Body T7
2 x Turbo Bypass Valve
2 x Valve Cover Gasket Set 4cyl
2 x SCNA Christmas Calendar
3 x Crush Sleeve F35 F25
2 x Rear Engine Mount 4cyl
1 x Front Rotors PAIR 302mm Plain (Code: AB)
1 x Mass Airflow Meter T7
1 x Hood Emblem 9-3 SS/sc 03- All
3 x Headlight Bulb H7 Longer Life
2 x Rear Pedestal Spoiler 9-3 SS
1 x Flex Pipe 900 94-98 9-3 99-02
2 x Ignition Coil 9-3SS 2.0t and 2.0T
3 x Shift Rod Bushings
2 x Viggen Front Brake Disk Pair 308mm
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Remote Button NG900
1 x Slave Cyl
1 x Brembo Brake Kit 315mm 9-5 02-->
1 x Viggen Clutch Kit 99-02
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x 9-3 ng900 radio wires
1 x 9-5 286mm REAR Brembo Disk (1) See Descr.
2 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Turbo Conversion Pipe 900 9-3 T5
1 x 9-3/NG900 Shift Knobs Leather
2 x Basic Subframe Brace
1 x Rod Bearings only Pauter Rods
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x 20th Viggen logo Shifter Top
1 x Downpipe Hardware Kit
2 x 9-3 /NG900 Grille
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x 9-3 900 9-5 REAR Brembo Disk See Descr.
2 x ATF Saab 3309 (Automatic 02->)
3 x Steering Coupler 9-3 99-02
1 x Steering Rod Bushings NG900/93
1 x Drop in Sport Filter 9-5
2 x Machined Control Arm Kit
2 x Exhaust manifold Stud Kit
1 x Fog light Replacement Panels 99-01
1 x Filter 9-5 Cabin Air
2 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
2 x 9-5 Open Air Prefilter
2 x 9-3 / 900 Uprated Front ARB Bushings
3 x K&N Filter Service Kit
1 x Shifter Alignment Pins (Set 2)
1 x 9-3 / 900 Uprated Suspension Bushings Inner
3 x Rear spring perches Adjustable NG900/9-3
3 x 9-5 AERO 308mm Front Brake Rotor / Disk
2 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
2 x AEM Wideband Gauge Kit
1 x 9-5 Wheel 10-Spoke 16in.
1 x 9-5 Aero Sill Protection
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
1 x 9-5 High Performance Brake Line Kit
1 x Cat back for Viggen 2.5in
2 x Oil Filter Re-locator
1 x Midpipe 2.8T FWD (2wd)
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Replacement Hardware Pack 6-Point
1 x 9-5 Exhaust Flex Pipe Stainless
1 x Replacement Filter for Open air 9-3 T7
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Injectors Siemens 60lb 630cc (set 4)
1 x Rivetnuts Pair (2pcs)
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
$37,679.86
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail